摩擦電流 的英文怎麼說

中文拼音 [diànliú]
摩擦電流 英文
frictional working current
  • : 摩構詞成分。
  • : 動詞1 (摩擦) rub 2 (用布、 手巾等摩擦使干凈; 揩拭; 抹) wipe; scrub; clean 3 (塗抹; 搽) spre...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 摩擦 : 1 (互相接觸的兩物體作來回相對運動) rub; chafe 2 [物理學] (相互接觸的兩物體在接觸面上發生阻礙相...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. We also studied the dynamic characteristics of cf / cu ( c ) - cu composites, the results show that, by the method of graphite is coated with copper, the coefficient of friction and the wear rates remarkably decreased. with the increase of the copper coated carbon fiber content, the wear rates of cf / cu ( c ) - cu composites is notably decreased, while the coefficient of friction is increased. with the increase of electric current density, the wear rate of cf / cu ( c ) - cu composites is increased

    研究發現,碳纖維鍍銅石墨-銅復合材料的磨損性能與碳纖維含量存在一最佳值,當碳纖維含量為0 . 6時,其磨損性能最好;對于不同密度下的磨損性能的比較可以發現,通磨損時的系數要小於機械磨損時的系數,碳纖維鍍銅石墨-銅復合材料的系數隨密度增大先減小而後增大,在密度為15a cm ~ 2時達到最小值;通磨損量要遠大於機械磨損量,且隨著密度增大,磨損量增加。
  2. It is shown that : with the enhancement of er effects, the pressure and the thickness of lubricant film are obviously increased, while the friction coefficient and force are increased, the leak flow is reduced

    計算結果表明:隨著變效應的增強,油膜壓力和油膜厚度都有明顯提高,但是系數和力有所增加,端泄量有所減小。
  3. A method is provided to measure the friction parameters of the bed. the maximum friction torque, coulomb friction torque, viscous friction coefficient and moment of inertia can be gotten by fitting the free reduced rate curve of the gimbals and measuring the motor current when the motor begins to rotate

    提出了一種測量轉臺特性的方法,通過對轉臺在無外推力作用下的速度衰減曲線的擬合以及機啟動過程和轉速的測量,可以得到最大靜力矩、庫侖力矩、粘滯系數及轉動慣量。
  4. Effects of diamond particles and their adding contents on the coating hardness, friction coefficient, wear resistance, corrosion current density and microstructures were studied

    研究了金剛石粒子及其添加量對塗層硬度、因數、耐磨性能、腐蝕密度和微觀組織的影響。
  5. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模,並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究,主要針對影響系統特性的主要參數變化,動態分析系統的輸出特性,在上下行工況中,分析了機軸系粘性阻尼系數、軸系力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼系數以及不同運行樓層工況等參數對系統特性的影響;最後對軸向柱塞泵馬達的量壓力脈動對梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  6. L. ruan, g. gu, x. tian “ numerical simulation for circulating systems and experimental comparison of the closed - loop, self - circulating evaporative cooling of hydro - generators ” 《 electrical engineering 》 vol86, no. 3

    阮琳,顧國彪,田新東「大型蒸發冷卻水輪發機的關鍵問題定子空心導線內兩相阻力放大倍數的比較及修正建議」 《大機技術》 , 2004 . 4
  7. Against two kinds of nonlinear friction observers, the analytic expression of zero ve - locity interval t based on the nonlinear model of brushless dc motor system is deduced in this paper. simulation results indicate that the system performance at low velocity can be im - proved effectively using the friction observer based on coulomb friction model

    針對兩種不同的非線性觀測器,推導了基於無刷直動機非線性模型的零速度時間間隔腡解析表達式,通過模擬證實,利用基於庫侖模型的觀測器可以有效地改善系統的低速控制性能。
  8. First super - low specific - speed centrifugal pump has a long and narrow flow passage for its high head and low capacity, and the power absorbed by disc friction is too high, so the efficiency is very low ; secondly the diffusion of flow passage is so high, that the reserved flow often emerges at the inlet and outlet of impeller. therefore the h ~ q characteristic curve is often hump - shaped, and at the low - capacity operating condition the instability often occurs ; thirdly the centrifugal pump at high - capacity operating condition is easy to overload because the n ~ q curve appears a rising trend

