摩擦坡度 的英文怎麼說

中文拼音 [mócāpōdù]
摩擦坡度 英文
friction slope
  • 摩 : 摩構詞成分。
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 坡 : Ⅰ名詞（地面傾斜的地方） slope Ⅱ形容詞（傾斜） sloping; slanting
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 摩擦 : 1 （互相接觸的兩物體作來回相對運動） rub; chafe 2 [物理學] （相互接觸的兩物體在接觸面上發生阻礙相...
  • 坡度 : falling gradient; slope; inclination; declivity; pitch; batter
  1. The slope stability question is influenced by many kinds of inherent factors, for instance geological structure, intensity of rock body, development state of joint and crack, cohesive force ( c ) of the rock, interior angle of friction ( f ), groundwater, etc., these objective factors reflect generally their sizes with some quantitative parameter indexes in the past

    邊坡穩定問題受多種內在因素影響，如地質構造、巖體強度、節理裂隙發育狀況、巖石的內聚力（ c ） 、內摩擦角（ ） 、地下水等，這些客觀因素過去一般用某些定量參數指標來反映其大小。
  2. Vetiver grass is found to increase adhesion and internal friction angle, enhance shear strength and improve soil stability

    通過試驗分析發現，香根草護坡可以提高土的黏聚力和內摩擦角，從而提高土的抗剪強度，進而增加土壤穩定性。
  3. The studied factors respectively are : length of soil nailing, insert deepness of piles, friction force of soil nailing interface, declination angle of soil nailing, horizontal spacing of soil nailing, rows of soil nailing, unit weight of soil, friction angle, unit cohesion, overload of slope, diameter of soil nailing

    這11個因素分別為：土釘（錨管）長度、土釘直徑、土釘界面摩擦力、土釘下傾角、土釘水平間距、土釘排數、土體重度、內摩擦角、粘聚力、坡頂超載、板樁插入深度。
  4. In this paper, a numerical simulation is conducted, which is based on the test data of the model experiment of sloping ground with the help of the marc program. when the bearing capacity characters of level ground and the foundations adjacent to or above slopes are analyzed, the effect is considered, which includes deformation moduli, density, poisson ratio, angle of internal friction, stress - strain relationship, slope angle, relative distance from the edge of slopes and relative depth of footings

    本文利用斜坡地基模型試驗的試驗數據，用marc軟體進行了斜坡地基模型試驗的數值模擬，分析了平地地基、臨坡地基和斜坡地基的承載力特性，研究了變形模量、容重、泊松比、內摩擦角、應力應變特性、斜坡坡度、基礎的相對坡頂距及其相對埋深等因素對斜坡地基承載力性能的影響。
  5. If the planar failure arises without fixed plane in rock slope, the critical inclination of failure face is not only the function of slope angle and friction angle of failure face, but also the function of the height of failure part, the cohesion of failure face, and unit weight of failure body

    摘要在巖石邊坡中，當出現平面滑坡時，如果邊坡內沒有確定的滑面，滑面的臨界傾角不僅僅是邊坡傾角和破壞面摩擦角的函數，而且還應該是滑體高度、破壞面的黏聚力和巖體重度的函數。
  6. According to deduction and calculation the critical inclination of failure face has a linear relation with the slope angle, a quadratic function relation with the friction angle of failure face, a logarithmic relation with the height of failure part, a negative exponent relation with the cohesion of failure face, and a quadratic function relation with the unit weight of failure body

    通過推導和計算得知，滑面的臨界傾角與邊坡傾角呈線性關系，與破壞面摩擦角呈二次函數關系，與滑體高度呈對數關系，與破壞面的黏聚力呈負指數關系，與巖體重度呈二次函數關系。
  7. Analysis of the inter - velution ship and its influence factor between loess landslide slope failure and charecterisitics of soil and rock mass show that the range of landslide slope failure enlarges with the development of earthquake intensity, coeffient of pore pressure and cohession. it delarges with the development of angle of internal friction ; use simplicity bishop method and computer to get simplicitely and quickly usable stability anlytic figures and data table

    分析黃土滑坡與巖性的內在關系及其影響因素表明，滑坡范圍隨地震烈度、孔隙水壓力系數、粘聚力的增大而增大，隨土體內摩擦角的增大而減小;採用簡化畢消普法，藉助計算機，獲得了簡捷明快、使用方便的穩定分析圖表。
  8. A solid - waste containment system can be simplified as a slope which contains a layer of geomembrane ( which is simplified as interlayer slope in the rest part ). shaking table model test and numerical analysis have been done to study the seismic stability of interlayer slope based on the two - part wedge theory in this paper. many factors which affect the slope stability ratio, including horizontal seismic coefficient, slope angle, soil - geomembrane interaction coefficient, slope length, layer thickness and soil character, have been took into consideration

