摩擦腐蝕 的英文怎麼說

中文拼音 [shí]
摩擦腐蝕 英文
chafing corrosion
  • : 摩構詞成分。
  • : 動詞1 (摩擦) rub 2 (用布、 手巾等摩擦使干凈; 揩拭; 抹) wipe; scrub; clean 3 (塗抹; 搽) spre...
  • : Ⅰ名詞(豆腐) bean curdⅡ動詞(腐爛; 變壞) decay Ⅲ形容詞(腐爛) rotten; corroded; putrid
  • : Ⅰ動詞1. (損失; 虧耗) lose 2. (腐蝕) erode; corrode Ⅱ名詞(天體現象) eclipse
  • 摩擦 : 1 (互相接觸的兩物體作來回相對運動) rub; chafe 2 [物理學] (相互接觸的兩物體在接觸面上發生阻礙相...
  • 腐蝕 : 1 (通過化學作用使物體逐漸消損破壞) corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Sepiolite has low shrinking rate, plasticity is good, alkali - resisting and easy to dissolve, absorb the peculiar industry performance such as being strong of performance, in addition, also absorb, decolouring, hot stability is anticorrosive, resist radiation and insulate against heat, the characteristic such as being insulating, is used in the non - asbestos jointing sheet, various of brake shoes, paint, sound insulation of the building mainly, thermal insulator

    海泡石具有收縮率低,可塑性好,耐堿易溶解,吸附性能強等特有的工業性能,除此之外,還具有吸附,脫色,熱穩定,抗,抗輻射及隔熱,絕緣等特性,主要用於密封產品如非石棉橡膠板,產品如各式剎車片,油漆、塗料,建築隔音、隔熱材料。
  2. Sepiolite has low shrinking rate, plasticity is good, alkali - resisting and easy to dissole, absorb the peculiar industry performance such as being strong of performance, in addition, also absorb, decolouring, hot stability is anticorrosie, resist radiation and insulate against heat, the characteristic such as being insulating, is used in the non - asbestos jointing sheet, arious of brake shoes, paint, sound insulation of the building mainly, thermal insulator

    海泡石具有收縮率低,可塑性好,耐堿易溶解,吸附性能強等特有的工業性能,除此之外,還具有吸附,脫色,熱穩定,抗,抗輻射及隔熱,絕緣等特性,主要用於密封產品如非石棉橡膠板,產品如各式剎車片,油漆、塗料,建築隔音、隔熱材料。
  3. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用零部件材料發展的需要,在實驗室磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料副在水、化學性介質作潤滑劑和無潤滑時室溫下的磨損特性。
  4. Effects of diamond particles and their adding contents on the coating hardness, friction coefficient, wear resistance, corrosion current density and microstructures were studied

    研究了金剛石粒子及其添加量對塗層硬度、因數、耐磨性能、電流密度和微觀組織的影響。
  5. Abstract : this article introduces a new sieve covering. it features as follow ; slot wit h standardized dimension ; smoth surface ; low sliding resistance ; little risk of clogging ; fabricate and raplace singly ; high wear & erosive resistance. and research on how to adjust sieve parameters to separate the mixture that diffcult to filter

    文摘:分析專利技術生產的新型板網具有縫隙均勻,表面光潔,阻力小,不堵料,裝拆方便,使用壽命長,耐等優點,並對過濾中如何調整板網參數滿足難過濾物料的要求進行了研究。
  6. Owing to its combinations of high red - hardness, low friction coefficient, good wear resistance, excellent corrosion resistance and low cost, etc, ti ( c, n ) based cermets is in a process of replacing the tic based cermets and conventional wc - co cemented carbides in cutting tool applications

    Ti ( c , n )基金屬陶瓷具有紅硬性高、系數低、耐磨性好、耐性高等特性,並且在市場成本上佔有明顯優勢,在刀具應用領域大有取代傳統wc - co硬質合金和tic基金屬陶瓷之勢。
  7. Paints and varnishes - friction - reduction coatings for the interior of on - and offshore steel pipelines for non - corrosive gases

    油漆和清漆.岸上和近海鋪設的無氣體鋼管道內側的減小塗層
  8. The properties of product : extremely high wear - resisting performance, an extremely low cofficion ; fine person who lubricate by oneself, it si unnecessary the note oil, use the difficult card to die under the abominable condition ; antistatic, it is fire - retardant to resist, ageing - resistant, able to bear the corrosion of chemistry ( sour alkali and organic solvent ) ; can bear and assault, shake repeatedly ; mechanical performance is excellent, light, install it conveniently

    產品性能:極高的耐磨性能,極低的系數,優良的自潤滑性,不用注油,在惡劣條件下使用不易卡死;具有抗靜電,抗阻燃,耐老化,耐化學(酸、堿和有機溶劑)的;能承受反復沖擊、震動;機械性能優異,重量輕,安裝方便。
  9. Powder - metallurgy copper friction materal has enough and steady frictional factor. it can perfectly coexist with coordination material. it has good anti - bite, thermal conduction, wear - proof and corrosion - proof

    銅基粉末冶金材料,具有足夠和穩定的系數,能與對偶材料很好的共存,具有良好的抗咬合性和導熱性,耐磨、耐
  10. In addition to maintaining the original natural graphite with characteristics, texture also has soft, flexible, high and low temperature resistance, corrosion resistance, high - dose irradiated milk, and low friction coefficient, which has a wide adaptability

    除保持天然石墨原來具有的特性外,還具有質地柔軟,富有彈性,耐高低溫、耐、耐高劑量輻照、系數低等優點,因而具有廣泛的適應性。
  11. Improvement and progress in mechanical, tribological properties, high - temperature oxidation and corrosion resistance of hard multilayer coatings were summarized. efficient methods were put forward

    摘要總結了硬質多層膜改善力學性能、性能、高溫氧化性能、性能的方法及進展,指出了有效途徑。
  12. Feature for good anti - impact intensity, low friction index, good wear resistance, light weight, anti - aging, anti - corrosion, self - lubricating, antistatic, electricity

    具有抗沖擊強度、系數小、耐性好,重量輕,耐老化、不、自潤滑、抗靜電。
  13. Steel tubes and fittings for on and offshore pipelines - internal coating for the reduction of friction for conveyance of non corrosive gas

    海上和近海管道用鋼管和配件.降低無氣體運輸的內塗層
  14. The purpose of lubrication in ball screw applications is to reduce friction and wear, provide anti - corrosion, cooling, and foreign substance displacement measures

    滾絲杠的潤滑是為了減少磨損,抵抗,冷卻,減少外部物質的影響。
  15. Steel tubes and fittings for on and offshore pipelines - internal coating for the reduction of friction for conveyance of non corrosive gas ; german version en 10301 : 2003

    海上和近海管道用鋼管和配件.降低無氣體運輸
  16. Depending on different natures of materials to be conveyed, the pipe inner surface can be lined with a metal either the same as or other than the pipe base metal by means of the plastic deformation complex technique so as to meet the following requirements : 1 ) increasing both corrosion resistance and wear resistance of the pipe inner surface ; 2 ) reducing the friction factor and the resistance against the materials being conveyed in the pipe line ; 3 ) easy processing, installation and maintenance of the pipe line

    根據輸送物料的性質,採用塑性變形復合方法在管道內壁鑲襯異種或同種金屬管,可以實現以下目的:增強管道內表面的耐性和耐磨性;降低系數,減小物料的輸送阻力;便於管道的加工、安裝和維修。
分享友人