接觸面積 的英文怎麼說

中文拼音 [jiēchùmiànjī]
接觸面積 英文
area of contact
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  • 面積 : [數學] area
  1. The ultrasonic dynamic contact of bolt - clamped transducer and rigid plane are modeled using hertzian contact theory, and the analyzing results reveal that the nodal plane of the bolt - clamped transducer is levitated in normal direction by the ultrasonic dynamic contact action, and the real area of contact of bolt - clamped transducer and rigid plane decreases in the same time

    首先利用赫茲接觸理論建立了夾心式換能器和剛性平面的超聲動態接觸模型。通過對模型進行分析、求解表明，在縱向超聲頻率動態接觸作用下，換能器節面位置產生了上浮，換能器端面與剛性平面的動態真實接觸面積比靜態時減少了。
  2. Fine structure for the smaller contact area

    接觸面積小時用細密的組織
  3. The major function of having precious metals coated with carriers is that it can provide with larger touchable square measure. therefore, it can provide the largest surface square measure and held - up time. equilibrium tight intensity can provide gas with good mixable degree and even step - down in order not to cause slanting flow

    將貴金屬披覆于擔體上，主要功能為提供較大的接觸面積，因此可提供最大的表面積及滯留時間，均衡的緊密度可提供氣體好的混合程度及均勻的壓降，不致造成偏流。
  4. Another question discussed was the pore shape correction. the equivalent pore radius of the elongated microcrack membrane pore was corrected by the correlation present in the study on the stomata diffusion of monocotyledons

    這合理地解釋了在膜接觸器氣液分離過程中，氣液接觸面積等於整個中空纖維膜的表面積而不是孔面積這一實驗現象。
  5. This increase in friction is attributed again to an increase in area of contact at the f/m interface by the swollen rayon yarn.

    這種摩擦力的增加也是由於FM相交界面粘膠長絲吸濕膨脹引起接觸面積擴大的緣故。
  6. Deodorization effect is high. because oxidization effect has large touchable square measure, it can handle a large number of odor effectly

    ~除臭效果高，由於氧化反應接觸面積大，可以有效的處理大量的臭氣。
  7. A series of tests were performed on the self - made fretting wear test rig to examine the fretting wear of steels, by taking the wear depth of steel wires as a characterization parameter describing the fretting wear in relation to contact load and fretting time. the results demonstrates that the fretting wear depth increases with the increasing of the contact load and fretting time

    結果表明，鋼絲試樣的微動磨損深度隨著接觸載荷和微動時間的增加而呈增長趨勢，但由於接觸面積和接觸應力在微動磨損過程中隨著接觸載荷和微動時間的變化而變化，使磨損深度在不同磨損工況下增長趨勢不同。
  8. With its important functions as load - bearing, shock absorption, stabilization, lubrication and congruency, the meniscus plays an important part in the complex biomechanics of the knee joint

    摘要半月板是膝關節的重要組成部分，它能吸收震蕩、增加關節面的接觸面積和潤滑關節，在傳遞載荷、穩定關節和防止關節退變等方面起著重要作用。
  9. The solid filler spread on top of the filler layer serves as the medium for gas and liquid contact ; the mixture is then demisted by the demist system ; air is then released to the atmosphere to achieve the purpose of exhaust treatment

    再經由填充層上之大表面積固體填充物作為介質，提供氣體與液體充分的接觸面積，最後由除霧系統除霧后，氣體排入大氣中，以達到處理廢氣的效果。
  10. Therefore, a novel optimization method for calculating the effective interfacial area is developed for two and three - phase distillations

    由此，本文提出了一種兩相和三相精餾過程有效相接觸面積優化計算方法。
  11. 4. based on the sensitivity analysis by a step - perturbation test for several most important parameters, the effective interfacial area is found the most sensitive parameter, which affects the separation efficiency in structured packing column significantly

    4 .基於階躍攝動測試，對非平衡模型主要參數進行了靈敏度分析，結果表明模型中的有效相接觸面積的靈敏度最大。
  12. However, when the samples have different effective contact areas, the degrees of dissolution may depend on the swing of the pendulum between the dissolution velocity and their effective contact area

    但當樣品在水巖反應過程中有不同的比表面積時，溶蝕作用的強弱或快慢就取決于巖石溶蝕速率與水巖反應有效接觸面積的消長關系。
  13. This increase in friction is attributed again to an increase in area of contact at the fm interface by the swollen rayon yarn

    這種摩擦力的增加也是由於f m相交界面粘膠長絲吸濕膨脹引起接觸面積擴大的緣故。
  14. This increase in friction is attributed again to an increase in area of contact at the f / m interface by the swollen rayon yarn

    這種摩擦力的增加也是由於f m相交界面粘膠長絲吸濕膨脹引起接觸面積擴大的緣故。
  15. The clouds of gas, however, were held back because they presented a much broader face to each other

    然而，氣雲卻受到了阻力，因為它們彼此的接觸面積要大得多。
  16. As compared with the conventional straight well, the horizontal well can greatly increase the contact area between well and reservoir, change the filtrational mode in the vicinity of wellbore in the reservoir and reduce filtrational resistance, thus obtaining higher oil and gas production by a relatively low producing pressure difference

    摘要同常規的垂直井相對比，採用水平井開采能夠大幅度增加油氣井與油氣藏的接觸面積，改變油氣藏中井筒附近區域的滲流方式，降低滲流阻力，進而可以利用較低的生產壓差來實現更高的油氣產量。
  17. Three models are proposed as follows by applying the model of " mixed flow " : the stress of increasing fluid on fouling, collision between solid particles and fouling, and solid particles movement velocity ; the effects of operating parameters, properties of particles, and the volume fraction of particles on stress in solid - liquid two phase flow, collision stress between solid particles and fouling, maximal contacting area between solid particles and fouling and maximal contacting time between solid particles and fouling are investigated systematically by calculating and theoretical analysis

    利用「混流」模型，建立了兩相流體的剪應力模型、固體顆粒與垢層的碰撞模型和固體顆粒的運動速度模型；通過計算和理論分析，系統地考察了操作參數、顆粒物性、顆粒體積分率等對固液兩相流剪應力、顆粒對垢層的碰撞力、顆粒與垢層的最大接觸時間和最大接觸面積的影響。
  18. By changing the tube into d shape ( semicircle ), the pallet can fully contact with the tubes ( re. picture 2 ), the cooling speed can be shortened by the contact surface increased

    如果把管子的形狀改成d形（半圓形） ，托盤在管子上的接觸為平面接觸（如圖2所示） ，接觸面積比圓管大大增加，熱量以最快的速度從托盤傳至排管並由管內的冷劑蒸汽帶走。
  19. One has to hit in the direction that the edge is pointing at, so that the contact area would be as small as possible to ensure the generation of a large pressure. hence, the target s surface is penetrated and a cut is made

    要斬進的話，刀劍必須向著鋒口所指的方向直線走，與目標物的接觸面積越小越好，以確保產生出最大的壓力，足夠穿過目標物的表面，造成一次成功的斬擊。
  20. Rough and loose structure for rough grain size

    接觸面積大時用粗松的組織
分享友人
分享到 Line

分享到臉書