收縮溫度 的英文怎麼說

中文拼音 [shōusuōwēndù]
收縮溫度 英文
contraction temperature
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 縮 : 縮構詞成分。
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 收縮 : 1 （由大變小; 由長變短） contract; shrink 2 （緊縮） concentrate one s forces; draw back 3 take u...
  • 溫度 : [物理學] temperature
  1. Construction of a mass concrete is in the construction process, because of cement let out in large quantity hydration heat and surface of a mass concrete let out heat, make its temperature, humidity cause to ascend and descend, and it causable constringency transform will be unavoidable

    大體積混凝土結構在施工過程中，由於混凝土中水泥熟化時放出大量的水化熱及其隨后的表面散熱，使其溫度、濕度出現升降變化，並由此而引起的收縮變形將是無法避免的。
  2. Comparing with the same category overseas jointless bridges, the new type bridge has more reasonable structure, more simple and convenient construction, and better use effect etc. the main work in this paper is described as follows : ( 1 ) this paper introduces phylogeny and reseach survey of the joints bridge inland and abroad, and a new jointless bridge structure ? new type semi - integral abutment bridge is based on these, which characteristic of own structure and setting of primary component are expatiated. ( 2 ) this paper analyses influence of temperature effect, creep, shrinkage and circumambient soil of run - on slab on the new type structure, and analyses the forcing performance of beam, abutment and run - on slab of the new type semi - integral abutment bridge, and constrast to the same category joints bridges

    本文主要做了以下工作: （ 1 ）介紹了無縫橋梁在國內外的發展歷史、研究概況，並在此基礎上提出了一種新的無縫橋梁結構形式-新型半整體式無縫橋梁，闡述了它特有的結構形式以及主要構件的設置; （ 2 ）分析了溫度效應、徐變和收縮以及搭板周圍土體對這種新型結構的影響，對新型半整體式無縫橋主梁、橋臺以及搭板進行了受力性能分析，並和同類無縫橋梁進行了對比分析。
  3. Bear the heat, can bear 230 heat but do not take place the constringency

    2 ）耐高溫，能承受230度高溫而不發生收縮
  4. Some other defects in castings are well - defined cracks and hot tears that develop during solidification, under combination of stress concentration from uneven contraction and the metal ' s low strength at near - melting temperatures

    鑄件內部的其它一些缺點是，凝固過程中，在不均勻收縮造成的應力集中和接近熔點溫度下金屬的低強度的綜合作用下，出現的清晰裂縫和熱撕裂。
  5. Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled

    課題研究中，首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性，使其表面由憎水轉化為完全親水，確保與無機材料的復合質量；其次，通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾，使保溫材料在滿足必要的強度的前提下，導熱系數降至最小；並且，課題研究中成功解決了纖維在保溫材料中均勻分散的問題，達到了抑制保溫材料收縮的目的；最後，通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性，滿足施工的要求。
  6. There are many facts affect the linear contractive quotiety of asphalt concrete, such as the type of asphalt, the asphalt content in asphalt concrete and the temperature period of the asphalt concrete worked in

    試驗內容主要包括瀝青品種、瀝青含量、以及不同溫度段中瀝青混凝土線收縮系數的測試。
  7. The test results indicate that the influence of the asphalt type and the temperature period on the value of linear contractive quotiety is very notable, while that of asphalt content ( variation within 0. 3 % ) and the temperature raising and reducing process is relatively small

    試驗結果表明：瀝青品種對瀝青混凝土的線收縮系數的影響較大，瀝青混凝土在不同溫度段的線收縮系數相差很大，而瀝青含量（變化范圍0 . 3 % ） 、升溫或降溫過程對其的影響較小。
  8. Shrinkage stress was found to increase linearly with cure temperature.