    首先由於它的揚程較高、量較小,所以它的道狹長,圓盤損失較大,效率相對較低;其次由於它的道擴散較嚴重,易在葉片進口產生迴和在出口產生脫,揚程量特性曲線易出現駝峰,在小量工況下易產生不穩定現象;第三,由於其功率量曲線呈現上升趨勢,在大量區運行時機易過載。
  9. Research and development of sliding - collecting - current materials in modern railway transportation and related current - carrier friction abrasion

    現代軌道交通材料及相關載磨損研究進展
  10. Compensation of friction in brushless dc motor system

    無刷直動機系統的一種補償方法研究
  11. Presents a simple method of compensating friction against the character of the nonlinear model of a brushless dc motor system which transfers the original system model to a simple linear model using the method of input - output linearization, and estimates the coulomb friction in the system in real - time using a nonlinear friction estimator, and then compensate the friction in the system using a friction feedforward, and concludes from simulation results that this method can effectively eliminate the influence of friction in brushless dc motor systems

    針對無刷直動機系統的非線性數學模型特點,提出了一種簡單的補償方法.該方法首先利用輸入輸出線性化方法將原系統模型轉化為一種簡單的線性模型,然後給出一種非線性估計器實時估計系統中的庫侖值,最後利用前饋補償方法對其進行補償.模擬結果表明該方法可以有效地抑制無刷直動機系統中的影響
  12. However, the traditional dc motor uses brush so as to switch the phases, so there are relative mechanical frictions. then it comes out many fatal failing, such as yawp, spark, wireless disturb, etc. what " s more, its making cost is high, its maintain is also difficult, therefore its application is greatly limited

    動機具有運行效率高和調速性能好等諸多優點,但傳統的直動機均採用刷,以機械方法換向,因而存在相對的機械,由此帶來了噪聲、火花、無線干擾以及壽命短等致命弱點,再加上製造成本高及維修困難等缺點,從而大大地限制了它的應用范圍。
  13. Based on the analysis, we gave an example to study the dynamic contact with friction of the intermittent joint, and got some essential rules : the friction coefficient could n ' t influence the distributing of dynamic stress on the contact surface, and the roading rates affected evidently on the dynamic characteristic on the contact surface. in the last part, this paper made respectively use of the time - history method and the response spectrum method to analyze the dynamic response of the rock slope on baise hydraulic power plant, and got the coincident resultant. simultaneously, the contact theory was applied to study the stability of the intermittent joints

    基於上述的接觸理論和接觸分析結果,本文在最後一部分中分別利用動力時程法和反應譜法對百色水站尾水渠的巖質邊坡進行動力響應分析,兩者計算方法得出比較一致的結果,同時採用動力接觸理論重點分析了斷層對于邊坡的穩定影響,認為斷層的存在會使得巖坡的穩定性降低,在地震等動力荷載的作用下對于斷層將發生張開、閉合和錯動現象,尤其是動力荷載和其他荷載如滲力等的耦合作用將會對斷層產生極為不利的後果,進而影響巖坡的整體動力穩定,應該要引起足夠的重視。
  14. It has plenty of advantages, like as strong power, user - friendly, versatile and safe, operation reliability, high performance and efficiency, long lasting etc. all our products have been widely used in drilling cutting, construction project, concrete drilling and chiselling wall sawing floor sawing concrete crushing and bursting

    Ews - 300 ews - 200系列動墻鋸,鋼筋混凝土切割機由我公司研製生產,採用德國超強墻鋸機頭,輸入功率4300w ,輸出功率3600w ,採用離合器過保護器源自動檢測三重
分享友人