接觸電極 的英文怎麼說

中文拼音 [jiēchùdiànjí]
接觸電極 英文
contact electrode
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  • 電極 : electrode; pole
  1. Secondly the major mechanisms of degeneration of pcss are caused by both the filamentary nature of the current in high - gain pcss damage to the chip of the switch and the charge domain reached the anticathode causes the erosion of metal interface

    開關退化的主要原因是:開關體內的絲狀電流對開關晶元的損傷;以及電荷疇到達陽極時來不及放電而產生的電荷擁擠現象對開關電極接觸表面的損壞。
  2. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  3. An electric arc is struck by contacting the electrodes

    接觸電極便擊出電弧。
  4. Polyvinyl chloride and polyvinyl chloride can resist to be oxidized. soapnated cellulose acetate can prevent dissolved ferrate ( vi ) penetrating toward the anode and prevent dissolved cathode ' s discharge products penetrating toward the cathode

    （ 1 ）壓製成型的正極經過相同的存放時間，不與電液接觸情況下k _ 2feo _ 4的分解比例，比與電液接觸情況的小。
  5. Schottky barrier diode is a kind of majority carrier device, using the contact barrier formed between metal and semiconductor to work. it has the advantages of low turn - on voltage and high response frequency, compared with pn junction diodes

    肖特基二極體是利用金屬與半導體之間接觸勢壘進行工作的一種多數載流子器件，與普通的pn結二極體相比，它具有正向導通電壓低，響應速度快等優良特性。
  6. Yuli brand drive optical network lights and the colourful new torpedo lights product range, is use of new improved power spring - loaded device access by luminous objects bottom cathode metal with top of spring - loaded contacts, contacts larger, use more flexibility, and must change the old generation network light bending of " spring - loaded " installation use error - prone, lean, exposed the defects

    "魚利"牌勁光網標燈及彩光新魚雷燈系列產品採用全新改良的電源彈簧接觸裝置，由發光器底部負極金屬片與彈簧頂部接觸，接觸面更大使用更加靈活方便.傾底解決了老一代網標燈彎尾彈簧安裝使用時易偏差、傾斜、外露的毛病。
  7. The influences of vertical grounding electrodes on grounding resistance, step and touch voltages were analyzed numerically

    採用數值計算方法分析了垂直接地極對接地系統的接地電阻、接觸電壓及跨步電壓等的影響。
  8. It creates the model of layer soil by using the cdegs software, analyses the resistance error which is measured by traditional three - poles way, measures the grounding grids resistance and soil resistance rate of hejin power plant, creates the electromagnetic model of layer soil and grounding grids model of hejin power plant, calculates the step voltage > touch voltage n voltage distribution of earth surface in fault of hejin power plant. in the end, it compares the measuring value and calculating value of grounding grids resistance in hejin power plant

    本文利用cdegs軟體建立分層土壤接地模型，對傳統三極法測量接地電阻誤差進行分析；對河津電廠接地網接地電阻和土壤電阻率進行測量；建立河津電廠分層土壤電磁模型和接地網模型；計算河津電廠接地網電阻和事故狀態下跨步電壓、接觸電壓和地表電位分佈；最後對河津電廠接地網電阻實測值與計算值進行比較分析。
  9. The main work includes three contents as followings : 1, the situation of ohmic contact about al electrode, ti / al electrode on n - gan in different annealing conditions are investigated

    主要工作如下： 1 、研究了al單層及ti al雙層電極與n型gan在不同退火條件下的歐姆接觸情況，並用挖補圓盤法計算出接觸電阻率。
  10. We should consider the stripe-contact device.