    我們發現收縮應力隨固化溫度直線增加。
  9. In this paper, the course of isothermal crystallization kinetics of polymer in limited volume unit is simulated by use of the method of monte carlo. four factors influenting on the course of polymer in the limited volume unite isothermal crystallization are analyzed under the given conditions. the four factors are sample volume shrinkage, the change of the linear growth rate of entities g, the change of sample thickness and the change of the number of nuclei

    本文採用montecarlo方法研究了高聚物在有限體積元中的等溫結晶動力學過程，分析了在一定條件下，樣品體積收縮、晶體線生長速率變化、樣品厚度變化和晶核數目變化這四種因素對高聚物在有限體積元中的等溫結晶過程的影響。
  10. This thesis investigated and researched on non - loaded crack, especially those caused by thermal - shrink, and analyzed the thermal - shrink stress of beam, slab and continuous - wall, found that according data of civil and overseas offered thermal - shrink calculating formula without considering effect of factors, such as the cement quantity, using of aruhuesiru, aggregate size and quantity of sand, which made the result data smaller. in addition, there are not enough construct measure in code

    本文對非荷載裂縫，特別是溫度?收縮裂縫進行了調查研究，並對兩端或四周約束的梁、板和底部約束的地下連續墻進行了收縮應力分析，發現國內外有關文獻給出的收縮計算公式沒有考慮泵送商品混凝土的水泥用量、外加劑使用、骨料粒徑和砂用量等因素的影響，計算出的混凝土收縮量往往偏小；另外， 《規范》中針對溫度?收縮裂縫的構造措施不足。
  11. We research the causes of concrete cracking, develop the high performance anti - cracking additive, optimize the concrete mix and construction techniques, increase the stability of concrete volume by shrinkage compensation, enhance splitting tensile strength, and can meet demand of high workability of fresh concrete. in the study, a thorough investigation of this problem is made from all points of view, with the aid of various modern measurement & testing technology and different theories & methods in surface physical chemistry, structural chemistry, solid - state chemistry, composite materials, fracture mechanics, etc. our research results have shown that the various shrinkage of concrete cause concrete cracking in building engineering, such as autogenous shrinkage, dry shrinkage, temperature shrinkage, plastic shrinkage, carbonized shrinkage, etc

    目前，解決混凝土開裂的方法是綜合的，我們調查研究了混凝土開裂的原因，開發研製了高性能抗裂外加劑，優化混凝土的設計和施工方法，並通過補償收縮達到混凝土體積穩定，提高抗裂強度，滿足混凝土拌和物高工作性能的要求。本研究採用多種測試技術，應用表面物理化學、結構化學、固體化學、復合材料學、斷裂力學等多學科的理論與方法，從不同的角度進行深入的研究和探討。通過調查研究建築工程中出現的混凝土開裂、滲漏問題，發現混凝土在非荷載作用下開裂主要是由混凝土的自收縮、乾燥收縮、溫度收縮、塑性收縮、碳化收縮等各種收縮變形引起的。
  12. Electric lamps - standard method of measuring the pinch temperature of quartz tungsten - halogen lamps

    電燈.測定鹵鎢石英燈收縮溫度的標準方法
  13. Standard method of measuring the pinch temperature of quartz - tungsten - halogen lamps

    石英鹵鎢燈收縮溫度測定的標準方法
  14. Method of measuring the pinch temperature of quartz glass lamps

    石英玻璃燈熱收縮溫度的測量方法
  15. The dsf is a high strength for regarding polypropylene as raw material, with special craft making, fiber of low extension polypropylene, and can avaylably control the concrete, and fuck, temperature to contract the produce, improving of crack the concrete s anti the function, anti to pound at the ability, extension concrete the service life that product

    丹強絲一種以聚丙烯為原料，以特殊工藝製造的高強度，低延伸性聚丙烯纖維，可以有效地控制混凝土塑性，干縮、溫度收縮裂紋的產生，改善混凝土的抗滲性能，抗沖擊能力，延長混凝土製品的使用壽命。
  16. Standard test method for shrinkage temperature of leather

    皮革收縮溫度的標準試驗方法
  17. Leather - physical and mechanical tests - determination of shrinkage temperature

    皮革.物理和機械試驗.收縮溫度的測定
  18. Leather - physical and mechanical tests - determination of shrinkage temperature up to 100 oc

    皮革.物理和機械試驗. 100攝氏度及以下收縮溫度的測定
  19. Leather - physical and mechanical tests - determination of shrinkage temperature up to 100 degrees c

    皮革.物理和機械試驗. 100以下的收縮溫度的測定
  20. High transparence, strong shrinkable rate and the shrinkable temperature is between 80 and 150, be suited to the product package of kinds of industries, can be designed as flat placket, abnormity bag, arc bag and shrinkable pipe

    透明度高、收縮率強，收縮溫度80 - 150 ，適用於各個行業的產品包裝，可設計製作成各種平口袋、異形袋、弧形袋及收縮導管。
分享友人
分享到 Line

分享到臉書