放泄壓力 的英文怎麼說

中文拼音 [fàngxièyālì]
放泄壓力 英文
blow down pressure
  • 放 : releaseset freelet go
  • 泄 : Ⅰ動詞1 （液體、氣體排出） let out; discharge; release 2 （泄露） let out （a secret）; leak （new...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. We established geological and mathematic model for the relief of overthrust fault and earned out simulation computation after selecting factors. the result is that pressure can be released when fault is open. but ft will take a long time for the formation pressure to be relieved to normal formation pressure

    建立了逆掩斷層泄壓的地質模型和數學模型，選取參數后進行了模擬計算，結果表明逆掩斷層活動開啟釋放壓力，但要將地層壓力釋放到正常地層壓力需要時間較長，在斷裂活動時期不足以將圈閉中超壓釋放掉，這是庫車坳陷超壓能夠保存的另一主要原因。
  2. The researches including discharge capacity, pressare properties, cavitation characteristics at some key positions, hoisting load of the gate, configuration of energy dissipator at the exit dentated - sill, and downstream scouring were performed by hydraulic model tests

    藉助系列水工模型試驗對水布埡放空洞的泄流能力、壓力特性及關鍵部位的空化特性、閘門啟閉力、出口鼻坎消能工體型及下游沖刷等進行了較深入的研究、分析。
  3. Test results indicated : with the hoist of altitude, the increase of ice amount and the rise of pollutant, the average flashover voltage reduced. the character exponent generally depends on the insulator profile, ice amount, ice state and pollution severity etc. by means of a high - speed camera, a data acquisition system and high voltage test facilities, a series of the flashover processes on ice surfaces were record. the experimental results form this study and the subsequent theoretical analyses suggested : the thermal ionization of the air in front of an arc root resulted in arc movement ; the electrostatic force had an auxiliary effect of impelling arc propagation ; the electrical

    通過對攝像機、數據採集系統及高壓試驗裝置記錄覆冰絕緣子表面閃絡電弧的發展過程的試驗結果進行理論分析得出：弧根周圍空氣的熱電離導致了電弧的發展，靜電場力對電弧的發展起到了加速作用，電擊穿僅發生在閃絡最終的跳躍階段；通過測量閃絡過程中的放電電壓、泄漏電流、閃絡時間、覆冰水電導率、電弧長度及電弧半徑等參數，得到了不同階段電弧（電弧起弧階段、電弧發展階段及完全閃絡）的發展速度、臨界電弧長度均隨覆冰水電導率的增加而減小。
  4. Sizing, selection and installation of pressure - relieving devices in refineries

    煉油廠壓力泄放裝置的尺寸確定選擇和安裝的推薦作法
  5. Transportation of powdery products. road tankers with pneumatic discharge under maximum pressure 2. 5 bar. coupling

    粉狀產品的運輸.最大壓力為2 . 5巴的帶氣動泄放裝置的道路罐車.聯軸節
  6. All pressure containing parts within one body - bonnet forging ? no joints to leak or welds to cut for servicing

    所有壓力部件都放置在閥體-閥帽鍛件內-沒有可能導致泄露的連接部位；在維護時，不需要切割任何焊接部位。
  7. So the pressure signal of control air holds the single - acting cylinder at the stop position through the pipe named “ supply ”, the 3 - way valve ( pos. no. 22, upper frame ), the double check valve ( pos. no. 72 - 1 ) and the quick release valve ( pos. no. 41, right frame )

    因此控制空氣的壓力信號保持單作用氣缸在停止位置通過管路supply ，三通閥22 ，上位，雙向止回閥72 - 1和快速泄放閥41 ，右位。
  8. Some people, tired out after all exhausting yet satisfying life revolving around work, are anxious to relax in retirement with all the strains relieved ; others resent the prospect of being “ put on the scrapheap ”, and seek alternative outlets for their energies and alternative source of satisfaction or joy

    有些人圍繞工作，勤勉一生，雖心滿意足，卻已然疲憊不堪，渴望著退休放鬆，緩解壓力；另一些人則對即將成為「一個廢物」憤恨不已，繼而另覓他途，發泄過剩的精力，藉以尋找滿意和樂趣。
  9. But, he adds : " i am going to succeed. whether it will be in the first attempt, that i do n ' t know. if i do n ' t, i will try again.

    「熱氣球配備有生命支持系統，如果熱氣球發生壓力泄漏，我就必須放棄，這不是我能控制的」 ，辛加尼亞表示， 「但我仍將再次嘗試」 。
分享友人
分享到 Line

分享到臉書