擬合線 的英文怎麼說

中文拼音 [nǐgěxiàn]
擬合線 英文
fitted line
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  1. This paper put forward the optimized methods include reconstructing the characteristic curve by reasonable use of the adjust tools and analyse tools of the modeling software, admeasuring the automotive model surface correctly, simulating the breaking surface and creating the surface in the right turns which is good for modeling a smooth and exactitude surface. at last, after the correct analysis of the factors which are effect to the surface construction, a smooth and exactitude surface of the similar diamond concept car has been constructed by using the right optimize method

    本文通過合理利用反求軟體中的造型工具和分析工具，正確劃分反求模型的造型區域，使用正確的曲面造型方法，對反求曲面的特徵網格線進行二次優化，並對突變曲面進行擬合再生成處理及建立合理的曲面生成順序等方法，最終獲得了仿型度和光順度都很高的反求曲面。
  2. Adopting the assummation that the quark interaction is the sum of the usual one - gluon direct exchange and the mixture of linear scalar and vector potentials, we structure the relativistic corrections of order v2 / c2to the cornell potential, including the annihilation potential for the quark and antiquark of the same favors which plays the same role with the one - gluon direct exchange at short distances. the effects of the relativistic corrections on the hyperfine splittings of quarkonium states are discussed, and a good fit to the available experimental data is obtained on heavy quarkonium mass spectra

    采納庫侖勢源於單膠子直接交換，而線性禁閉源於標量和矢量的混合，同時考慮在短程區域與單膠子直接交換起同樣作用的同味正反夸克的湮滅，構造了靜態夸克-反夸克勢到v ~ 2 c ~ 2級次的完全相對論修正，並擬合計算了重介子偶素的能譜，討論了相對論修正對重介子偶素能級分裂的作用。
  3. ( 2 ) based on indoor test, two typical soft rock of brecciated mudstone and siltstone in luohu jiancheng district is carried systemically though interior rheological testing ; moreover combining with preceding studying results of rock rheological constitutive model, rheological numerical constitutive model suited to rock mass mechanics characteristics and stratum structure of luohu fracture zone, and numerical parameters of the model are processed with studying of curve fitting

    （ 2 ）立足於室內試驗，對羅湖建成區兩種典型的軟弱巖石?含角礫泥巖和粉砂巖進行系統的室內流變試驗研究，又結合前人對巖石流變本構模型的研究成果，分析並確定了適合羅湖破碎帶巖體力學特性及地層構造特徵的流變計算本構模型，並對該模型的計算參數進行了曲線擬合研究。
  4. Nonlinear spiral simulation of chandler wobble orbit

    擺動軌跡的非線性螺旋線擬合及機制的研究
  5. Fitting method for pump complex characteristic curve based on b - spline

    樣條的水泵復雜特性曲線擬合方法
  6. In the wafer - cycle fitting algorithm, comparing with circumgyration radius approach, track fitting approach, and least square circle fitting approach. in the wafer pre - alignment system, the wafer square fitting algorithm - least square circle fitting approach, based on optical linear ccd sensor, as well as the theoretical error analyze of this algorithm

    在晶圓檢測演算法方面，比較回轉半徑法、軌跡擬合法以及最小二乘圓法，選擇光學線陣ccd的晶圓圓心最小二乘圓法作為系統晶圓圓心的檢測方法。
  7. An approach for approximation of arbitrary conic by biarcs

    任意二次曲線的雙圓弧擬合成形法
  8. Non - round curve fitting and tabulated curve fitting

    非圓曲線與列表曲線的擬合
  9. Research and application of a new method of curve fitting

    實驗數據的曲線擬合方法及其應用
  10. An algorithm for valve core curve fitting

    閥芯曲線擬合演算法
  11. The approach of curve fitting is used to mark out of the flight path

    航跡的規劃採用曲線擬合的方式。
  12. Sub pixel edge detection algorithm based on guadrativ curve fitting

    基於二次曲線擬合的圖像亞像素邊緣定位演算法
  13. Curve fitting in switched capacitor networks using least square estimation

    開關電容網路頻域的最小二乘曲線擬合
  14. Curve fitting compaction

    曲線擬合法壓縮
  15. Method of deal with data error by subsection curve fitting and discrete degree

    分段曲線擬合與離散度加權的數據誤差處理方法
  16. First the sketch / datum plane is fitted by least - square distance, then the extruded direction or axis with the flank points of the cloud is extracted in quadratic paogramming arithmetic, and certain points projected to gain 2d sketched datas. feature points are defined to segment the sketch datas, and the sketch profile is generated by fitting separately the line and circle segment

    使用最小二乘方法擬合草圖基準平面，採用二次規劃方法提取拉伸方向和旋轉軸線，然後將數據點投影以獲取草圖數據，通過柵格劃分提取草圖邊界輪廓數據，再對這些邊界數據進行基於特徵點的分割，以直線和圓弧段擬合出草圖輪廓。
  17. It employs a series of processing methods. for example, it employs different method of threshold according to illumination and the characteristic of the dial plate ; employs the method of mathematic form filtering according to the thought of the line is the most important in image ; employs the method of beeline matching according to the characteristic of the line

    此系統利用了圖像處理的基本思想，採用了一系列的處理方法，如根據照度及表盤特點採用了不同的二值化方法；根據圖像中線條最重要的思想對圖像的濾波採用了數學形態濾波方法；根據線條特點提出了利用直線擬合的方法等。
  18. Best - fit line

    最佳擬合線
  19. Best fit line

    最優擬合線
  20. The research work focuses on the following four main investigations : 1. theory of fluid system design for adjustable linear oil damper by use of dynamic mathematical models and dynamic - parameter - compensat ing method, the first research of this item has established the generalized optimiz - - ation mathematical model of the fluid system of an adjustable linear oil damper ; by use of the mechanical generalized optimization theory and platform, the first research has also made a multi - objective and overall - performance optimal design to the fluid system which gives the damper both the best damping performances and the best economic capacities ; by modeling the whole damper and analyzing it by numerical method, the second research of this item has solved the problem of the damper ' s dynamical damping characteristics calculation, simulation and analysis

    主要涉及以下四個方面的內容： 1 、可調式線性油壓減振器阻尼系統的設計理論採用動態數學模型和動態參數補償的方法對可調式線性油壓減振器的阻尼系統進行了廣義優化設計建模；運用機械廣義優化設計理論和平臺對可調式線性油壓減振器的阻尼系統進行了多目標、全性能的優化，實現了其技術性能和經濟性能的綜合優化設計；通過對整個油壓減振器進行建模與數值分析，解決了工程上對多級擬合線性油壓減振器的阻尼性能進行求解、對其動態特性進行分析的難點。
分享友人
分享到 Line

分享到臉書