掩模板 的英文怎麼說

中文拼音 [yǎnbǎn]
掩模板 英文
mask plate
  • : 動詞1 (遮蓋; 掩蔽) cover; hide 2 (關; 合) shut; close 3 [方言] (被卡住) get squeezed [pinch...
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : Ⅰ名詞1 (片狀硬物體) board; plank; plate 2 (專指店鋪的門板) shutter 3 [音樂] (打拍子的樂器) ...
  • 模板 : [土] formwork; mould; shuttering; follow board; form board; match board; match plate; mother plat...
  1. Hard surface photomask substrates

    硬面光
  2. Ignored the amplified spontaneous emission ( ase ) and esa, rate equations and propagations equations for continuous wave er ~ ( 3 + ) / yb ~ ( 3 + ) co - doped phosphate glass waveguide laser were calculated using runge - kutta algorithm. propagation characteristics of signal and pump light in the waveguide were analyzed too

    利用fd - bpm法,對在平波導以及波導折射率為漸變折射率分佈的溝道波導和埋型波導內傳播的波長為980nm的泵浦光和1540nm的信號光的光場進行了擬。
  3. This paper focuses on the research of the stress mechanism of the ribbed shell structure in statics, dynamics and under the explosive load on the basis of the engineering practice of cave depot of single aircraft. in this paper, according to the classical shell theories, the basic differential equilibrium of the ribbed shell structure and the finite element analysis of 3d rippled plate are established, in which the function of annular ribs reinforcement bars and 3d ripped steel plates are distributed in the range of the steel, and the functions along the longitude direction of tension, bending, and torsion are neglected ; applied with dynamic analytical theory, the dynamic model of ribbed shell structure and the analytical theory model of elastic - plastic are set up ; the triangle series method is used to solve the displacement and stress under the distributed load and the concentrated load of the ribbed shell structure

    本文以軍用機場地面單機蔽庫工程建設為工程背景,首次對內襯三維波紋鋼混凝土拱型復合結構的受力機理進行了靜力、動力和爆炸荷載的分析研究。根據將橫肋、鋼筋及三維波紋鋼的作用均勻分佈在殼體范圍內的情況,忽略橫肋、鋼筋及三維波紋鋼沿殼體母線方向的抗拉、抗彎及其抗扭作用,首次推導出了內襯三維波紋鋼混凝土殼體的微分平衡方程,建立了有限元計算型,並採用三角函數法,求解了三維波紋鋼混凝土拱型復合結構在分佈荷載和集中荷載作用下的位移響應和應力響應,並與普通殼體進行了比較。
  4. In this paper at last. the localized anti - collapsing effect of the cave depot of single aircraft under the explosive load is calculated and analyzed. the explosive result shows that 3d ripped steel plate and ribbed shell structure are effective to raise the capacity of anti - collapsing of the protective structures

    對飛機單機蔽庫工程在爆炸荷載作用下,抗局部震塌效應進行了計算分析,擬直接命中的爆炸試驗結果表明:鋼筋混凝土內襯三維波紋鋼組成拱型復合結構,是提高防護結構抗震塌破壞的一種十分有效的措施。
  5. Specification for round quartz photomask substrates

    圓形石英玻璃光規范
  6. The control circuit, the core of which is intel 8254 ic was designed. it succeeded in driving xyz spindles, rotatable table and shield plate

    實現了對微動臺xyz軸的精確運動控制、轉臺和旋轉掩模板的轉動控制。
  7. ( 3 ) fabrication methods of planar, y - branches, and channel waveguides employing structure lights formed by cylindrical lenses and optical binary masks are investigated experimentally in detail

    對利用柱透鏡和光學二元掩模板形成的結構光在光折變晶體中寫入平面光波導、 y型光波導以及通道光波導的方法進行了詳細的實驗研究。
  8. The main parts are as follows : 1 ) at the base of the fabrication methods, the photosensitivity of optical fiber and the uv laser sources are introduced simply, the diffraction characteristics of phase mask are analyzed to get the distribution of refractive index in fiber grating, referent the paper [ 4 ] ( delivered )

    全文概括如下: 1 )從常用的製作方法出發,簡單介紹了光纖光敏性和成柵光源,重點分析掩模板的衍射場,從而獲得理想情況下光纖光柵的折射率分佈函數,參考已投論文[ 4 ] 。
  9. Lithograghy and its relative techniques play a very important role in mems fabrication processes, spin coating and baking are an indispensable working procedure before and after the lithography process. oven and hotplate are often employed in order to enhance adhesion between the film and the substrate, stabilize sensitivity of film and improve the abrasion resistance when the film touches a mask in contact exposure

    均膠和烘乾是光刻工藝中不可缺少的一道工序,為增加膠層與矽片表面粘附能力,提高在接觸式曝光中膠層與版接觸時的耐磨性能及穩定膠層的感光靈敏度,通常採用烘箱或熱等加熱設備對光刻膠進行乾燥。
  10. Abstract a polymorphisms single template masking for edge detection algorithm based on clustering was proposed, which could dynamically estimate the edge location of the neighborhood

    摘要提出了一個能夠動態估計鄰域中邊緣位置的基於聚類演算法的多態單邊緣檢測演算法。
分享友人