接觸摩擦 的英文怎麼說

中文拼音 [jiēchùmócā]
接觸摩擦 英文
contact frection
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 摩 : 摩構詞成分。
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  • 摩擦 : 1 （互相接觸的兩物體作來回相對運動） rub; chafe 2 [物理學] （相互接觸的兩物體在接觸面上發生阻礙相...
  1. Fist of all, on the basis of the research of agone boffins, this author investigates the interaction mechanism of bolts and rock, and introduces the elastic ? lastic analytical resolution which is consist of the liner structure, the equivalent reinforced wall rock and the original wall rock in the simple loading from the equivalent well - proportioned view ; this solution is very important meaning for the engineering design. on the basis of coulomb friction model, the author introduces the finite element equation of the contact problem in order to provide the academic foundation for the application of msc. marc. finally, combining the engineering practice of the non - linear analysis of shield tunnel through yellow river of the south - north water transfer and using the model of friction, the author researched the evolution law of stress and displacement field in the structure of grouted rock bolts, and analyzed the effect to the stress and deformation of surrounding rock mass due to anchor supports

    首先，在前人研究成果的基礎上，對錨桿與圍巖的相互作用機理進行研究，利用全長錨固錨桿的中性點理論，從等效均化的角度來考慮錨桿對圍巖的加固作用，並推導了在簡單荷載作用下，含有襯砌、等效加固后的圍巖、原始圍巖三者的彈塑性解析解，對工程設計有著重要的參考意義；在數值模擬方面，以考慮錨固圍巖滿足規則化庫侖摩擦模型為基礎，利用虛功原理推導了接觸問題的有限元方程的計算格式，為開發運用大型商用有限元軟體msc . marc提供了理論根據，也形成了本文的理論基礎：最後，論文以南水北調東線穿黃隧洞穩定性分析項目為工程實例，利用本文所述的接觸問題的摩擦模型理論，對錨桿支護結構的應力場、位移場的變化規律進行了研究，分析了加錨支護對隧洞圍巖應力、變形的影響。
  2. This is where the rubber meets the road. the outsole ' s design affects the traction you ' ll get on hard and clay courts

    這是橡膠接觸地面的部分。鞋底的設計會影響你在硬地和土場上的摩擦力。
  3. It could be used for simulating study in aeronautical weapon. there is a set of hold - range transfer mechanism and friction drive system in the equipment. it also used a set of hydraulic system to drive the equip in right position for multiple parameters detecting and made extrusion stress in limited range

    在裝置中，採用了同步帶傳動機構及摩擦驅動裝置，並採用了液制系統進行驅動檢測參數要求的換位和摩擦輪的壓力調節，保證了檢測裝置的正確位置和摩擦輪接觸正壓力的有效工作范圍。
  4. Based on the research of the characteristics of piezoelectric ceramic, this paper presents the analysis of the movement of the stator surface points and work principle of motor. this paper describes a theory about the influence of the ultrasonic vibration on the frictional properties of ultrosonic dring, and finds that the horizontal vibration produces friction driving force and vertical vibration affects horizontal driving effect

    並且對行波型超聲波電動機的減摩現象進行了研究，發現在接觸區定子表面上一點的水平振動產生摩擦驅動力，垂直振動只起影響水平驅動效果的作用，得出垂直方向超聲振動具有減振作用是引起超聲驅動動摩擦系數降低的原因。
  5. For sliding contact, the coefficient of kinetic friction uk is defined as the ratio of the frictional force to the normal force.

    滑動接觸時，動摩擦系數Uk的定義是摩擦力與法向力的比率。
  6. For sliding contact, the coefficient of kinetic friction uk is defined as the ratio of the frictional force to the normal force

    滑動接觸時，動摩擦系數uk的定義是摩擦力與法向力的比率。
  7. Foundation in to the steel wire race ball bearing contact theoretical analysis computation, and the steel wire race ball bearing main friction form analysis, gave the bearing several kind of main friction to have the form in the work process, and gave the corresponding theoretical calculation formula

    在對鋼絲滾道球軸承點接觸理論分析計算的基礎上，進行了對鋼絲滾道球軸承的主要摩擦形式分析，給出了軸承在工作過程中幾種主要的摩擦產生形式，並給出相應的理論計算公式。
  8. This increase in friction is attributed again to an increase in area of contact at the f/m interface by the swollen rayon yarn.

