收斂流 的英文怎麼說

中文拼音 [shōuliǎnliú]
收斂流 英文
contracting stream
  • : Ⅰ動詞1 (把攤開的或分散的事物聚集、合攏) put away; take in 2 (收取) collect 3 (收割) harvest...
  • : Ⅰ動詞1 (收起; 收住) hold back; keep back 2 (約束) restrain 3 (收集; 徵收) gather; collect; ...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 收斂 : 1 (減弱或消失) weaken or disappear 2 (約束言行) restrain oneself 3 [數學] convergence; constr...
  1. 3. developed simply and practical fluid network algorithm for large - scale of pipe networks, such as air - gas system and powder manufacture system. iterative computation used in this algorithm is not only astringing quickly and numerical calculating steadily but also cater the required ratio of precision and guarantee the real - time and any performance simulation of fluid network

    3 、本文對風煙系統和制粉系統等大型管網,建立了簡單實用的體網路模型演算法,此法在迭代計算中,不僅可以快速和數值計算穩定,而且滿足一定的模擬精度,較好的保證了體網路的全工況實時模擬。
  2. Power flow calculating, power loss and reactive power optimization analysis calculate fast and have credible constringency

    、網損計算和無功優化分析計算速度較快,能夠可靠
  3. Many more criteria for the convergence of infinite series were developed by leading mathematicians.

    許多第一的數學家推導了無窮極數的很多判別法則。
  4. In order to improve the efficiency of the mesh generation, we employ the transfinite interpolation method. in low speed flow ( m < 0. 05 ), the low mach will aggravate the difference between eigenvalues of the system and make the convergence sharply difficult. as for this, we use the preconditioning method to remove it

    另外,我們求解的是極低馬赫數下的場( m 0 . 05 ) ,極低的馬赫數會導致可壓動方程十分僵硬而難以,對此,我們對n - s方程進行了矩陣預處理。
  5. In chapter three, a back / forward sweeps based on branch loss for power flow is presents, which is credited with simple program, good numerical value stability, small ems memory and rapid calculation

    第三章介紹了基於支路網損的配電網前推回推潮演算法,該演算法編程簡單,數值穩定性好,佔用內存小,計算速度快,並且性和速度均優于牛頓法。
  6. 4. a 2 - d and 3 - d euler equations and n - s equations are solved using the cell - centered finite volume method and four - step runge - kutta scheme on the cartesian grids with standard convergence acceleration techniques such as local time stepping, enthalpy and implicit residual smoothing

    使用jameson中心有限體積法和runge - kutta時間推進方法,求解了關於二維、三維復雜場的euler 、 navier - stokes方程,採用了當地時間步長、隱式殘值光順等多種加速方法。
  7. Finite element simulation of melted polymer flow inside convergent flow slot

    收斂流道內聚合物熔體動的有限元模擬
  8. In extensional flow fiber tended to perpendicularity to the streamline, while in shear flow and convergent flow fiber tended to parallel to the streamline in the thin wall caving

    在薄壁型腔的擴張中,短纖維趨于與線方向垂直,而在剪切收斂流中趨于與線方向一致。
  9. Neural network control is an important mode of intelligent control, and it is widely used in branches of control science, first, the architecture and the learning rule ( error back propagation algorithm ) of multiplayered neural network which is widely used in control system are presentedo especially, the paper refers to the architecture of diagonal recurrent neural network and its learning algorithm - - - - - recurrent prediction error algorithm because of its faster convergence with low computing costo next, before introducing the neural network control to the double close loop dc driver system, the controllers of current and velocity loop are designed using engineering design approach after analysis of the system, simulation models of the system are created

    神經網路控制是智能控制的重要方式之一,它廣泛應用於自動控制學科各個領域。本文首先敘述了控制系統中常用的多層前饋網路結構及演算法( bp演算法) ,特別提及了能夠較好描述系統動態性能的對角遞歸神經網路和在用遞推預報誤差演算法訓練drnn時取得了較快的速度。其次,應用工程方法分析設計了tf - 1350糖分離機的電、轉速雙閉環直調速系統的控制器,作為引入神經網路控制的設計基礎,並建立了系統的模擬模型。
  10. This paper presents a three - phase harmonic power flow algorithm using phase components and back - forward sweep method to solve the disconvergence when the three - phase transformer harmonic model was used. the example result presented the method was feasible and

    本文針對在進行三相諧波潮演算法時因引入三相變壓器諧波模型而可能導致計算結果不問題,提出了諧波潮計算的相分量法,其中引用了前推-回代法。
  11. For the variables with greater gradient, a high - precision interpolating function, such as quasi - consistence hexahedral element method, is naturally necessary to be adopt

