摩擦磨損 的英文怎麼說

中文拼音 [mócāmósǔn]
摩擦磨損 英文
fretting wear
  • 摩 : 摩構詞成分。
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 摩擦 : 1 （互相接觸的兩物體作來回相對運動） rub; chafe 2 [物理學] （相互接觸的兩物體在接觸面上發生阻礙相...
  • 磨損 : wear and tear; abrasive wear; abrase; abrade; detrition; wear; scuff; wear out; fray; battering; ...
  1. Effect of antifriction on friction and wear properties of resin - based composite

    減摩組元對樹脂基閘片摩擦磨損性能的影響
  2. Influence of 19cn5 and 20crmnmo sulfurized after cementite on anti - freting performance

    鋼滲碳后硫化對摩擦磨損性能的影響
  3. In this dissertation, al - si / sicp composites brake rotor with diameter of 1200mm was firstly fabricated by a novel spray deposition technology, and simultaneously coupled brake pad was prepared by a novel dry - powder processing route, termed as two - step pressing process. a wedge pressing technology was developed to densify the as - produce al - si / sicp composite brake rotor

    本文首次採用噴射沉積技術制備了直徑達1200mm的al - si / sicp制動盤，同時採用二次壓制工藝制備出了配套的合成閘片，研究了制動盤的楔壓緻密化技術、機理，復合材料摩擦磨損性能及機理。
  4. The result of those studies as follow : ( 1 ) an composite layer of definite thickness on the casting was gained by cast - sintering technique, and it has well wear - resistance. ( 2 ) the reinforcement of the composite layer is tic or vc, which was exiguous and is well distributed

    同時利用干滑動摩擦磨損實驗，對表面復合層的耐干滑動摩擦磨損的性能進行了研究。研究表明： （ 1 ）利用鑄造燒結技術可以在鑄件表面獲得一定厚度耐磨性能良好的表面復合層。
  5. Wear resistance of q235 steel surface mo - cr alloy layer by double glow discharge technology

    235鋼表面雙層輝光離子強化層摩擦磨損性能
  6. Study on the tribological behavior of monel alloy

    航用蒙乃爾合金摩擦磨損特性的研究
  7. Simultaneity the friction mechanism was investigated based on the surface morphology inspected by sem

    運用sem觀測磨損表面形貌，探討摩擦磨損機理。
  8. Study of intelligent testing system of mhk - 500 ring - block tribometer

    500環塊摩擦磨損試驗機智能測控系統的研製
  9. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  10. 1. 5 m in diameter ) were dispersed in n46 engine oil with different concentrations using ultrasonic respectively in order to study their tribological properties. the tribological experiments were carried out by mq - 800 four - ball tribometer and mm - 200 ring - on - block tribometer, in which extreme pressure properties, wear scan diameter, friction coefficient and wear volume loss were measured. the results showed that oil containing mos2 nanoparticles had a better wear resistance, friction - reducing and extreme pressure than the oil containing common mos2

    將上述制備得到的納米二硫化鉬顆粒和普通二硫化鉬粉末（ 1 . 5 m ）以不同濃度分散在n46機械油中，在mq - 800四球摩擦磨損試驗機上考察它們的最大無卡咬負荷（ p _ b值） 、耐磨性能和摩擦系數；並在mm - 200摩擦磨損試驗機上，通過環?塊摩擦副，比較和分析了它們的摩擦學特性。
  11. We also studied the dynamic characteristics of cf / cu ( c ) - cu composites, the results show that, by the method of graphite is coated with copper, the coefficient of friction and the wear rates remarkably decreased. with the increase of the copper coated carbon fiber content, the wear rates of cf / cu ( c ) - cu composites is notably decreased, while the coefficient of friction is increased. with the increase of electric current density, the wear rate of cf / cu ( c ) - cu composites is increased

    研究發現，碳纖維鍍銅石墨-銅復合材料的電摩擦磨損性能與碳纖維含量存在一最佳值，當碳纖維含量為0 . 6時，其電摩擦磨損性能最好；對于不同電流密度下的電磨損性能的比較可以發現，通電磨損時的電摩擦系數要小於機械磨損時的摩擦系數，碳纖維鍍銅石墨-銅復合材料的電摩擦系數隨電流密度增大先減小而後增大，在電流密度為15a cm ~ 2時達到最小值；通電磨損量要遠大於機械磨損量，且隨著電流密度增大，磨損量增加。
  12. Gas permeability tester and mechanical folding device were developed to study the barrier property and deformation failure behaviors. the surface characterization, chemical structure, optical, mechanical properties of pet coated with dlc have been investigated by x - ray photoelectron spectroscopy ( xps ), contact angle measurement, light transmission analysis, nanoindentation and friction wear tests

    通過x射線光電子譜分析、接觸角測定、光學透過率分析、納米壓痕、摩擦磨損試驗、機械彎折試驗、氣體透過率試驗，對膜層的表面特徵，光學、力學及氣體阻隔性能進行了系統的研究。
  13. Friction and wear performance on fretting wear of steel wires in hoisting ropes

    提升鋼絲繩的鋼絲微動摩擦磨損特性研究
  14. Test method for friction and wear of plastics by sliding

    塑料滑動摩擦磨損試驗方法
  15. Friction and wear behavior of varied ti3sic2 material

    2的摩擦磨損行為
  16. Friction and wear of si3n4 ceramics against cast iron under emulsion

    4間配副的摩擦磨損行為
  17. Friction and wear properties of al2o3 fiber filled - ptfe composites

    復合材料摩擦磨損性能分析
  18. Dry friction and wear properties of intermetallics mosi2 against 45 steel

    45鋼摩擦磨損性能的研究
  19. Present friction and wear researches on friction couple in electric field

    受電摩擦磨損的研究現狀
  20. Friction and wear performance of nano - graphite al matrix composite material

    鋁基復合材料的摩擦磨損性能
分享友人
分享到 Line

分享到臉書