    這種摩擦力的增加也是由於FM相交界面粘膠長絲吸濕膨脹引起接觸面積擴大的緣故。
  9. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  10. 5. numerous simulations are done with different initial docking misalignment by adams software and ddss : ( 1 ) influence of the contact columbus friction to simulation results is inspected ; ( 2 ) adams results are compared with that of ddss, both the results validate each other ; ( 3 ) simulation results show good capture ability of

    5 .對各種對接初始偏差，分別用adams與ddss進行了大量的模擬研究: （ 1 ）考察了接觸點處庫侖摩擦力對模擬結果的影響; （ 2 ） adams與ddss對比分析結果相互驗證了模型及演算法的正確性。
  11. Compared the results of fea and the data of experiment, we can analyse that the distributing of the seismic stress of polymer - geogrid reinforced material is similar to that of the static stress, but the stress values of them is different ; the seismic similar friction coefficient between the earth and reinforced material fall with the increasing of earthquake acceleration, model acceleration respond along the height of the model, etc. thirdly, according to the comparison and analysis of the model seismic fea results and model experiment data, we can find the polymer - geogrid reinforced earth seismic fea is reasonable, which is composed by earth element, contact element and reinforced material element

    通過對比有限元計算結果和試驗數據，分析得出塑料土工格柵筋材的最大動拉應力的分佈與靜拉應力的分佈沿筋材的埋深大致相同，只是應力的值大小不同；地震作用下土筋間的動似摩擦系數是隨地震加速度的增加而減小；模型沿墻高方向的加速度響應等。接著，根據模型動力有限元時程分析結果和模型試驗數據的比較分析，得出由土體單元、接觸單元和筋材單元組合的塑料土工格柵加筋土非線性動力有限元分析模式的合理性。
  12. Because of no contact and friction, damage to the apparatus may be decreased and the spark may be ignited will disappear. potential applications are the rising power delivery for high - speed electric locomotive and electric vehicle. it can also be applied to chemical industry, mining and other inflammable fields

    由於沒有接觸摩擦，可減少對設備的損傷，也不會產生易燃易爆的火花，可用於目前正在興起的高速電力機車、城市電車饋電以及化工、采礦等易燃易爆領域。
  13. The model from the input to the output of the piezoelectric traveling wave ultrasonic motor is established by synthetically using lagrange - maxwell equation, hertz elastic contact theory and coulomb friction theory, along with considering electromechanical coupling, influence of the interface force between the stator and rotor of the motor on the amplitude of the traveling wave inside the stator and dynamic contact friction friction force

    利用拉格朗日?麥克斯韋方程以及赫茲彈性接觸理論，庫侖摩擦理論，考慮機電耦合效應，定、轉子間界面力對彎曲行波的影響及其動態接觸摩擦力，建立了壓電行波超聲波馬達從輸入到輸出的機電耦聯系統的數學模型。
  14. Surface acoustic wave ( saw ) motor is a novel micro actuator, which generates saw with the electroacoustic transducer and transfers it to the power of saw motor by the frictional force between the slider and the stator

    表面彈性波馬達是一種以電聲換能器產生表面彈性波，並通過馬達動子和定子的接觸摩擦將表面彈性波振動轉換為馬達動力的新型執行器。
  15. And the constitutive model for the plasticity and damage description is further derived based on the hill ' s self - consistent scheme

    對bs11在典型輪軌接觸摩擦應力狀態下的響應特性與損傷進行了分析。
  16. Most instrument ball bearing applications introduce a lubricating fluid to the contacts with the ideal goal of achieving complete surface asperity separation

    絕大多數的滾珠軸承應用流體潤滑劑來實現完全隔離表面粗暴接觸（摩擦）的理想目標。
  17. Analysis makes known, what it is along the progressive failure process of the slop that be able to more reasonably make known steady along slope actual situation, utilize contact friction spring element

    分析表明，邊坡穩定性分析的漸進破壞法能更合理地反映邊坡穩定的實際情況，利用接觸摩擦彈簧元可以有效地模擬這一過程。
  18. Three possible contact driving mechanisms of saw motor are discussed, and the frictional drive of saw motor is shown by the linear relation between the speed of the slider and the driving voltage

    探討了表面彈性波馬達三種可能的接觸傳動機理，並以表面彈性波馬達動子速度與驅動電壓呈線性的關系，首次證實了表面彈性波馬達的工作原理是接觸摩擦傳動。
  19. A reciprocating compressor using labyrinth seal ( labyrinth piston compressor, lpc ) can compress and transport gases in an oil - free way. it has many advantages, such as non - lubricated maintenance, no friction loss, no hot spots, minimal wear and tear, and so on

    採用迷宮密封的往復式壓縮機可以完成潔凈氣體的壓縮和輸送，具有壓縮過程無潤滑、無接觸摩擦、氣體無污染、安全可靠等優點。
  20. Abstract : in this paper, first fe simulation algorithms for contact search, contact constraint, and the calculation of contact and friction loads were established based on the analysis for contact friction problem in sheet metal forming. then the fe simulation model for contact friction problem in sheet metal forming was set up. at last, the efficiency & amp; stability of this model was proved to be satisfactory by the comparing numerical example and experiment results of skin stretch forming

    文摘:本文在分析了板料成形過程接觸摩擦問題特點的基礎上，提出了接觸搜索、界面滑動約束、法向接觸力以及摩擦力計算等問題的有限元模擬演算法，建立了板料成形過程接觸摩擦問題的有限元模擬模型，最後通過數值算例與飛機蒙皮拉形模擬試驗結果的比較，驗證了此模型計算精度及數值穩定性良好。
分享友人
分享到 Line

分享到臉書