摻氣區 的英文怎麼說

中文拼音 [chān]
摻氣區 英文
aeration zone
  • : 摻動詞[書面語] (持; 握) hold
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 區名詞(姓氏) a surname
  1. A kind of measurement was developed to measure the air concentration of water and the result showed the possibility of entrained air existing near the wall of drop shaft. that is to say, the wall of drop shaft may be protected by entrained air from cavitation damage to some extent

    本文設計了一種適用於近壁水流濃度測量的方法,對空腔段水流濃度進行初步測量,發現井壁附近水流存在的可能,這對改善水流空化條件能起到積極作用。
  2. Curvature effects on the film cooling with the rotation

    旋轉狀態下曲率對膜與主流域的影響
  3. The aerated behaviours in cavitation region of high velocity flow through the non - circulating water tunnel are investigated by using the advanced experimental facilities in the hydraulics laboratory at zhejiang university of technology

    摘要本文用先進的量測儀器在浙江工業大學水力學實驗室直流式水洞中分別對高速水流空化、空蝕特性進行了較為系統的試驗研究。
  4. While the speed is very large, the fuel - air mixing behind the airstream is decreased and the span that the fuel flow in the second combustor is reduced, so the combustion efficiency is decreased, h ) if the fuel streams impinge with the airstreams directly at the air - inlet exit, it make against increasing the combustion efficiency, i ) increasing air - to - fuel ratio within proper range can increase the combustion efficiency

    增加燃噴射速度有利於增強迴流強度,頭部燃燒溫度上升,但速度太大則會減弱燃同空在進道下游的混燃燒,減少燃在室內停留時間,燃燒效率降低; 8燃射流與空流在進道出口直接撞擊不利於燃燒效率的提高; 9在適當范圍內增大空燃比能顯著提高燃燒效率。
  5. Effect of temperature ratio on the film cooling with the rotation

    旋轉狀態下溫度比對膜與主流域的影響
  6. Variations in pressure with and without aeration in cavitation region are measured and the compressible characteristics of pressure waveforms and relation between mach number and compression ratio are analyzed ; the time - averaged pressure profiles of different air concentration in cavitation erosion region are measured, the variations of the pressure with air concentration and effects of back pressure on cavitation erosion are analyzed ; the relations between least air concentration to prevent cavitation erosion and flow velocity are proposed ; the cavitation numbers with and without aeration in cavitation region are compared

    實測了空化前後壓力的變化,分析了壓力波形的可壓縮流特徵以及馬赫數與壓縮比的關系;實測了空蝕不同濃度的時均壓力分佈,分析了壓力隨濃度的變化及背壓對空蝕的影響;提出減免空蝕的最低濃度與流速的關系,比較了前後水流的空化數。
  7. With computations and analysis, the comprehension on the mixing and combustion process is increased, and some significative results are listed below : a ) there are three recirculation regions and one vortex region in the combustor, and these recirculation regions affect the combustion process deeply, b ) increasing side - arm angle and moving side - air inlet position toward the fuel inlet can improve mixing and combustion characteristics, and increase the combustion efficiency, c ) when the angle between two air - inlets equals to 180

    通過計算與分析,增進了對補燃室內混燃燒過程的理解,為固體火箭沖壓發動機補燃室設計提供了一些有意義的結果: 1補燃室內的流動十分復雜,存在三個迴流和一個旋渦,迴流混燃燒過程有重要影響; 2增大空入射角度、向前移動進道出口位置有利於增強頭部迴流強度,增強混效果,燃燒效率上升; 3
分享友人