換氣通風 的英文怎麼說

中文拼音 [huàntōngfēng]
換氣通風 英文
ventilate
  • : 動詞1. (給人東西同時從他那裡取得別的東西) exchange; barter; trade 2. (變換; 更換) change 3. (兌換) exchange; cash
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 通量詞(用於動作)
  • : Ⅰ名詞1 (空氣流動) wind 2 (風氣; 風俗) practice; atmosphere; custom 3 (景象) scene; view 4 ...
  • 換氣 : 1 (屏氣后再次呼吸) take a breath (in swimming); aeration2 (通風) change of air換氣風扇 scav...
  • 通風 : 1 (使空氣流通) ventilate; air 2 (透氣) be well ventilated 3 (透露消息) divulge information;...
  1. We can use new functions to adjust the casements angle and lead wind to enter ; adjust indoor entered wind quantity and direction

    二利用新功能隨意調整窗扇開啟的角度導入室內。調節室內的進量和方向的目的。
  2. Numerical simulation of airflow in air conditioning rooms with displacement ventilation

    空調房間流組織的數值模擬
  3. The shanghai china rope draft equipment limited company is located shanghai fengxian area shanghai and hangzhou road 3, 352 is specialized devotes to the well ventilated air regenerating device scientific research, the manufacture, the trade to a body joint capital enterprise

    上海華索設備有限公司是一家專業致力於設備科研、製造、貿易於一體的合資企業。
  4. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間次數的增加勢必導致供暖房間能耗加大,頂棚輻射、散熱器和熱等三種採暖方式由於供暖機理不同,形成的室內熱環境特徵不同,時產生的熱損失也有所區別,為了提高大量房間的供暖節能效果,必須對不同供暖方式在大量情況下的熱舒適性與節能效應進行研究。
  5. It becomes a complete ventilation access if has vent - pipe. vent - pipe can discharge all mirage and muddy air out of door, and meanwhile inhales clean and fresh air through gaps of window and door. so the whole bath room will be in a minus - press, and make you feel in distinct and soothing air

    浴霸在裝上管並往室外后,形成了一個完整的路,可以有效地將浴室內的各種霧、濁可靠的排到室外,同時過窗戶、門等縫隙吸入新鮮干凈的空,使整個浴室內處于負壓,讓人能在一個清新的環境中沐浴。
  6. Passages reserved for connecting the engine room to the outside ( e. g., the cooling fan outlet, the exhaust outlet, the ventilation outlet, etc. ) must be designed as muffling passages, whose insertion loss should also be equivalent to the sound insulation amount of the fender structure. only in this way can the environmental noise outside the engine room live up to the standard

    為機房與外界相而預留的道(如冷卻扇出口、發動機排出口、機房口等)必須設計成消聲道,其插入損失也應與圍護結構的隔聲量相當,只有這樣做才可保證機房外的環境噪聲達標。
  7. Takes several energy saving measures for air conditioning system, nick a large capacity centrifugal chillers working with variable frequency nil capacity chillers, variable frequency and variable flow control on secondary pump water systems, cooling tower for four - pipe water system in winter, fan - coil unit for commercial peripheral zones aid all - air systems for interior zones, variable frequency control on supply and exhaust air fain, enthalpy control on fresh air cooling in winter and intermediate season

    採用了多項空調節能措施:大冷量離心冷水機組搭配變頻小冷量機組,二次泵變頻變流量空調水系統,四管制機盤管冬季用冷卻塔冷供冷設計,商業外區機盤管、內區全空空調系統,送機、排機變頻控制,過渡季、冬季利用室外新降溫的焓值控制設計。
  8. If there is no vent - pipe, the most mirage and muddy air that given out by bath king will stay on the ceiling of bath room, and air pressure has not decreased yet, so fresh air can not enter in sufficiently

    如果不接近管或不將往室外,則由浴霸口排出的霧、濁將有絕大部分沉積在浴室吊頂上方。浴室內壓幾乎沒有降低,則新鮮干凈的空就不會充分補充到浴室內。
  9. In this research, through the test in geometric parameter and resistance performance, and comparison between random and other stacked packing, pvc screw thread oblique corrugated plate have more advantage. combined with test and theoretic calculate, determined the heat and mass transfer coefficient, obtained the influence relationship between inlet air flow rate, temperature and humidity, inlet liquid desiccate flow rate, temperature and concentration with outlet air humidity in dehumidifier, provided consideration for equipment design and production

