控制點設置 的英文怎麼說

中文拼音 [kòngzhìdiǎnshèzhì]
控制點設置 英文
point setting
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 設 : Ⅰ動詞1 （設立; 布置） set up; establish; found 2 （籌劃） work out : 設計陷害 plot a frame up; fr...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 設置 : 1. （設立） set up; put up 2. （設置） install; fit
  1. Sets up control points for spherical quadrangle interpolation

    設置球狀四角插入的控制點。
  2. This paper introduces common background knowledge of intersection, mainly describes traffic control design principle, such as signal timing and lane channelization. it also summarizes the same point between signal timing and lane channelization in nature and illustrates that it is optimal cycle length and signal phase that is the critical part of signal timing

    =本文介紹了交叉口的一般背景知識，重點闡述了平面信號交叉口的交通控制的設置原理，包括信號配時原理和路口渠化原理，概括了信號配時和路口渠化原理的本質相同點。
  3. Explores the location of pressure difference control points in variable flow rate systems with a hot water heating piping model

    摘要結合一個熱水供暖熱網模型，探討了變流量壓差控制點的設置位置。
  4. Then in allusion to biased momentum wheel system, based on classical control system a pid controller was design about pitching channel. according to specialty of roll - yawing channel, this paper discuss long - time cycle movement and short - time cycle movement. when design the control method of long - time cycle movement, whiff thruster is used to assistant the control system. when design the control method of short - time cycle movemen, in order to sovle the problem of coundn ’ t abtain the angular velocity signal, nonminimum phase controller advanced by terasaki is used

    然後針對偏置動量飛輪系統，基於經典控制理論設計俯仰通道的pid控制律，根據滾動?偏航通道耦合的特點，分別討論了由軌道角頻率和章動頻率引起的長周期運動和短周期運動。其中長周期運動控制律設計時，結合了噴氣推力控制來輔助偏置動量控制;短周期運動控制中，為了解決不能獲得角速度信號的問題，採用terasaki提出的非最小相位控制器進行控制。
  5. Calculating and analysing result indicates that the control point located in the joint of first user and main pipe and the pressure difference equaled to the design value can satisfy the demand flow rate of the users and save energy

    計算分析結果表明，將控制點設置在第一個熱用戶與主幹管的連接處、控制壓差設為該處的設計工況壓差既能保證熱網中各用戶流量又較節能。
  6. The technical problems are clarified and the corresponding solutions are given. ( 1 ) because there are several supervisors for remote viewing, the contradiction between safe operation and monitoring control can be avoided by installing the indispensable main controller and secondary controllers. ( 2 ) the operation state and video information of substations should be displayed on the same screen. ( 3 ) appropriate measures should be taken for the data processing, storing and communication in the multimedia master station systems

    文中闡述了主要的技術問題和相應的解決方案：主站將出現多個遙視控制點，設置必要的主控和分控可以避免安全操作和監視控制上出現的矛盾；變電站工況信息和視頻信息協調顯示的一種較好的方法是同屏演示；主站在數據處理和存儲、通信網路等方面也將相應變化。
  7. First, robust controllers design with mixed performance requirement is researched by giving output - feedback synthesis with h2, h and regional pole placement constraints. second, reduced - order robust filters design for continue - time / discrete - time systems is researched. the filters obtained are a set of permitted ones and have optimality and unbiased estimation

    首先，以極點配置、 h _ 2 、 h _為目標的輸出反饋綜合為例研究多目標魯棒控制器設計；再則，對連續離散時間系統研究降階魯棒濾波器設計，使得所設計的濾波器具有最優性和無偏性。
  8. The system contains the following three subsystems : control module, configuration module and agent module. in the thesis, we discuss the function and module design of this system and focuses on introducing the operational principle and design of agent module

    系統包含控制端、配置端和agent端三個子系統，本文闡述了該系統的功能設計與模塊設計，重點介紹了agent端的工作原理與agent端的設計。
  9. Internal control system about credit operational risk of commercial banks aimed to ensure credit business sustained developing and control credit operational risk. it is summation of adoptive organizations, methods and procedures that it takes process of credit operation and management and operational activities as control object, standardizes credit operation and sets the risk control point in reason, uses all control factors. that commercial banks develop credit business must be based on established internal control system about credit operational risk

    商業銀行信貸業務風險內控制度是商業銀行為了保障信貸業務的健康發展，控制信貸業務風險，以信貸經營管理過程和業務活動為控制客體，以規范信貸業務活動並在業務流程中合理設置風險控制點，綜合運用各種控制要素所採用的組織、方法、程序的總和，商業銀行開展信貸業務應該以建立信貸業務風險內控制度為前提。
  10. It covers the theory and algorithm of how to implement the breakpoint, single step, execution control and symbolic access. the general hardware and operation system support are briefly introduced in order to well explain the mechanism of debugging process

    然後介紹了斷點設置，單步跟蹤，執行控制和符號表讀寫的原理;以及硬體和操作系統對跟蹤調試的支持。
  11. Through analyzing strata ' s absorbtion and attenuation, the specialty of ssf in system - one ( two ) and 24 - bit a z a / d, the scheme to improve the data acquisition system is brought forward including the design of multiple differential spectrum equilibrium filter ( mdsef ) and program control amplifier

    通過詳細分析地層的吸收衰減特性， system - one （ two ）頻譜整形濾波器及24位a d的特點，對現有採集系統提出了改進方案。其中包括對多級微分頻譜均衡濾波器的理論設計，程式控制型前置放大器的理論分析與設計。
  12. Control or sets input focus to the control

    控制項中的選擇或將輸入焦點設置到該控制項上。
  13. Sets input focus to this control

    為此控制項設置輸入焦點。
  14. Sets input focus to the control

    為控制項設置輸入焦點。
  15. Sets input focus to a control

    為控制項設置輸入焦點。
  16. In this approach, an target pressure distribution is developed using a set of control point and require only global parameters as input. the chordwise locations and pressures of these points are then aptly adjusted during process to satisfy the flow and geometric constraints

    本文根據總體設計參數用一系列控制點來生成目標壓力分佈，在設計過程中這些控制點的位置和大小可以適當調節以滿足流動和形狀約束。
  17. This algorithm allows the users design the control frame freely. compared with other algorithms, it abandons the limitation of topological structure among the control points and uses sibson local coordinate system, so it is more flexible and universal

    和其它演算法相比該演算法允許用戶根據需要設置控制點，拋棄了對控制框架的拓撲結構的限制，使用更為一般的sibson局部坐標系（ sibsonlocalcoordinatesystem ） ，因而該演算法更具靈活和通用性。
  18. Client script is used to set focus on the specified control

    客戶端腳本用於將焦點設置到指定控制項。
  19. Any methods or properties that set focus on controls, such as the

    將焦點設置到控制項的任何方法或屬性，如控制項的
  20. The authentication level set on the endpoint controls which network connections are accepted by the endpoint

    對端點設置的身份驗證級別可控制該端點接受哪些網路連接。
分享友人
分享到 Line

分享到臉書