    我們應考慮這個條形電極接觸器件。
  11. An experimental system of electro - spray with two different charging methods - inducted by ring electrode and polarized by contacted needle electrode is established. an effective charging equipment for fuel is designed. water and kerosene ' s characteristics of charging and atomization in the electro - spray are measured and analyzed

    2 、建立了環狀感應電極充電和閉式接觸電暈充電的荷電噴霧實驗系統，對煤油和水兩種不同物性介質的荷電特性與荷電霧化特性進行了測量及分析。
  12. The results show that the vertical grounding electrodes can effectively decrease grounding resistance, step and touch voltages of the grounding system and reduce the influence of seasonal factors on the grounding system

    分析表明，增設垂直接地極能有效減低接地系統的接地電阻、減小發變電站的接觸電壓和跨步電壓、減小季節因素對地網安全性的影響。
  13. The contact area between clamp and terminal is either silver or copper.

    夾頭和電極之間的接觸面是銀的或銅的。
  14. Research on surface and grain boundary passivation mechanism obtained effects of surface recombination on crystalline silicon solar cell performance and the theoretical expression of grain boundary recombination velocity. the limit ratio of short - circuit current increment for anti - reflection coating utilization on solar cells was obtained. the crystalline silicon solar cell spectral response, contact resistance and minority carrier lifetime measurement systems were established

    鈍化機理研究獲得了表面復合對不同表面摻雜濃度晶體硅太陽電池性能的影響、表面和界面復合速度的理論表達式；研究得到了減反射膜對太陽電池短路電流增量比的極限；建立了太陽電池光譜響應、柵線電極接觸電阻和少子壽命等測試系統。
  15. Ultrasonic wire bonding was applied to connect the contacts and sub - miniature - a ( sma ) connectors. also a suitable shield box has been designed for the test of hts filters

    對于超導濾波器的焊接，採用超聲點焊焊接sma的接頭和高溫超導濾波器的接觸電極，實現了較小的接觸電阻和較好的機械強度。
  16. Leakage current is one of key factors for the energy resolution of the detectors, the mis detector has lower leakage current thus improve the energy resolution. the mis structure is a good contact type for the cdse detectors

    可見漏電流是影響探測器能量解析度的重要因素，具有mis接觸電極的探測器能有效地減小漏電流，提高能量解析度，因而是cdse探測器的一種較佳電極接觸方式。
  17. During this process, the level of doping concentration exceeds the density of cd vacancy in the crystal. in addition, the preparation of au contact on cd1 - xznxte wafers was studied. after further thermo - treatment, the stable ohm au contact was achieved

    此外，對于在cd _ （ 1 - x ） zn _ xte晶體上制備穩定歐姆接觸電極進行了相應的研究，制定出相應的蒸鍍及退火工藝。
  18. For the purposes to make cd1 - xznxte detector, ohmic contact materials of cd1 - xznxte crystal are selected and structure of electrode is designed. the processing of conducting film prepared by the magnetron sputtering is studied

    本研究主要開展了在cdznte晶體上歐姆接觸電極的設計選材和磁控濺射方法制備導電薄膜的工藝研究，為cdznte探測器的制備奠定工藝技術基礎。
  19. One of the most key technologies of preparing cd1 - xznxte detector is to make ohmic contact film electrode on cd1 - xznxte crystal ' s surface, and the main technology usually used is evaporation, but the cohesion of evaporated film is n ' t very firm

    制備cdznte探測器最關鍵的技術之一就是在cdznte表面制備出歐姆接觸薄膜電極。關于在cd _ （ 1 - x ） zn _ xte晶體表面制備接觸電極用導電薄膜，大都是採用蒸發鍍膜技術，膜層與cdznte晶體結合不很牢固。
  20. Because the contact resistance between the metal contacts and the superconducting films has large impact on the performance of superconducting filters, we experimental techniques. after annealing the optimum temperature and, we got the minimum contact resisitivity. we also further studied the interaction between ag and ybco films after annealing at a certain temperature and attempted to give an explanation and discussion

    金屬接觸電極與超導薄膜之間的接觸電阻對超導濾波器的插入損耗有很大影響，因此，本文通過多種實驗方法，系統的研究了ag與ybco超導薄膜之間的接觸電阻問題，得到了最佳退火溫度，並對退火時ag與ybco超導薄膜之間相互作用的機理進行了研究和探討。
分享友人
分享到 Line

分享到臉書