改性塗料 的英文怎麼說

中文拼音 [gǎixìngtúliào]
改性塗料 英文
modified paint
  • 改 : Ⅰ動詞1 （改變） change; transform 2 （修改） revise; alter; modify 3 （改正） rectify; correct 4 ...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 塗料 : coating material; paint; coating; daubing; dope; moldwash
  1. Development of alkyd resin modified with acrylic

    丙烯酸改性醇酸樹脂塗料的研究進展
  2. A study on acrylate copolymer - modified alkyd resin paints

    丙烯酸酯共聚改性醇酸樹脂塗料的研製
  3. 90 % uv below 400nm could be shielded by the nano - sio2 sol. the time of the artificial aging of nano - sio2 - modified coatings prepared by the way of in - situ dispersion method was about twice as long as that of the nano - sio2 - modified coatings prepared by dispersing the nano - sio2 powder in the coating directly. on the other hand, the fadeproof time ( reaching the second level of color aberration ) of the nano - sio2 - modified coatings was 1. 83 times as long as that of the national standard for the super coatings

    實驗證明:納米510 :溶膠具有很強的紫外散射屏蔽性能，對400nm以下的紫外光能屏蔽90 %以上;在位分散法納米510 :改性塗料的耐人工老化粉化時間比直接分散法納米510 :改性塗料提高了近1倍，耐變色時間（達到色差2級的時間）是國標優等品要求的1 . 83倍，較相應的未改性塗料提高了約25 % 。
  4. There was an increase in the fadeproof time of 25 percent over the common coatings. both the nano - tio2 - modified coatings prepared by the way of in - situ sythesising method and the nano - sio2 - modified coatings prepared by the way of in - situ dispersion were strong weatherability coatings, which could resist 18 years " weathering if we calculated the result with the standard which argued that 100h of the artificial aging process was equal

    通過原位生成法制備的納米tio :改性塗料和在位分散法制備的納米510 :改性塗料具有超強的耐候性能，以人工老化100h大約相當于室外曝曬一年計算，納米改性的塗料在室外的使用壽命可超過18年。
  5. ( 5 ) glassy oxide film of samples processed by mevva al / piid si covered the surface of sic coating thickly and uniformly, and left few holes as a result of a good ability of sealing, which made weight loss of sic - c / sic smaller in air at1300

    （ 5 ） mevva源注入al再piid （等離子源全方位沉積） si塗層，玻璃氧化層厚而均勻，愈合性能好，孔洞少，對塗層缺陷有最佳的改性效果。復合材料在1300空氣中的氧化失重顯著降低，甚至出現增重。
  6. The mechanical properties and the resistance to water and heat of the polymer modified cement based waterproofing coating are greatly improved by the synthesized melamine resin

    三聚氰胺甲醛樹脂交聯劑可明顯改善聚合物水泥基塗料的力學性能、耐熱性能和耐水性能。
  7. On the basics of briefly summarizing the research and application presents of building coatings and nano - composite building coatings in domestic and overseas, presented a creative approach of modified exterior building latex coatings applying inorganic nano - powders and its " compound. systematically studied the effect of factors such as nano - materials " category, additive capacity, dispersing method on the behavior of exterior building coatings " weathering resistance, scratch resistance, water resistance and alkaline resistance etc. studying on uv - vis optical property of nano - powder materials and its " compounds turned up that nano - tio2, nano - sio2, nano - zno have excellent characteristics to uv shielding ; dispersing system of polybasic nano - composite materials owned higher uv shielding capability than single disperse system

    本文在簡要敘述國內外建築塗料和納米復合建築塗料的應用研究現狀的基礎上，提出了使用無機納米粉體及其復合材料改性建築外墻乳膠漆的創新思路，系統地研究了納米粉體材料的種類、添加量、分散方式等因素對外墻乳膠漆耐候性、耐洗刷性以及耐水、耐堿性等性能的影響，成功地開發了納米改性建築外墻乳膠漆產品，並完成了外墻乳膠漆用納米助劑的初步開發工作。
  8. Modified epoxy - putty coating for anode shielding

    改性環氧膩子型陽極屏塗料
  9. Including model th - 2 zinc silicate primer, th - 11 type epoxy zincrich paint, th - 12 type epoxy siderite intermediate coat, th - 17 type polyurethane coating of all kinds of varieties, th - 22 type modified epoxy pitch glass squama coating, etc. it has reliable quality and long antiseptic life, it is the ideal protection coating for large - scale steel construction

    包括th - 2型硅酸鋅塗料、 th - 11型環氧富鋅塗料、 th - 12型環氧雲鐵中間漆、 th - 17型各色聚氨脂塗料、 th - 22型改性環氧瀝青玻璃鱗片塗料等。質量穩定可靠，防腐壽命長，是大型鋼結構理想的防護塗料。
  10. We suggest to use the th - 22 type modified epoxy pitch glass squama coating for the underground parts

