控流閥 的英文怎麼說

中文拼音 [kòngliú]
控流閥 英文
flow control valve
  • : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  1. Industrial - process control valves - flow capacity - sizing equations for fluid flow through multistage control valves with interstage recovery

    工業過程式制制.通能力.通過有段間恢復功能的多段量的校準公式
  2. Industrial - process control valves - part 2 - 5 : flow capacity ; sizing equations for fluid flow through multistage control valves with interstage recovery

    工業過程式制制.第2 - 5部分:通能力.通過有段間恢復能力的多段門的量的校準公式
  3. Industrial - process control valves - part 2 - 5 : flow capacity - sizing equations for fluid flow through multistage control valves with interstage recovery

    工業過程式制制.第2 - 5部分:通能力.通過有段間恢復能力的多段門的量的校準公式
  4. Nibco ' s new circuit balancing valves control and maintain a comfortable indoor climate while saving energy and reducing costs. these control valves ensure trouble - free operation and ease of maintenance

    在節約能源和降低成本的同時,美國尼伯科的量平衡制調節和維持一個舒適的室內環境。這些保證無故障運行,並且維護保養簡便易行。
  5. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合制實驗系統和實驗方法;介紹了實驗採用的制的pid演算法;並測定了執行器芯位移相關的系數;做了單個執行器計算量反饋制、量足夠情況下多執行器量任意分配、量不足情況下多執行器按比例調節量分配和多執行器進油側量反饋分制實驗;通過實驗說明了論文提出的分制方法能實現大小慣性負載復合操作時的合理分
  6. The improvement system is made up of the pressure sensor, flow sensor, displacement sensor, electro - hydraulic proportional flow control valve, power amplifier, data gathering board and computer. the platform can carry out testing the hydraulic parameters, processing the tested data, saving the processed data and drawing, adjusting the pressure automatically

    改造后的測系統主要由壓力傳感器、量傳感器、位移傳感器、比例節、功率放大器、數據採集卡和計算機組成。改造后的實驗臺具有自動採集實驗數據、自動處理實驗數據、自動保存實驗數據、自動調節液壓系統負載壓力等功能,大大提高了實驗臺的工作效率、測試精度和智能化水平。
  7. Throttle operating mechanism

    制機構
  8. Test methods for electro - hydraulic proportional bypass flow control valves

    電動液壓比例旁通試驗方法
  9. The meijiayi mjy channels therapeutic apparatus developed by our company, combines the advanced microcomputer technics with the profound traditional chinese medicine methods as well s the human channelss science, magically takes advantages of modern electronic technics and the outer treatment of chinese medicine, realistically simulated the effects like acupuncture, aprapathy, essage, eating, kin scraping and cupping, etc. which improve the comprehensive effects, especially for the common ailments and geriatric diseases in digest digestive system, respiratory system and nervous system

    旋翼式多束濕式基表,雙脈沖采樣方式進行數據採集,採用計算機技術進行數據處理顯示門動作。它採用獨特的卡口安全及保護措施動態安全可靠的ic卡加密機制先進的硬體及軟體的容錯處理性能安全可靠,具有精度高自身功耗低體積小壽命長便於安裝等特點。能準確實現用水計量及實現預付費功能。
  10. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交異步電動機變頻調速技術的發展概況,在回顧電梯液壓制系統節能技術的基礎上,介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能制系統研究」的基本原理,分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式;詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計,重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成組的設計等內容;最後簡單介紹了本課題矢量制變頻制櫃的外部附件電氣接線、計算機制及數據採集系統的硬體設計等內容。
  11. A study of microcomputer - controlled hydraulic digital throttling valve

    單片機制水壓數位元組的設計研究
  12. The system is mainly comprised of a computer, sensors, cable, high pressure oil lines and electromagnetic overflow valve, has both the functions of measuring and control, and is awarded the explosionproof qualification certificate by china classification society

    該系統主要由計算機、傳感器、電纜、高壓油管線和電磁溢等組成,既具有監測功能,又具有制功能,而且取得了中國船級社的防爆合格證書。
  13. Abstract : the transformation of the flowmeter and the control valve for water and oil phase flow, the control devices for oil - water phase ratio and blast hole charge and other control devices has eliminated the distinct dificiencies in the quality control of on - site mixed loading car of emulsified explosive and realized its automatic control so as to improve the quality of the products of emulsion and emulsified explosive and their blasting effect

    文摘:從水相和油相量的量計、制水相油相量的制油相水相配比的配比制裝置、炮孔裝藥量制裝置以及其他制裝置的改造入手,改變原有乳化炸藥現場混裝車質量制上存在的明顯不足之處,實現乳化炸藥現場混裝車的自動制,提高了生產乳膠及乳化炸藥的質量和爆破效果。
  14. Pneumatic fluid power - five - port directional control valves, sizes 18 mm and 26 mm - part 2 : mounting interfaces with optional electrical connector

    氣壓體. 18毫米和26毫米規格的五孔口定向.第2部分:帶光學電接頭的安裝面
  15. Hydraulic fluid power - electrically modulated hydraulic control valves - part 1 : test methods for four - way directional flow control valves

    液壓傳動電調制液壓第1部分:四通方向試驗方法
  16. Hydraulic fluid power - electrically modulated hydraulic control valves - part 2 : test methods for three - way directional flow control valves

    液壓傳動電調制液壓第2部分:三通方向試驗方法
  17. Application of self operated control valve

    自力式的探討
  18. The nonlinear problem is ubiquitous and is difficult to solve in electro - hydraulic servo system. it is caused by the throttling property, because of the existing of the servo valve, proportion valve and throttling valve, by the dead band, the back lash and so on

    非線性是電液伺服系統中普遍存在且至今沒有很好解決的問題,這些非線性主要由電液轉換和制元件(伺服、比例或節)的節特性和液壓動力機構的滯環及死區等因素引起。
  19. The test platform adopts controlled system for silion controlled governing and electrohydraulic proportional relief valve loading to achieve the microcomputer controlled

    實驗臺採用可硅直電機制轉速系統和電液比例溢加載系統來實現被試泵的計算機制。
  20. Each chemical has a station consisting of a feed pump, inductive flow meter and control valve. this ensures the reproducibility of chemical quantities

    每一種化學助劑都有一個工作站,包括有輸液泵、電感式量計、以及,這就保證了助劑用量的再現性。
分享友人