換位用導線 的英文怎麼說

中文拼音 [huànwèiyòngdǎoxiàn]
換位用導線 英文
transposition wires
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 換位 : conversion; transposition; replacement; trans-situaition; commutant; change of positions
  1. Through the detailed analysis of the aaf, the defection of using chirp - fourier transform in guidance radar signal processing is pointed out

    通過對加速度模糊函數的形態分析也指明了針對線性調頻信號的二次相位匹配處理（ chirp - fourier變換）在應用到制導雷達信號處理中所存在的缺陷。
  2. Abstract : in fourier transform profilometry, because of the nonlinear relationship between the irradiant incident upon a ccd dete ctor andthe voltage it outputs, it will cause phase evaluation errors. here, we ex plain the errorsource by theoretical deducing, then make a simulation. at last, a method to decrease thiserror is put forward

    文摘:在傅里葉變換輪廓術中，由於ccd探測器光電響應的非線性，將在測量中引入高次項，從而對相位的求解造成較大誤差，通過理論的推導定性地解釋了誤差的來由，並用計算機進行了模擬計算，最後提出了減小誤差的方法。
  3. Multiferroelectric magnetoelectri materials have a spontaneous polarization that can be reoriented by an applied electric field, a spontaneous magnetization that can be reoriented by an applied magnetic field. these materials have been exploited as transducer, waveguides, switches, phase inverters, modulators, etc. which also find a lot of technological applications in radioelectronics, optoelectronics, microwave electronics in instrumentation

    這類材料同時具有鐵電和鐵磁材料的性能可以應用到傳感器，波導器件，轉換器，相位倒相器，變頻器，調節器等，在無線電電子學，光電子學，微波電子學等領域的發展具有重要意義。
  4. Methods of measurement for radio transmitters ; part 12 : guideline for drawing up descriptive leaflets for transmitters and transposers for sound and television broadcasting ; specification sheets

    無線電發射機的測量方法.第12部分:音響設備和電視播放設備用發射機和換位器的草擬說明導則.第2節:說明卡
  5. With the development of electronic technology in the field of high - frequency and high - power, power mosfet is gradually enhancing its important status in semiconductor apparatus and is being widely applied in power converters as switch. with the increasing of the operating frequency ( > 200khz ), the energy loss caused by parasitic capacitance will affect the efficiency of power transforming in converters. especially in the applications of high frequency power supply using mosfet as main devices ( the unit of frequency is mhz ), the energy loss caused by the switch process will badly affect its efficiency

    隨著電力電子技術進一步向高頻的大功率用電領域發展，功率mosfet在各種電力半導體器件中的重要地位日益顯著，使用功率mosfet作為開關器件的功率轉換電路也日益增多，但隨著器件開關頻率的提高（大於200khz ） ，由器件極間電容引起的能量損耗將會影響到功率轉換電路的能量傳輸效率，特別是在以mosfet作為開關器件的高頻感應加熱電源中（工作頻率可達兆赫） ， mosfet在開關過程中的能量損耗嚴重影響到電源的效率，因此如何減小開關器件的損耗提高高頻功率轉換線路的效率成為電力電子技術領域的重要研究課題之一。
  6. Application of transposed cable

    換位導線的應用
  7. This production line is specialized in making transposition wire windings of large capacity, high voltage and power saving transformer

    本設備是用於製造大容量高電壓等級節能變壓器換位導線繞組的專用設備。
  8. The characteristics of transposed cable for transformer windings are introduced. some problems in transposed conductor manufacture and application are presented

    摘要介紹了變壓器繞組各種換位導線的特點，並對換位導線製造和應用中的一些問題進行了說明。
  9. The calculation program using the matlab has been worked out to get the numerical solutions of the proposed models. the experiment has first been conducted in the laboratory to get the fundamentals thermal and moisture properties ( such as materials density, specific heat capacity and thermal conductivity ) and also the material moisture absorption isotherms of adobe building materials. the methods of measuring the surface mass transfer coefficient and material moisture content have been proposed

