換置法 的英文怎麼說

中文拼音 [huànzhìfǎ]
換置法 英文
hypallage
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. Secondly, programmed the image processing arithmetic code which include the bottom arithmetic for the general condition comprises threshold division, region combination and informate and the middle level arithmetic for the given task comprises detecting the line dation creirection according to the hough transform in order to fix on the hole ’ s azimuth angle, detecting the aiguille tip position according to the image movement according to the environment and the image format

    然後，根據目標環境要求和攝像機採集圖像格式，開發了圖像處理演算法程序。圖像處理演算法包括底層演算法和中層演算法兩部分，底層演算法針對通用情況，包括閾值分割、區域合併和信息生成。中層演算法針對具體任務設計，包括利用hough變換檢測棱線的方向，從而確定圓孔的方位角和利用基於圖像運動檢測鉆頭尖端位置。
  2. Disposes the switch in the network is decided to the network performance improvement by the network analysis situs and the size, and the serviceable wave length number and uses rwa algorithm

    在網路中配置轉換器對網路性能的改善取決于網路拓撲和大小，及可用波長數和所用的rwa演算法。
  3. Multiplication of permutations, unlike multiplication of numbers, is not always commutative.

    置換的乘法不同於數的乘法，它並不一定滿足交換律。
  4. Azeotropic distillation stage and dehydration with alcohols can prepare nanocry stalline powders with extremely small crystallite size ( 40nm )

    共沸蒸餾乾燥法和無水乙醇置換乾燥法均能制備50nmal _ 2o _ 3粉體。
  5. So the electrode boundary - displaced csm is brought forward to settle the problem in the paper

    為此，本文提出採用電極邊界置換法來對此問題加以解決。
  6. Fourth, the paper treats two kinds of hoisting projects of high alititude construction in bulk and member assembly, hositing machine and plan layout, setting up scaffold and joints, and installing trunks, branches and joints etc. then in detail discusses the method which applys total station to measure three - dimensional coordinate of dendriform structure, including selecting survey sign points, creating survey system and converting survey coordinate system etc. the paper also deep research on the welding performance, welding method, welding process, welding stress and control, welding strain and rectification, weld defects analysis and weld quality inspection, and so on complicated heterogeneity steel weld proplems

    接著系統的論述了高空散裝法和分單元安裝法兩種樹狀結構吊裝方案，樹狀結構吊裝機械及平面布置，樹狀結構胎架及節點的搭設，以及樹狀結構樹干、樹枝和節點的吊裝工藝等諸多工藝問題。詳細的論述了採用全站儀對樹狀結構進行空間三維坐標測量的方法，包括測量標志點的選取、測量系統的建立及測量坐標的轉換等問題。深入地研究了樹狀結構可焊性、焊接方法、焊接工藝、焊接應力及控制、焊接變形及矯正、焊接缺陷分析及焊接質量檢查等復雜的異種鋼焊接問題。
  7. A new fractal - based infrared image feature extraction method is presented and the detailed theoretic analysis and implement procedure of this algorithm is submitted and tested in some experiments. with the limitation of the line detection based on traditional hough transform that the information of the length and the end points of the line is unavailable, a new algorithm which makes use of the accessional strategy based on precognition information is put forward to meet the demand for more information of the line, simulation results show this method is effective. finally, the whole process of airport target recognition is presented and the result images are also given

    使用分形方法提取目標的特徵，在知識指導下，提出了一種基於目標特徵模型的降維的形態學分形維數計算方法，對傳統分形方法進行了改進，從理論上推證了演算法的合理性，並對演算法進行了模擬分析；針對傳統hough變換無法獲得線段端點和長度信息的局限性，提出了一種基於目標特徵先驗知識的hough變換融合策略，通過引入目標先驗知識，可以有效地獲得直線信息；對信息多而復雜的機場目標採用基於知識的目標識別方法，使用置信度模摘要型實現不確定推理，對目標進行識別判斷，將知識貫穿于整個識別過程中，對目標進行了有效地識別。
  8. Method of cleaning long compressed - gas pipe line between zhengzhou and yima

    鄭州煤氣長輸管道的通球清管置換方法
  9. Compared with currently fire control system, apsse has such characteristic as : highly precision, complex construction, high technique, etc. so this thesis expatiated in detail on the measuring theory of apsse, emphases on the discussion of system error and random error of apsse, deduced the three axis error of apsse usign the coordination transformation methods, provided the applying base for the measuring error equation of apsse. in this paper, we emphases on expatiating the basic theory of usign space coordination transformation in the measuring error equation of apsse

    因此，論文採用了空間坐標變換方法分析機載光電跟蹤測量設備在對目標進行測量、定位時空間坐標轉換關系，推導出從中心地平坐標繫到目標坐標系的變換矩陣，在此基礎上首先建立機載光電跟蹤測量設備的無測量誤差的位置傳遞方程和機載光電跟蹤測量設備的含有測量誤差的位置傳遞方程，為利用蒙特卡洛法分析機載光電跟蹤測量設備的測量誤差奠定了理論基礎。
  10. Plasma characteristics of a rf ion source are investigated by emission spectroscopy. the spatiotemporal spectral line intensities of the first three atomic lines in hydrogen bahner series ( = 656. 28, 486. 13, 434. 05nm ) of rf ion source plasma, are measured with calibrated optical multichannel analyzer ( oma ). some plasma parameters, including electron temperature, hydrogen atom density and hydrogen ion density, are calculated and analyzed using partial local thermodynamic equilibrium ( plte ) theory and abel transform

