振動力矩 的英文怎麼說

中文拼音 [zhèndòng]
振動力矩 英文
oscillatory torque
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • : 名詞1. (畫直角或正方形、矩形用的曲尺) carpenter's square; square2. (法度; 規則) rules; regulations 3. [物理學] moment
  • 振動 : vibrate; vibration; vibrance; vibrancy; vibra; vibes; shaking; rumble; jitter; chatter; sway; jar...
  1. The convert and evolution course of periodical response, quasi - periodical response, double - periodical bifurcation, chaos of the system response is analyzed. ( 3 ). it is deduced that the general differential equation of bending - torsional - pendular coupling vibration about rotor with the gyroscopic moment

    ( 3 )推導了一般意義下,考慮陀螺的單盤轉子彎扭擺耦合非線性方程,基於該方程,推出了不平衡轉子和碰摩轉子的非線性彎扭擺耦合方程。
  2. Based on the special property of magnetic fluid ( mf ), we fill the magnetic fluid into the working clearances of the servo valve torque motor. one side, the magnetized magnetic fluid can exert a damping torque on the torque motor armature and reduce vibration of the armature ; on the other side, it can improve the magnetic circuit efficiency of the torque motor because of the magnetic fluid ’ s larger magnetic permeability

    基於磁流體所具有的特殊性質,將磁流體添加到伺服閥馬達的工作間隙中,一方面磁流體被磁化后可增大銜鐵的阻尼,減少;另一方面由於馬達氣隙中磁導率的提高,使氣隙中的磁通量增大,馬達的磁路效率和輸出扭將增大,因此可以提高馬達的固有頻率和伺服閥的響應速度。
  3. Compared with non - slung - load flight, additional aerodynamic load, gravity load should be considered in the slung - load system. so the moment to the gravity center, flight mode and the natural frequency will change

    直升機吊掛飛行,與直升機非吊掛飛行狀態相比,增加了新的氣載荷、重載荷,和因此產生的對直升機重心的,其飛行運模式、低頻蕩固有頻率均發生改變。
  4. This paper presents the displacement solution to mine elevator viscoelastic vibrating equations and the kinetic tension calculation method, discusses kinetic tension characteristics under rectangular, ladder shaped, sinusoidal and parabolic acceleration curves, provides ways to limit or even avoid lifting rope viscoelastic vibration

    摘要給出了礦井提升機粘彈性方程的位移解及的計算方法,研究了採用形、梯形、正弦形、拋物線形加速度時銅線繩的特性,給出了限制和消除提升鋼絲繩粘彈性的方法。
  5. The submarine noise detected by sonar consists of two parts : propeller - generated hydro - dynamical noise, which can be greatly reduced by improving the submarine rear shape ; radiated noise from the submarine structure excited by the centrifugal forces ( moments ) of rotatory machine, which is more complicated and influenced by many factors

    聲納所探測的潛艇噪聲包括兩部分,一是螺旋槳運轉帶來的水噪聲,二是潛艇主機工作時產生的不平衡引起潛艇結構,帶流場從而輻射噪聲。通過改進潛艇尾部線型設計,已將水噪聲降到比較低的程度,而結構噪聲則復雜得多,與許多因素有關。
  6. The influence of the eccentricity mass moment, position of mass center and the bearing stiffness to the vibration characteristics of the rotor system is discussed in detail ; 3. to verify the exactness of fem and learn the principle of vibration of dredge pump further, the orbit of the rotor shaft of the pump in the dredger is measured, the measurement results show : the repeat of the orbit of the rotor shaft is very bad when dredge pump is in the dredging mud condition

    模態分析確定了泥泵的特性(固有頻率和型) ;諧響應分析確定了泥泵轉子軸在偏心的作用下軸截面處的最大響應位移;研究了轉子軸的質心位置、軸承剛度和質量偏心對轉子軸特性的影響; 3 、採用軸心軌跡法,實船測量了泥泵軸工作時響應值。
  7. Coordinate transformation, matrix, vectors, newton ' s law, conservation theorems, simple harmonic oscillator, non - linear oscillations, gravitation, euler ' s equation when auxiliany condition are imposed, the delta notation, lagrangian and hamilitonian dynamics, central - force motion, dynamics of a system o f particles, motion of noninertial reference frame, dynamics of rigid body, coupled oscillations, orthogonality of the eigenvectors, continuous system

    座標變換、陣、向量、牛頓定律、守恆定律、簡諧、非線性、引、尤拉式方程式及附加條件、符號、拉格蘭及漢米爾頓學、中心運、多粒子系統學、非慣性參考座標運、剛體學、耦會、本微向量正交性、連續系統。
  8. The main work includes : based on biot ' s dynamic consolidation equations, by the method of integral transform and matrix transfer, two - dimensional consolidation of layered saturated soils is studied. then, the general integral solutions of stress ( including pore pressure ) and displacement ( including fluid flow ) of any point were obtained under harmonic vibration loads according to staunch boundary condition. second, a program to verify the correctness of this dissertation is developed

    主要工作有:本文根據biot平面固結方程,運用積分變換和陣傳遞的方法,研究了成層飽和地基的二維biot固結問題,根據下邊界為不透水基巖的邊界條件,獲得了地基表面作用簡諧荷載時,任意點應(包括孔壓) 、位移(包括流體流量)的一般積分形式解。
  9. In the full of research, the thesis constructed the dynamic equations of the simplified model, then programmed and computed the feedback gains using lqr method. moreover, the thesis plotted pictures of displacement, velocity, acceleration, bend and shearing force of ship ' s head and middle part in the condition of using cable and not using cable