    開邊界給定方式宜採用速度dirichlet條件和動壓力neumann條件,以利用壓力無反射條件,加快計算速度。
  12. Reactive optimal control of distribution system is based on power flow calculation. alternate iterating algorithm is proposed in this paper according to characters of reactive optimal control. the algorithm has advantages of fast computation speed, a few iterating times, high accuracy convergence and easy programming. it is an effect method applied to reactive optimal control

    其次,針對配電網無功優化控制對配電網潮計算的要求,採用交替迭代演算法進行配電網的潮計算,該演算法編程簡單、性好、計算速度快,適合於配電網無功優化控制的調用。
  13. In the last part, an experiential formula for nondimensional thermal stratification height is obtained, which includes inlet temperature t, inlet velocity v, heat transfer of the wall body q and the distance of heat source l. in order to obtain a more realistic result, the ? model is used to simulate the airflow and the buoyancy item is treated by boussinesq hypothesis. the paper investigates the flow field of the displacement ventilation in an office by a numerical method

    兩方程湍模型為基礎的壁面函數處理方法,對熱浮升力項採用了boussinesq假設,得到了的溫度場、速度場分佈。在此基礎上,給出了熱力分層高度的計算方法,並分析了送風溫度、送風速度、圍護結構傳熱和熱源分佈等因素對熱力分層高度的影響。
  14. The following aspects are involved in this dissertation : 1 ) properties of convergence of the network model under the circumstance of few rooms, the prediction of the early production tally with the growth of the fire in building on the whole while the prediction becomes most fallacious when the rooms increase to a certain number, for instance, 9. the solution of the net mass flux, positive mass flux and negative mass flux is improved and then mass conservation is strictly maintained so that the prediction of the software become more credible and reliable

    本文主要涉及以下幾個方面: 1 )軟體計算性態在房間數目很少的情況下,軟體開發的前期成果能在總體上成功預測建築火災的發展過程,當房間數目增加到一定的數目(如9 ) ,軟體計算將出現劇烈振蕩的問題,預測結果極不理想。本文改進了軟體對凈質量量、正、負質量量的求解,保證了三者之間的嚴格守恆關系。經過改進,軟體的預測結果更可靠,更可信。
  15. Study of creep convergence mechanism of high concrete face rockfill dam with consideration of rockfill arch action

    考慮拱效應的高面板堆石壩機制研究
  16. This paper studies nonlinear dynamic problems of tall building structures, first, constitutes linear dynamic equation and elasto - plastic dynamic equation of structure by using qr method, later, solves the dynamic equation by using spline unconditional stable algorithm, last, programs corresponding computer programs with c program language, and calculates some example and a tall building in constructing the courses and the results prove that qr method is not only simple in calculating and fast in constringency rate, but also precise, that qr method is a effective and economic new method

    本文研究高層建築結構彈塑性動力問題,先利用qr法建立了結構線性動力方程及彈塑性動力方程,然後利用樣條無條件穩定演算法求解了動力方程,最後利用c語言編寫了相應的計算程序,計算了一些例題和分析了一個工程實例。 qr法在理論上及方法上不用有限元法及動法則,避免了這些傳統方法在分析非線性問題時所帶來巨大困難的缺陷。計算結果表明,這種方法不僅計算簡便,而且精度高,速度快,是一種經濟有效的新方法。
  17. By analyzing the characteristic of the flow field in overloading srm and comparing several existing experiment techniques, a convergence - fold tube facility was developed. the flow field in chamber of srm with high acceleration was simulated. some inhibitor ablation experiments were carried out in this test facility

    通過分析過載條件下場的特點,提出並比較了現有過載地面模擬試驗技術的優缺點,最終確定了?折管的模擬試驗方法,模擬了高過載條件下發動機燃燒室內的高濃度粒子,利用該方法開展了高過載模擬沖刷條件下的絕熱層燒蝕特性研究及絕熱層抗沖刷能力的篩選試驗。
  18. 1394 serial bus interface : convergence bus promises to unite pcs and digital consumer equipment

    1394串列匯排介面:色收斂流排保證將個人電腦與數碼用戶設備合併
  19. 3. aiming at the limitation of simulated anneal genetic algorithm on a high computation while applied to flow shop scheduling problems, the paper presented selected simulated anneal genetic algorithm

    三、針對模擬退火遺傳演算法解決水車間調度問題存在速度慢的局限性,提出了選擇性退火的遺傳演算法。
  20. Numerical simulation of three dimensional isothermal power - law polymer melt flow within a rectangular convergent channel

    矩形收斂流道內聚合物熔體三維等溫冪律動的數值模擬
分享友人