換算系數 的英文怎麼說
中文拼音 [huànsuànxìshǔ]
換算系數
英文
coefficient of conversion- 換 : 動詞1. (給人東西同時從他那裡取得別的東西) exchange; barter; trade 2. (變換; 更換) change 3. (兌換) exchange; cash
- 算 : Ⅰ動詞1 (計算數目) calculate; reckon; compute; figure 2 (計算進去) include; count 3 (謀劃;計...
- 系 : 系動詞(打結; 扣) tie; fasten; do up; button up
- 數 : 數副詞(屢次) frequently; repeatedly
- 換算 : [數學] matrixing; scaler; conversion; convert; translation換算表 conversion table; equivalent tab...
- 系數 : [數學] coefficient; ratio; modulus; quotient; factor
-
A novel communication receiver which uses lapped transform ( lt ) incorporating modified median filter ( mmf ) algorithm is designed for narrow - band interference excision. the lt domain mmf algorithm takes full advantages of the direct sequence spread spectrum signal, as well as the characteristics of lt, performing the transform domain filtering twice. the first filtering locates the position of interference and mitigates most of them. the second filtering is performed in a small neighborhood of the located interference. so lt domain mmf algorithm can completely mitigate the interference without distorting the desired signal. simulation results demonstrate the improved ber performance and increased robustness of our receiver
本文採用改進的重疊變換域中值濾波演算法進行變換域抗干擾處理.該演算法既考慮到直接序列擴頻信號的特點,同時又利用重疊變換的特性對變換域系數進行了二次濾波.該演算法節省處理時間,並且不需要有關干擾的先驗知識,系統性能不會隨干擾頻率變化而變化,因而是一種很穩健的處理方法Calculation method of heat transfer coefficient of air - side heat exchanger of air source heat pump water chiller heater
空氣源熱泵冷熱水機組空氣側換熱器換熱系數的計算方法Time scale factor
時標換算系數Axial load composed of five main kinds of vehicles was gained by eye - observing, and then the mean exchange coefficients of each kind of vehicles and equivalent standard axle load were obtained
利用目測法得到各類車輛軸載組成,通過分析得到各類車輛平均軸載換算系數,然後求得標準軸載作用次數,採用空間換時間方法,最後建立了四個地區不同交通量等級下的路面使用性能預測方程。A calculation model of the coefficient of heat transfer between gas and stave body and inlaid refractory is built based on the substitution method of boundary condition
摘要基於邊界條件替換方法建立了高爐冷卻壁本體和搗打料與爐氣之間的換熱系數計算模型。A series of tests on centrifugal oil pumps with different specific speeds were done under different conditions of liquid viscosities and pump rotary speeds
摘要用比轉速為66 , 90 , 105的離心泵在不同粘度、不同轉速下進行了一系列試驗,提出了一種新的油泵液體粘度換算方法,該方法考慮了轉速對換算系數的影響。The heat transfer coefficient at the gas temperature ranging from 500 to 1248 between stave and furnace gas is determined by the combination of calculation model of temperature field and the temperature value of hot surface calculated from the temperature measured near hot surface
用試驗測量冷卻壁近熱面溫度來推算冷卻壁熱面溫度,與冷卻壁溫度場計算模型結合,確定了爐氣溫度在500 ~ 1248范圍內,高爐冷卻壁與爐氣之間的換熱系數。Based on the analysis and calculation of ship resistance, according to the main factors influencing the resistance, such as sailing speed, water depth and ship draft ratio, and coefficient of sectional form, the deepwater, shallow water and restricted channel are defined by the coefficient factor
摘要通過對船舶阻力的分析和計算,根據影響阻力的主要因素,航速、水深與船吃水比、斷面系數,由換算系數來界定深水、淺水與限制性航道。Standard practice for units of measurement and conversion factors for pulp, paper, and paperboard
紙漿紙張和紙板用測量單位和換算系數Firstly, for jet array impingement cooling, the effects of the distance of adjacent holes, the impinging distance and jet reynolds number on heat transfer characteristic at the target wall are summarized under staggered holes arrangement and the same hole diameter. and then, the numerical simulation of inclined multi - hole film cooling has been studied. the influence factors examined in this case include blowing ratio and the distance of adjacent holes
首先通過對射流沖擊冷卻方式的研究,分析了相鄰孔間距、沖擊間距以及射流入口雷諾數對沖擊靶面換熱系數的影響情況,然後對多斜孔冷卻方式進行了數值模擬,重點探討了吹風比和相鄰孔間距對絕熱溫比與壁面換熱系數的影響規律,最後,針對沖擊-發散復合冷卻流場的計算物理模型,研究吹風比、相鄰孔間距的變化對沖擊-發散復合冷卻流動與傳熱特性的影響。Normally, coefficient of convective heat transfer is gotten through experiments which is heating testing tube by electricity and computed through newton cooling law
通常,對流換熱系數是在實驗中以電加熱試驗管壁面后根據牛頓冷卻定律計算得來的。According to the fatigue equation of lean concrete, coefficient of axle load conversion of lean concrete is put forward
根據貧混凝土的疲勞方程,推導出貧混凝土的軸載換算系數。In this paper, the pce principle, method and technical achievement of traffic engineering in domestic and overseas from 1940 to 1993 are analyzed, compared and evaluated. moreover, the use condition and limitation of the studying achievement are elaborated. based on it, in view of the complexity of the vehicle kinds and mixed traffic in domestic highway traffic, the physics method on influence space of vehicle is put forward according to the achievement of studying the road capacity and the mass traffic observation data of 177 section of highway
本文首先對1940到1993年以來,國內外在交通工程研究中涉及到的車輛當量換算系數計算的原理、方法和技術成果進行了分析、比較和評價,闡述了這些研究結果的使用條件和局限性。在此基礎上,鑒於我國公路交通中車種多,車型復雜以及混合交通等的特點,通過對我們以前研究通行能力積累的成果和實地177個不同路段所採集到的大量交通觀測數據的分析和研究,利用數理統計和隨機場理論,提出了一種汽車道路作用空間的物理分析方法來研究車輛當量換算問題。Study of bicycle conversion coefficient on urban road section
城市道路路段自行車換算系數研究Mass energy conversion coefficient
質量能量換算系數Volume conversion coefficient
容積換算系數Power cables - part 1000 : current - carrying capacity, general, conversion factors
電力電纜.第1000部分:電流負載容量總則換算系數Scaling factor applied to all values in the texture. the valid range is 0 to ?. the range is 0 to 1. the default is 1
應用於紋理所有值的換算系數.有效的范圍是0到? .范圍是0到1 .預設值是1Characteristics of electro - optical x - ray image intensifiers for medical electrical equipment - determination of the conversion factor
醫療電氣設備用光電x射線圖像增強器的特性.換算系數的測定By analyzed a number of experiment, the criterion to define type of vehicles, the side and vertical direction feature to road place occupied by vehicles which are traveling as well as the fixed quantity to describe the relationship to each other are determined. at last, the pce of different traveling conditions are also put forward
最後,通過大量實驗分析,研究確定了車輛的分型標準、汽車在運行過程中道路作用空間的側向和縱向特性及其相互關系的定量數值,推算出了基於不同交通運行條件下的車輛當量換算系數。分享友人