    過對除濕塔的現場測試並結合理論計算,確定其熱質交系數,並分析得出採用pvc螺紋斜波紋板填料的一定結構的除濕塔,處理空量、入口溫度和含濕量及除濕溶液流量、入口溫度和濃度對空出口含濕量的影響關系,為除濕設備的設計和指導生產運行提供參考。
  10. Calculation of ventilating rate and analyses of field measurement for underground garages of civil buildings

    民用建築地下停車庫量計算及現場實測分析
  11. Points out that supplying fresh air is not sufficient in decreasing indoor air pollution and good ventilation is the pivotal guarantee in improving indoor air quality

    過實驗分析和對比,指出新量不能從根本上降低室內污染物濃度,良好的是提高室內空質量的有效保證。
  12. The result showed that the contamination situation in the lower zone of the office, i. e. the zone of occupants, was affected by of that of supply air. the supply air contamination should be kept to a low level in order to provide a good indoor air quality. however, the variation of the supply pollutant concentration has no influence on the indoor contaminant distribution of such system

    本文針對態污染物,研究了不同送濃度對系統的影響,結果表明:置房間的下部區域受送污染物濃度的影響較大,人的工作區恰好處于該區,實踐中需要控制好送濃度以保證人呼吸區的空品質;但是送濃度的變化並不影響置下污染物的分層分佈的特點。
  13. The insulation and the thermal mass, coupled with the gains from the conservatory and the buffering effect of the earth sheltering provide comfortable conditions

    一個熱交系統利用高效的12伏直流電扇來保證往每個房間的流,而近可能地減少其熱量損失。
  14. The results showed that the best method was : covered plastic film and added grass - shade, exchanged the air twice a day

    結果表明:以覆塑料膜加蓋草簾子,每天2次這種方法最好。
  15. Replacement of high voltage switchboards, transformers and low voltage system of the tunnel power supply system in lion rock tunnel, replacement of field equipment of toll collection system in cross - harbour tunnel and replacement of ventilation control panels, exhaust fans, motors and flexible connectors in aberdeen tunnel

    獅子山隧道供電系統的高壓配電板變壓器和低電壓系統更海底隧道車輛繳費系統的路面設備及更香港仔隧道的控制屏抽扇電動機和軟接頭
  16. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的熱負荷;增加輻射管的熱面積;修正煙囪高度;用新型燃燒器,變自然為強制供,以增大燃燒器的發熱量,減小過剩空系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空預熱器以提高空入爐溫度;採用高溫輻射塗料增強輻射熱效果,從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  17. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的熱負荷;增加輻射管的熱面積;修正煙囪高度;用新型燃燒器,變自然為強制供,以增大燃燒器的發熱量,減小過剩空系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空預熱器以提高空入爐溫度;採用高溫輻射塗料增強輻射熱效果,從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  18. Displacement ventilation also has higher energy using ration than other supply air systems, ie it has higher temperature effectiveness, and that displacement ventilation system always has part quantity of heat lying upside area of room, air supply outlet lies at low side, supply air direct come into workaround, and only absorb heat and humid of workaround, assure satisfaction of the design conditions of workaround

    對于置其節能性也優于其它的送方式,即其溫度效率高,而且置總有部分熱量處于房間上部區域,送口設在低部,送入空直接進入工作區,只是吸收了工作區的熱、濕量,保證工作區的象參數滿足要求。
  19. Research on displacement ventilation of indoor air quality and saving energy

    條件下室內空品質研究
  20. Since the 1980s, with the developing of air - condition technology, men begin thinking much of room condition quality, displacement ventilation has been given a good favour for its higher ventilation effectiveness and air exchange efficiency

    二十世紀八十年代以來,空調技術的發展開始對室內環境質量有了足夠的重視,置因其較高的效率和效率而受到人們的青睞。
分享友人