    填埋場防滲基坑的邊坡可以簡化成含土工膜夾層的土坡（以下簡稱夾層土坡） ，本文根據「雙滑楔體」理論思想，對夾層土坡的地震穩定性問題進行了較為系統的模型試驗和數值分析，著重考慮了水平地震系數、夾層土坡坡角、土工膜與覆蓋層土體摩擦系數、夾層邊坡長度和厚度、夾層土坡覆蓋層土體性質等因素對土坡安全系數的影響，並對地震作用下夾層土坡的永久變形進行了初步的研究，給出了對實際工程設計有參考價值的結論。
  9. With the help of this program, this paper does research on the moved backwards of the slide surface, lengthening the anchor section, the soil nail ' s total force, gets conclusion about relations between the soil nail ' s length and the slope ' s grade, height, soil ' s mechanical parameter ; relations between soil nail ' s total force and coulomb soil pressure. with the help of the large multiuse finite element program ansys, this paper analyzes the soil nailing in one - step ' s slopes, in two - steps " slopes, puts the emphasis on the axis force ' s distributing along the soil nail at each rows, the effect of both the excavating mode and the original slope figure to the axis force of the soil nail, the one another effect between the upper - step slope and the nether - step slope in the soil nail ' s axis force, gets conclusion about the design of soil nail at the first low, different slope body is the same with different excavating mode, the original slope figure has more effect to some than others because of the slope body, the reasonably design of the step width in two - steps slopes, the two - steps excavating and retaining has more virtue than the one - step ' s. through soil pressure analysis this paper does research on the differences and the links between the coulomb soil pressure theory and the rankin ' s, the vertical pressure at the slope surface when the slope surface is inclined and the retaining wall is rough, the soil pressure ' s distributing behind the panel, gets conclusion about the effect of both the slope body inner stability and the slope surface local stability to the soil pressure

    通過分析比較，論證了對數螺旋線型比圓弧形作為邊坡的假設滑裂面具有較多的工程優點，並為此編制了一個採用極限平衡法分析土釘支護的fortran語言程序，以此作工具對滑裂面的后移、土釘錨固段的超長、土釘總力的大小等方面作了研究，得出了有關土釘的長度與邊坡的坡角、坡高、土體力學參數的關系、土釘總力與庫侖土壓力間的關系等結論；採用大型通用有限元數值分析程序ansys分別對採用土釘支護的一階邊坡、二階邊坡進行分析，重點是研究各排土釘的軸力分佈規律、開挖方式及原始邊坡形態對土釘的軸力的影響、上下階邊坡在土釘軸力方面的相互作用，得出了有關第一排土釘的設計問題、不同類型的土體應適用於特定的開挖方式、原始開挖出的邊坡形態對一些類型坡體的邊坡土釘支護有較大的影響而對另外一些影響不大、二階邊坡臺階寬度的合理確定、二階開挖及支護比一階時具有較多的工程優點等結論；通過土壓力分析對朗肯、庫侖兩種經典土壓力理論的區別與聯系、坡面傾斜及墻背有摩擦時的坡面豎向應力分佈、面板背土壓力的分佈形態作了研究，得出了邊坡支擋土壓力受坡體內部穩定與坡面局部穩定兩個方面的影響、土釘支護面板背土體中卸荷拱的存在對面板受力有利等結論。
  10. Some results have been shown as follows : 1. some main factors to rock slope stability were analyzed by sensibility analysis. the conclusions are shown that earthquake has a most influence on its stability, cohesion c and friction angle in the next one, groundwater level h in the third, and density p of rock masses and height h of slope minimal

    通過對影響巖質高邊坡穩定性的主要因素進行敏感性分析，表明：地震作用對邊坡安全性的影響最大；滑動畫內聚力c和內摩擦角對安全系數k值的影響次之；地下水位高度h對安全系數有一定的影響；而坡體密度和高度h對邊坡安全性的影響相對較小，有時可以不予考慮。
  11. At first it analyzes the bedding rock slope ' s bedded rock and its incontinuity face, and studies the stress, strain, stability ' s condition of the bedding rock slope, fully considering the cohesive force of rock layer and incontinuity face. geologic mechanics models of two types of bedding rock slope are set up, the instability coefficient of bedding rock slope under different mechanical parameters is computed, and the conclusion that the stability of bedding rock slope is relation to rock layerer, cohesive force of incontinuity face, inner friction angle and rock layer obliquity has been gotten. based on the above discussion, the thesis comes down the influence of rock layer and the incontinuity face on the bedding rock slope to incontinuity face ' s influence factors, and discusses other factors that influence the bedding rock slope ' s stability, so gains the evaluating and forecasting index marks

    本文首先對順層邊坡的層狀巖體及其中的層理面和不連續面進行了分析，對其應力應變進行了研究，得出了順層邊坡的穩定性不僅與巖體中巖石的強度有關，還與巖體中層理面及不連續面的內聚力、內摩擦角及其傾角有關；論文建立了層理面和節理面的地質力學模型，討論了其力學參數變化對邊坡穩定性的影響，並在此基礎上將層理面和節理面歸納為順層邊坡穩定性的結構面影響因素，同時討論了影響順層邊坡穩定性的其他因素，從而得出順層邊坡穩定性的評價預測指標。
  12. Because the friction force mainly influences the track precision and the orientation precision of the servo system, it should consider these two targets changes between before and after compensation. low - velocity ramp signal and step signal were chosen as simulation test signal

    由於摩擦力主要影響電液位置伺服系統的低速跟蹤精度和定位精度（即穩態誤差） ，所以要考慮補償前後這兩個指標的變化情況，模擬測試信號選為低速斜坡信號和單位階躍信號。
分享友人
分享到 Line

分享到臉書