接收損耗 的英文怎麼說

中文拼音 [jiēshōusǔnhào]
接收損耗 英文
receive loss
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 接收 : 1 （收受） receive; reception; accept; [電學] receipt; receiving 2 （接管） take over; expropriat...
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. At the same length, the insertion loss of different sub - channels also undergoes changes. this effect, along with the intrinsic background noise, impulse noise and the receiving sensitivity of modem on the adsl, will limit the maximum transmission distance on one single subscriber line

    首先，銅線的插入損耗將隨著線路距離的增加而成比例地增加，並且在同一距離下各子通道的插入損耗也發生變化，這個因素和線路固有的背景噪聲、脈沖噪聲、數據機的接收靈敏度一起將限制在單用戶線上adsl所能夠傳輸的最大距離。
  2. Of course, a message can be consumed by multiple receivers in a pub sub scenario

    當然，在pub / sub場景中多接收端可以損耗消息。
  3. The low insertion loss is achieved by optimizing the transistor widths and bias voltages, by minimizing the substrate resistances, and by dc biasing the transmit and receive nodes, which decreases the capacitances while increasing the p1db

    通過優化mosfet的柵寬及偏置電壓可以降低插入損耗。在版圖設計中通過增加襯底接觸降低襯底電阻，從而減小插入損耗。另外，為接收和發送端提供直流偏置可以降低p1db 。
  4. The simulated results show that we can improve the sensitivity by setting the optical bias at / 2, reducing the gap of electrode, increasing the overlap integral factor, reducing the insert lose, adopting suitable segmentation number, increasing the electrode length, increasing the optical power, reducing the wavelength and the relative intensity noise and reducing the receive bandwidth ; obtain the wider bandwidth utilizing reducing the electrode length and the capacitance of modulator, segmentation the electrode ; increase the dynamic range using lowering noise, increasing the optical power at the detector and lower optical bias

    通過計算得知，使傳感器相位偏置為/ 2 ，減小電極間距，提高電光重疊因子，減小器件插入損耗，採用合適的分段數，增加電極長度，增大光功率，降低激光的波長，減小相對強度噪聲，減小接收帶寬，對提高靈敏度的效果是非常明顯的。而減小天線長度，降低調制器電容，電極分段，都可以獲取較大的帶寬。降低系統噪聲;增加到達探測器的光功率，採用較低的光學偏置，都可以增大線性動態范圍。
  5. Excluded are selling of waste packaging materials used by the establishments ( units ) themselves, commodities transferred without buying or selling procedures, commission income from brokerage in transactions whose settlement is directly handled by buyers and sellers, rejected commodities in the purchase, loss in commodities, etc

    不包括：出售本企業（單位）自用的廢舊包裝用品，未通過買賣行為付出的商品，經本單位介紹，由買賣雙方直接結算，本單位只收取手續費的業務，購貨退出的商品以及商品損耗和損失等。
  6. The system designing of fvisar are discussed in detail in charpter three. especially, the quantitative analysis and simulation research of the velocity range, fringe constant selection and attenuation of fiber delay line are intruduced

    第三章對全光纖速度速度傳感器的系統設計做了詳盡的討論，包括系統光源的選擇、條紋常數分析、光纖延遲線的損耗對調制度的影響、光信號接收單元、數據處理單元。
  7. In particular, the bridge tap at the receiving side will make some sub - channels unusable. to that end, bridge taps on adsl lines must be examined and removed as much as possible. most importantly, there should be no bridge tap of any form at the receiving side

    第四，線路的橋接抽頭將顯著地改變線路插入損耗的頻響特性和相頻特性，特別是接收端附近的橋接抽頭將導致某些子通道無法使用，所以在使用adsl時，一定要檢測線路上的橋接抽頭，並盡可能地去除橋接抽頭。
  8. Receive to transmit stability loss rtsl

    接收至發射的穩定耗損
  9. Receive to transmit stability loss

    接收至發射的穩定耗損
  10. Receive to transmit echo loss rtel

    接收至發射的回波耗損
  11. Receive to transmit echo loss

    接收至發射的回波耗損
  12. Since the transmission loss from each onu to the olt receiver is different, there will exist a wide dynamic range in the received uplink optical power

    每個onu到olt接收機的傳輸損耗不同，因此所接收到的上行光功率將存在較大的動態范圍。
  13. Furthermore, the absorbent ' s electroconductibility as the function of its permittivity and permeability was also uncovered. the reflectance of the absorbents was calculated, and the effects of the preparation and the thickness on the absorbing ability were discussed. in a word, the prepared ilmenite absorbents are non - magnetic materials, at given thickness used in applications, the single - layered absorbents have the minimal reflectivity of - 50db and maximal bandwidth of 5ghz

    初步研究表明：鈦酸亞鐵類化合物屬于電損耗材料；在實際應用允許的設定厚度范圍內（ 2 . 0mm ） ，單層吸收劑的最小反射率（ rmin ）可達- 50db左右，最大帶寬（ ? db ）接近5個ghz ，吸波性能很好。
分享友人
分享到 Line

分享到臉書