    實驗採用絕對定標后的光學多道分析系統（ oma ）測定了離子源等離子體不同時間和空間位置的氫原子巴耳末譜線系中前三條譜線（ = 656 . 28 ， 486 . 13 ， 434 . 05nm ）的強度，並採用plte的理論和abel變換方法，計算出了高頻離子源等離子體的電子溫度、氫原子濃度、氫離子濃度等參數在放電的不同階段和徑向分佈情況，並進行了簡要分析。
  11. The main achievements of the thesis are as follows : ( 1 ) kinds of techniques to detect magnetizing inrush of traction transformers are thoroughly investigated in this paper, and their limitation are indicated and corresponding improvement techniques are proposed. ( 2 ) in this paper, flux linkage equilibriun equations are used to build " ash - box " models of some traction transformers based on system identification, such as two - winding single - phase traction transformer, impedance - matching equilibriun traction transformer and scott traction transformer

    論文的主要內容有： （ 1 ）詳盡分析了現有的針對牽引變壓器勵磁涌流演算法的保護演算法，提出了每種演算法的局限性及其改進方法； （ 2 ）提出適用於鐵道電氣化系統中各種牽引變壓器對應的三?二相轉換規則，利用該規則可將對應量的轉換置於保護軟體中，從而可大大減輕在牽引變壓器兩端外部復雜的接線。
  12. It will describe the general aspects of the network, the replacing steps, equipment used, construction organization and management and safety measures

    從管網工程概況、氣體置換方法步驟、所用設備、施工組織管理以及安全措施等方面進行了全面介紹。
  13. Because of its characteristics of simple structure, low cost and space economy, macpherson suspension has become the most popular independent suspension since its emergence. hence, the kinematic analysis of macpherson suspension has great significance. in this paper, the dimensional positions of points on the left macpherson suspension while the front left wheel turns and jumps are calculated with the method of dimensional coordinate transformation

    本文通過研究用於轉向車輪的麥弗遜式懸架的結構特點和運動特性，採用空間坐標變換方法，準確計算出前轉向車輪在轉向和跳動情況時麥弗遜式懸架上點的空間位置，建立了轉向車輪麥弗遜式懸架在車輪轉向和跳動時的物理模型和數學模型。
  14. In the paper, firstly, the tache of position ' s check has been discussed, then the measuring theory and transition of signal for encoder, which is a high precision measurement are described and the interpolator circuitry is also put forward

    文中首先對測控系統的位置檢測環節進行了論述，討論了高精度的檢測元件? ?光柵的測量原理及其信號轉換方法，並設計了細分介面電路。
  15. The visual basic stop statement provides a programmatic alternative to setting a breakpoint

    Visual basic stop語句提供了一種以編程方式設置斷點的替換方法。
  16. Jacobi transformation is used to find correlations among coefficients. then a method to transform general quadratic surface to formal quadratic surface equation is introduced. the location, direction and size of quadratic surface are obtained

    論述了運用jacobi變換方法來處理系數相關性問題，實現了二次曲面的一般方程的求取，並探討了將通用系數形式轉化為標準二次曲面方程的方法，從而求得二次曲面在空間的位置、方向和大小。
  17. Prior to the vector construction, the availability of gene replacement was extensively tested in streptomyces. sp. fr - 008

    在載體構建之前，我們先在鏈黴菌fr - 008中驗證了基因置換方法的可行性。
  18. In this paper, a 3d finite element analysis software ( fzfx3d ) was compiled to simulate the construction process of mass concrete structures constructed with sequence method. based on the practical project xiluodu arch dam, the dam ' s construction process was simulated by a small time step size, 0. 5 or 1 days. the environmental temperature change, hydration heat rise, artificial cooling, creep, volume deformatio

    運用laplace變換方法將溫度的求解表示為只與空間坐標及澆築時間有關的函數，從而避免了用隱式差分法、有限元法求解時需求解聯立方程的因而對測點選擇的依賴，也避免了顯式差分法求解穩定性受時間步長，測點間距大小限制的缺點，因而具有測點布置靈活的特點。
  19. Two methods of designing the switching function are presented : the pole setting and the quadratic form optimization. tendency ration strategy is presented to eliminate chattering

    在設計切換函數時，作者採用極點配置法和二次型指標最優法兩種方法來設計。
  20. Methods clinical data of 100 children with chronic rhinosinusitis receiving nasal cavity replacement therapy, antral lavage through natural ostium and functional endoscopic sinus surgery were analyzed retrospectively

    方法回顧性分析我院收治的100例小兒鼻竇炎，根據患兒不同情況採用藥物鼻腔置換療法、鼻內鏡引導上頜竇自然開口置管沖洗及鼻內鏡下功能性鼻竇手術治療的療效。
分享友人
分享到 Line

分享到臉書