探試器測試 的英文怎麼說

中文拼音 [tànshìshì]
探試器測試 英文
probe test
  • : Ⅰ動詞1 (試圖發現) try to find out; explore; sound 2 (看望) call on; visit; see 3 (向前伸出)...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • 測試 : test; testing; checkout; measurement
  1. In this thesis, the oxygen sensitive materials and glucose sensitive materials had been developed by thermo - polymerization method including carrier covalence method and carrier covalence - cross linking method, and the properties had been investigated using the detection experiment of oxygen and spectrophotometer, at the mean time, the applications of oxygen sensitive materials in fiber optical gaseous oxygen sensor and fiber optical dis solved oxygen sensor, and that of biology sensitive materials in fiber optical dextrose sensor had been studied in this paper. major content of this work includes five aspects as follows : ( 1 ). oxygen sensitive materials had been prepared by carrier covalence method, and the preparation mechanism of the materials had been investigated by fi - ir, sem, and the detection experiment of oxygen

    本論文主要包括以下五個方面的內容: ( 1 )載體共價法制備氧敏感材料:通過紅外光譜、掃描電鏡圖譜和氧實驗討該氧敏感材料的制備機理,通過氧實驗評價該氧敏感材料的氧敏感性和穩定性,同時研究了各種因素對該氧敏感材料性能的影響( 2 )載體共價?交聯法制備氧敏感材料:通過紅外光譜、掃描電鏡圖譜和氧實驗討該氧敏感材料的制備機理,通過氧實驗和分光光度計評價該氧敏感材料的氧敏感性和穩定性,同時研究了各種因素對該氧敏感材料性能的影響( 3 )氧敏感材料在光纖氣態氧傳感中的應用:該傳感的響應時間為10s ,檢下限為5ppm ,檢精度為0 . 5 ,具有較好的重復性和穩定性,遲滯較小,使用壽命至少為1年,適合各種環境下氣態氧濃度的檢
  2. Method for measurement and test of parameters of 4n infrared focal plane detector dewar assembly

    4n紅外焦平面杜瓦組件參數.方法
  3. So anew type of measurement and instrumentation is badly needed and developed which is suitable for non - centralized and stationary measurement based on this idea, this study take the new type of oilavater two - phase flow measurement and instrumentation development as the basic goal, cany out some theoretic exploration of measurement in order to improve oil / water two - phase flow well logging method and technique, and try to accomplish bom holdup and total flow rate measurement with one equipment simultaneously so as to push forward development of oilavater two - phase flow well logging

    本文正是基於這一思想,以開發新的油水兩相流為目標,進行先期的量理論索,圖從原理上改進油水兩相流井方法和工藝,實現利用同種電學敏感原理同時完成持率和總流量的量,推動油水兩相流井技術的發展。
  4. Auxiliary pressure and temperature measurements make the multifrequency phase fluorometer an ideal choice for luminescence sensor design, testing and calibration

    輔助壓力和溫度量讓多頻相位熒光計是發光傳感設計、和校準的理想選擇。
  5. Test procedures for germanium gamma - ray detectors

    鍺射線驗程序
  6. This paper mainly discusses the designing and testing method to the dds acousto - optic mode locking. it also makes some further analysis on the critical technology - - - - - - the transducer acoustical membrane matching and transducer thinning, which can directly affect the performance of acousto - optic elements. it then analyses the heat effect of acousto - optic elements and the technology of transducer thinning by developing ion - beam sputtering of high frequency acousto - optic elements

    本文重點討論了dds聲光鎖模的設計及方法,討論和分析了影響聲光件性能的關鍵工藝換能聲學膜層匹配和換能減薄工藝,對聲光件的熱效應進行了分析,對離子刻蝕法聲光換能減薄新工藝作了一定的討。
  7. Technical requirements and test methods of the high speed photodetector - preamplifier used for the optical fiber communication

    光通信用高速光? ?前置放大組件技術要求及方法
  8. One of the most important advancements recently for electroglas has been in gaining greater control over the z direction of the wafer prober, which affects the accuracy and impact force of touchdowns on wafers and enables their customers to effectively test even the most recent types of delicate devices

    其中伊智公司最近最重要的一個進步就是:實現了對于晶圓針臺z方向的更大程度的控制,這直接影響到針接觸晶圓的精確性和沖擊力,為客戶提供了高效率的;即使是最新型的精細件。
  9. The as - grown crystals were characterization by cutting and directional, x - ray diffraction, high resolution ohmmeter, ir transmission spectroscopy, visible light absorption spectroscopy, scan electronic microscopy ( sem ) and positron annihilate time technique ( pat ). the ir transmittance of czt single crystals grown with cd - riched is about 53 %, while 23 % with no cd riched

    採用解理實驗、 x射線衍射、電學性能、紅外透過譜、可見光吸收譜、 sem蝕坑分析、制等分析方法,並首次採用正電子湮沒壽命譜分析方法來研究czt單晶體的空位缺陷,綜合表徵了所生長的晶體的質量和性能。
  10. This article through installs the reactor with air core in the transformer substation transmission, to control the thunder electric wave amplitude and steepness in the transformer substation ; through over voltage on - line monitoring device testing, inquire into lightning protection of the reactor with air core

    本文通過在變電站的輸電線路的出口處加裝空心電抗,對通過輸電線路侵入變電站的雷電波的幅值和陡度進行抑制;並通過安裝過電壓在線監裝置進行的方法,初步討了空心電抗防雷的作用。
  11. Chapter 4 studies scheduling algorithm of the core node to implement on single adsp2191. the result shows that a single adsp2191 chip can ’ t satisfy the bhp processing delay request and parallel processing is inevitable. chapter 5 primarily studies the core node ’ s scheduling algorithm with many dsp parallel process. details of lauc - vf scheduling algorithm analysis data flow organization and mission distribution are argued. the results of software simulation and hardware debugging indicate that many dsp parallel processing is effective and coincident with the system ’ s demand