    首次對生土建築材料物性參數進行了實驗測試，得到了常用生土建築材料的密度、比熱和導熱系數等參數值，得到了生土建築圍護結構的等溫吸濕平衡曲線的擬合函數關系式；此外，研究了生土建築圍護結構表面質交換系數實驗測定方法，探索了利用電阻率測量生土建築圍護的安窪築科技人學博十學位論文結構內部含濕量的測試方法。
  10. We encoded and optimized the filter to design the algorithm for filter. computer simulation of complete simulation has demonstrated that the new filtering technique can significantly not only reduce the width relative deviation and the area relative deviation of the image, but also improve the resolution and the focal depth. it provides directive basis for the development of the experiment and the practicability of the technology

    計算機模擬結果表明，通過在非瞳孔面的適當分數傅立葉變換面上加入優化設計的位相型濾波器，可有效減小光刻圖形的線寬偏差和面積偏差，提高成像系統的解析度和焦深，為分數域濾波改善光刻圖形質量實驗的開展和這一解析度增強技術走向實用化提供了指導依據。
  11. Methods of measurement for radio transmitters - guideline for drawing up descriptive leaflets for transmitters and transposers for sound and television broadcasting - characteristics to be specified

    無線電發射的測量方法.第12部分:音響設備和電視播放設備用發射機和換位器的起草說明導則.第1節:規定特性
  12. Methods of measurement for radio transmitters ; part 12 : guideline for drawing up descriptive leaflets for transmitters and transposers for sound and television broadcasting ; characteristics to be specified

    無線電發射機的測量方法.第12部分:音響設備和電視播放設備用發射機和換位器的草擬說明導則.第1節:規定特性
  13. There are different ways to make the bit synchronization, for example : the technique of the pilot frequency, the technique of some change about the baseband signal

    為了保證在同步傳輸系統中的位同步，有導頻及對基帶信號信號直接變換的方式，直接變換的方式中，使用線路編碼是比較常見的。
  14. This paper stated the application of parallel link mechanism in modern machine tools, set up the error analysis as to parallel link mechanism in the virtucal - axis machine tool, derived the double triangular error equations of parallel link mechanicsm in its horizontal posture, analyzed the linearity and non - singularity of the error equations, thus giving the normal splution to the horizontal posture error. the error distribution law is simulated as to the center line in the workplace, and the error distribution curves are drawn as well

    該文對並聯機構在現代機床上的應用作了論述，建立了虛擬軸機床並聯機構的一種誤差分析方法，應用坐標變換原理導出了雙三角並聯機構水平姿態時的誤差方程組；分析了誤差方程組的線性和非奇異性，給出了水平姿態時的位姿誤差正解；對工作空間中心線的誤差分佈規律進行了模擬，繪制了其誤差分佈曲線。
  15. This paper gives a method applying wavelet transformation to get the blocklines, and construct a binary control mask to supervise the phase unwrapping, and phase interpolation procedure

    在這種演算法中，利用小波變換尋找截斷線，有效地標記出極點和截斷線，構造出二元模板指導位相展開。
  16. Moreover, the thesis emphasis on designing the servo system of the stabilized platform and provide the experimental result. combining the requirement and concerned optical mechanism, in the research this paper design the hardware of the servo system and establish the system module on the basis of analyzing control theories and summarizing various control methods. it gives pid rectifying for the velocity inner link and compound control ( forward + feedback ) rectifying for the position link

    在平臺穩定伺服系統研究中，結合相關的光學機械結構，設計了控制系統的硬體，並在此基礎上從控制理論分析入手，在總結了各種控制方法的基礎上，建立了本系統的數學模型，以速度內環採用pid校正，位置環採用前饋+反饋的復合控制方案實現對伺服系統的控制，並經雙線性變換離散化，推導出系統校正的狀態方程。
  17. By the theory of z transformation of linear system and matrix, we proved the validation of the averaging filter method using in ietd to cancel oscillation. then we illustrate the disadvantage of using averaging filter and give a new averaging filter that we note as phase - modified averaging filter, which can reduce the disadvantage. at the end of this chapter, we study the potent of reducing the time - cost of ietd by taking account the short duration characteristics of incident impulse

    本文第二章，首先簡述了時域積分方程遞推解法（ ietd ） ，然後推導了應用於旋轉對稱體的，能夠減少計算量的ietd方法，重點闡述並應用線性系統的z變換理論和矩陣理論研究了ietd方法中遇到的穩定性問題，從理論上證明了平滑濾波技術的有效性，指出了它對計算精度的影響，並在分析的基礎上提出了新的相位修正平滑濾波方法。
分享友人
分享到 Line

分享到臉書