換位線棒 的英文怎麼說

中文拼音 [huànwèixiànbàng]
換位線棒 英文
mixed-strand bar
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 棒 : Ⅰ名詞（棍子） stick; staff; club; cudgel Ⅱ形容詞[口語] （強; 高; 好） strong; excellent; good
  • 換位 : conversion; transposition; replacement; trans-situaition; commutant; change of positions
  1. Analysis and comparison of four transposition methods in the stator bar of hydrogenerator

    水輪發電機定子線棒4種換位的分析與比較
  2. By adopting the traditional way to rebuild the ventilation system is also an effective measure, but the results will not be significant. by changing the transposition of the stator bars in the generators to decrease their maximum temperature has been adopted by some power plants and good economic results have been obtained

    採用傳統的改造發電機通風系統只是有效措施之一，但通常改造的空間不大，在本文中提出改變發電機定子線棒的換位方式以徹底降低線棒溫度，這種方式已被一些水電廠所採用，取得了良好的經濟效果。
  3. Numerous members of the yankees ' roster pledged to wield pink bats on sunday in honor of mother ' s day and breast cancer awareness, but many switched to more familiar lumber following their first plate appearance

    數位洋基先發打線誓言在星期日揮舞著粉紅棒來慶祝母親節，並且來提倡乳癌防治，但是很多人最後都在第一次打席后就換回了熟悉的棒子。
  4. It may lead to 30 ~ 40 temperature difference. in this thesis, various transposition methods are studied and corresponding mathematical models were set up. on this basis, a program of strand current calculation and transposition analysis were made

    本文在研究發電機定子線棒的換位方式的同時，建立了數學模型及相應的泛函表達式，編制相應的換位運行程序對各種換位方式下的電流分佈進行計算。
  5. This measurement system is based on module - design. 3 sets of angle measurement system are used for the receiving and locating, and by using the astigmatism filter, the remained circuit of ccd system transforms the optical signal into electrical signal, and by applying the data acquiring card, adc is used and the data will be preceded by computer. software will be used so that the result will be generated automatically

    由3套角度測量系統分別對測量棒上點光源發出的光信號進行接收與定位，通過濾波消除雜散光的干擾后，角度測量系統中線陣ccd的后續電路將其上記錄的光信號轉變為電信號，然後由數據採集卡進行a / d轉換並送入計算機進行處理，最後通過軟體進行測量結果的顯示。
分享友人
分享到 Line

分享到臉書