    埋地部位建議用th - 22型改性環氧瀝青玻璃鱗片塗料。
  11. The anticorrosion painting is one of the key products of our factory. the th - 1 and th - 2 type zinc silicate coating for marine type obtain the ship examination certificate of classification society, the th - 22 type modified epoxy pitch glass squama coating obtains the ccs ship examination certificate

    防腐塗料是我廠的重點產品之一，我廠生產的th - 1 、 th - 2型硅酸鋅船用塗料獲多國船級社的船檢證書， th - 22型改性環氧瀝青玻璃鱗片塗料獲ccs船檢證書。
  12. Abstract : the situation of vae waste water and waste residue applied in the process of paints, adhesive, modified cement, thermal insulation materials is introduced in this paper

    文摘:介紹了vae廢水和廢渣在塗料、粘合劑、水泥改性以及保溫材料加工中的應用情況。
  13. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  14. The analysis results of single - calibration - ratio method, single - calibration - ratio iteration calculating method, karl fisher ( kf ) method and gas - pressure method were compared based on a series of waterborne samples

    用改進后的氣相色譜法測定了16個水性塗料樣品的水含量，對單點校正因子法、單點校正因子迭代法、卡爾費休滴定法、氣壓法測定結果進行了比較。
  15. In order to solve the problem of conglomeration of the nanoparticle and make the nanoparticle disperse evenly in the coatings. in this way, we could succeed in improving the effect of modification. we originally put forward the in - situ sythesising nanoparticle method to modify coatings. through this method, we made use of the technology of the wet chemical method and added the precursor of nanoparticle during the preparation of coatings

    在此基礎上，為解決納米粉體的團聚問題，使納米粒子在塗料中有效分散與附聚，以實現納米粒子改性的有效性，原創性地提出了原位生成納米粒子改性塗料制備工藝的新思路：利用濕化學方法制備納米材料的技術，在常規塗料制備的過程中加入所需引入納米粒子的先驅物，直接在顏填料微粒的表面原位合成相應的納米粒子。
  16. According to certain mechanics route, using some kinds of dispersion means, the antibacterial coatings is obtained by adding nanometer inorganic powders

    將納米材料按照一定工藝路線添加到塗料中，通過各種分散手段製成改性塗料，塗料性能檢測的依據為gb t9756 - 2001合成樹脂乳液內墻塗料標準。
  17. We also put forward the technique of in - situ dispersion to modify coatings. the key of the technique was to add the nanoparticle sol prepared by the wet chemical method into coatings instead of dropping the nanoparticle powder prepared by the technics of filtration and calcinations in the coatings

    同時提出在位分散法納米粒子改性塗料的制備技術：直接在塗料中引入採用濕化學方法制備的納米粒子溶膠，而不是採用外加經過過濾和燒結等工藝制備的納米粉體。
  18. In order to have the better dispersion, the nanometer antibacterial additive is studied in this paper. these additives can be filled in the coatings very conveniently, and even when the adding amount is as little as 2 percent, the coating can have better antibacterial effect, and the antibacterial rate can reach 99. 97 percent

    為使納米材料在塗料中具有更好的分散性，以便改性塗料的性能更為優越，本文研究了經過預分散的抗菌納米復合漿料，這種漿料可以很方便地添加到普通水性塗料中，在添加量很少時（ 2wt ）即可達到很好的抗菌效果，此時抗菌率達到99 . 97 。
  19. The coatings are tested comply with the requirements of national standards gb / t 9756 - 2001, the synthesis performance exceed the index of first - rank production, in the same time the average antibacterial rate of these inorganic materials can reach 90 percent. when the weight amount of the inorganic antibacterial powder of ag + and ce2 + reaches 2 percent, the antibacterial rate of the coating is 99. 976 percent

    通過檢測發現，樣品性能完全符合併超過合成樹脂乳液內墻塗料標準中對一等品的要求，同時抗菌效果可達到90 . 0以上，當多孔納米sio _ 2載銀、鈰材料在塗料中的添加量為2 （ wt ）時，改性塗料的抗菌率可達到99 . 976 。
  20. Using nano structured material powder as the coating stuff, laser is employed to remelt the plasma spraying coating basis so that the nano structured powder material could be clad on the surface of the plasma spraying base or infiltrated to the plasma spraying coating

    提出了一種納米改性塗層的復合工藝方案和技術路線。以納米為填料，在激光重熔等離子塗層的同時，將納米材料熔覆在等離子噴塗層表面或滲入等離子噴塗層內部。
分享友人
分享到 Line

分享到臉書