    在研究工作中,首先對船舶的簡化模型建立了學方程,然後採用線性二次型最優控制方法,編寫程序並計算出船體垂向固有頻率和最優反饋陣,得到控制前後船艏以及船舯部的位移、速度、加速度、彎和剪歷程圖。
  10. Based on the perturbation riccati transfer matrix method, the calculating program are developed. the program can be used to the perturbation analysis and the sensitivity analysis of the real and complex, the single and repeated eigenvalues and eigenvectors for lateral vibration of rod and beam structures, especially suitable to the perturbation analysis and the sensitivity analysis of eigenvalues and eigenvectors for rotordynamic systems ; 2. the perturbation riccati transfer matrix method was applied to identify the parameters of the rotor for a boiler supply pump, and the accurate dynamic model of the rotor was archived

    該程序可以對桿、梁結構橫向彎曲的實數、復數的孤立和重頻特徵值問題進行攝分析和靈敏度分析,特別是適合於轉子學系統特徵值和特徵向量問題的攝分析和靈敏度分析; 2 、用攝riccati傳遞陣方法解決了某電站鍋爐給水泵轉子的參數識別及模型修改的問題,並給出了該種型號的給水泵轉子的更準確的學模型,為進一步的轉子學分析與設計奠定了可靠基礎; 3 、給出了攝理論在相關領域如隨機特徵值分析、隨機響應分析、可靠性分析、靈敏度分析、優化設計以及參數識別中的應用公式。
  11. Tower crane has following characteristics : discontinuous working, starting & braking frequently ; there are noticeable vibration and impulsion in running ; high lifting height and extend rang, heavy lifting moment, etc. with the advent of more and more high - rise and large - scale buildings, requirements for the efficiency, lifting height, lifting moment, and safety features are becoming higher and higher

    塔式起重機具有下述工作特點:斷續工作、頻繁啟、制;運行過程中有明顯的和沖擊;起升高度和工作幅度較大,起重大。隨著社會中各類高層建築和大型工程的出現,使其對塔機的工作效率、起升高度、起重和安全性等工作性能提出了更高的要求。
  12. In which integrate compensator was introduced in slide mode controller of velocity loop for reducing torque chattering, and compound sliding controller was designed to avoid chatter in slide mode controller of position loop

    其中速度環通過增加積分環節來消除滑模控制的,位置環通過復合滑模拉制的設計來消除穩態滑模控制的抖
  13. From single - phase power supply, the shocks have driven two of the permanent cigang rotor rotary rotary magnetic field, and reducer with calculated design to export different rotational speed and moment, with the corresponding reduction in rotational speed increase moment

    由單相電源供電,蕩產生兩相旋轉磁場驅永久磁鋼轉子旋轉,與減速器配合,根據計算設計可以輸出不同的轉速和,隨著轉速減少的相應的增加。
  14. Firstly, under the assumption that the output driving torque generated by the stepper motor of the mirror is constant, such influence analysis is conducted. secondly, a mathematic model of the stepper motor is given. under the assumtion that the input impulse frequence is constant, the rotational motion of the stepper motor of the mirror with the mutual exertions of damping torque, friction torque and disturbance torque generated by satellite platform ' s attitude motion is simulated and analyzed

    對衛星平臺姿態對紅外相機掃描機構轉的影響進行了系統深入的模擬分析:首先在步進電機驅一定條件下,模擬分析了星體姿態運干擾對紅外相機掃描鏡轉的影響;接著建立了步進電機的數學模型,在步進電機輸入脈沖頻率一定條件下,模擬分析了步進電機在阻尼、干摩擦、平臺干擾等負載轉的共同作用下的轉情況。
  15. A open - close mathematic model is introduced into calculation of torsional vibration. results show : kurtosisness and high harmonic will increase when crankshaft have crack. 5. cylinder score is also diagnosed by torsional vibration in this paper, when cylinder score occurring, the friction of piston will decrease the action of air pressure

    本文借鑒了裂紋轉子剛度的開閉模型,首次對含有變剛度單元的柴油機裝置進行了扭計算,結果表明柴油機曲軸有裂紋后,扭的角位移和附加振動力矩的高諧次分量會增加,峭度值增加。
  16. From vibrating torque equations of shaker ' s exciting shafts, the self - synchronizing condition and synchronizing state stability condition of balanced elliptical shakers excited by two - shaft self - synchronizing are obtained

    篩偏心軸的振動力矩方程出發,導出了雙軸自同步平橢圓篩的自同步條件和穩定運轉條件。
  17. In order to satisfy the customer ’ s more strict command to the inertia brake, changsha sanzhan inertia brake co., ltd. and hunan university allied to develop a set of equipment of inertia brake test rigs, which can test and research the property of starting torque, braking torque, vibration of axis and so on to all kinds of models and specification of inertia brake to improve the property and quality of product

    為了滿足用戶對慣性制器產品提出的更高要求,長沙三占慣性制有限公司和湖南大學合作開發一套慣性制器試驗臺裝置,對各種型號及規格的慣性制器的起、制、軸向等特性進行測試和研究,以改進產品性能和提高產品質量。
  18. The shocking moment after the complete balance of shocking force can get partial balance through the adjustment of eccentric gear in the attached mechanism

    完全平街后機構的振動力矩,可通過調整附加機構中偏心齒輪的回轉中心得到部分平衡。
  19. A discussion has been made on the problems of balance for shocking force and moment of the commonly used crank slider mechanism in machinery

    摘要對機械中常用的曲柄滑塊機構的振動力矩的平衡問題進行了探討。
  20. In accordance with the principle of mean square root value of shocking force to be a minimum, the concrete position of the rotary center of eccentric gear was determined

    根據振動力矩的均方根值最小原則,確定了偏心齒輪的回轉中心的具體位置。
分享友人