接通電流脈沖 的英文怎麼說

中文拼音 [jiētōngdiànliúmàichōng]
接通電流脈沖 英文
make impulse
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 通 : 通量詞（用於動作）
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 接通 : 1 （撥通電話） put through; connect; get through 2 （連通） [電學] close; close up; cut in; （key...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  2. 2 ignitor : - this is an electronic amplifier that receives electric current from the ballast and boosts voltage to ignite the arc light source in all environments. it initializes plasma discharge within the source by delivering a high - volt pulse to the electrodes

    2 ignitor : -是一個從ballast接收電流並向所有環境中的arc light source釋放電壓的電子放大器，它通過向電極傳遞高脈沖來對等離子放電器進行初始化
  3. With the mathematic model of tracking beam current by velocity, real - time tracking can be obtained ; with current simulation controlling transducer and subsection linearity, precision of velocity ( error in ? 1 % ) is triumphantly can be controlled ; with inspection of the pulse numbers of switches, the position of all vehicles are checked to eliminate the error of calculating distance between all ones

    通過建立速度跟蹤束流的數學模型，較好地解決了速度跟蹤束流的實時性問題;通過採取用電流模擬量控制變頻器和分段線性處理的辦法，成功地解決了速度精度問題（誤差在士1 %內） ;通過檢測接近開關觸發的脈沖數，適時校核所有小車位置，消除各車之間距離計算誤差，從而很好地解決了距離累計計算誤差。
  4. At last, an experiential power supply was made, and a series of experiments is done. a lot of high - frequency pulse current was superposed on dcen current, modulated the welding current waveform we required and optimized the energy distribution, which satisfied the basic requirement of cathode cleaning

    最後製作了一臺實驗電源，並進行了一系列的電弧實驗，通過在變極性電源電流dcen基礎上疊加一系列脈沖電流，調制出所需電流波形，實現輸出能量的最優分配，在滿足陰極清理的前提下，最大限度地提高焊接效率。
  5. In this part, the high - frequency series inverter with resonant pole capacitor is introduced mainly. the current - exchanging processes of the inverter in different working modes are analyzed, how to reduce the switching loss is discussed, and the calculating methods of snubber capacitor c, factor angle switching frequency and pulse width pw are given in optimum switching process. and results of simulation and experiment verify the validity of theoretic analysis

    接著重點研究了含有諧振極無損緩沖電容的逆變器，對其換流過程中的不同工作狀態進行分析，討論了如何減小逆變器的開關損耗，給出了最佳工作狀態下緩沖電容c 、感性角、開關頻率、觸發脈沖的脈寬pw的詳細計算方法，並通過大量的模擬和實驗波形證明了理論分析的正確性。
分享友人
分享到 Line

分享到臉書