    結果表明單片adsp2191晶元不能夠滿足核心節點對bhp的實時處理要求,必須多dsp并行處理。第五章研究了核心節點調度演算法的多dsp并行處理。對多bhp批調度演算法的實現進行分析,討了多bhp處理任務的的劃分和分配方案;多dsp間數據通信和傳輸的dma實現;最後對多處理并行的處理時間進行模擬分析。
  12. This dissertation applies virtual instruments technique in the field of servo valve cat for the first time and makes a servo valve static and dynamic state characteristic test bedstand based on virtual instruments. relevant theories and methods are also studied

    本文首次將虛擬儀技術應用在電液伺服閥cat領域,研製出一套基於虛擬儀的電液伺服閥靜、動態特性綜合實驗臺,並對電液伺服閥靜、動態特性的有關理論及方法進行了研究和索。
  13. Chapter six introduces half - model test study of different parameters with ao effects utilizing the shack - hartman technology. chapter seven investigates the simulation technology for ao, mainly in 2 - d flow - field. this paper has a wide scope, ranging from theoretical foundation of ao to its engineering physics methods, from low temperature to high temperature that influence the index - of - refraction, from 2 - d to 3 - d ( density field ), from high speed to hyper - speed ( interceptor ' s speed ), from model test to numerical simulation ( optical phase measurement )

    並進行了實驗驗證;第四章主要討二維流場折射率的全息量技術;第五章介紹了導引頭三維流場干涉量的驗方法和數據重構;第六章利用哈特曼傳感技術對氣動光學效應各種參數進行了半模研究;第七章是氣動光學的模擬技術,主要研究二維流場數值模擬技術。
  14. Under windows nt and labview development environment, using the linear fit module, exponential fit module > general polynomial fit module of labview to design a method for fitting the experiment data, the results of curve fitting indicate that the purpose of general polynomial fitting is better than the rest. separating the equivalent input impedance of magnetostrictive transducers without stimulate current from input impedance of it with stimulate loop based on the results of curve fitting, and determining the syntony frequency and electric simulation network parameters of magnetostrictive transducers by this input impedance. finally, with labview network functions, realizing magnetostrictive transducer electric simulation system based on web server and discussing a scheme for this system network by datasocket. the method of this paper can more accurately determine the syntony frequency and electric simulation network parameters of magnetostrictive transducers than the testing method of syntony & anti - syntony. at the same time, discussing virtual instrument measurement system and how to realize magnetostrictive transducer electric simulation network system by labview network functions of network virtual instrument measurement development environment

    在windowsnt系統環境和labview虛擬儀技術開發平臺下,首次利用labview中的直線擬合模塊、指數擬合模塊以及多項式擬合模塊,設計了一種對實驗所得數據進行曲線擬合的方法,對三種擬合方法進行了比較,曲線擬合結果表明,多項式擬合方法相對于其它兩種擬合方法效果更好;根據曲線擬合的結果可從帶激勵線圈的磁致伸縮換能的輸入阻抗中分離出磁致伸縮換能鐵芯在無激勵電流時機械振動形成的等效輸入阻抗,並由此輸入阻抗確定了磁致伸縮換能的諧振頻率及其電氣模擬網路參數;最後通過labview提供的網路功能,實現了基於web服務的磁致伸縮換能電氣模擬虛擬儀系統,並討了通過datasocket技術實現該系統網路化的方案。
  15. Standard practice for testing nitrogen phosphorus thermionic ionization detectors for use in gas chromatography

    氣相色譜法用氮磷熱離子電離的標準實施規程
  16. Cd1 - xznxte single crystal with good crystallinity has been grown by the descending ampoule with rotation method - before this, high - purity cd1 - xznxte polycrystal materials have been synthesized from 6n gd zn te in the same ampoule. on the basis of this, we deeply explore method of detector fabrication. and we also studied the level and density of traps in detector. gold, indium and c have been deposited as electrodes on polished and chemically etched surfaces of samples with the sizes from 5 5 1 to 10 10 1. 5mm to compare different contact technologies. the behavior of detector ' s leakage current with temperature and leakage current with time were studied as well as th current - voltage characteristics to deduce the level and density of trap in detectors

    我們利用熔體溫度振蕩法在石英安瓿中將6n的單質cd 、 zn 、 te合成多晶原料,用坩鍋旋轉下降法在同一安瓿中生長出尺寸為20 40mm的cd _ ( 1 - x ) zn _ xte晶體。在此基礎上對碲鋅鎘的工藝進行了較深入的研究,製作了厚1 ? 1 . 5mm的了c 、 in 、 au等不同金屬的電極接觸性能,並在國內首次通過件的i ? v 、 i ? t曲線、弛豫特性和電容特性對電阻率、陷阱能級、陷阱濃度進行了分析,同時得的~ ( 241 ) am源的能譜。
  17. Testing plan guides by using sql server profiler

    使用sql server事件計劃指南
  18. Through equipment testing and artificial testing, the results of table tennis technical testing were examined and the application of ball hitters in the testing was studied

    摘要通過應用儀和人工方法,對體育院系乒乓球技術考核的結果進行相關分析,對多球發球機應用於乒乓球技術考核進行了索,以求乒乓球技術考核的標準化途徑。
  19. Standard practice for testing thermal conductivity detectors used in gas chromatography

    氣相色譜法中使用的導熱的標準實施規范
  20. Test procedures for semiconductor charged particle detectors

    帶電粒子半導體方法
分享友人