放電開關 的英文怎麼說

中文拼音 [fàngdiànkāiguān]
放電開關 英文
discharge switch
  • 放 : releaseset freelet go
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 放電 : [物理學] （electric） discharge; electro-discharge; discharging
  1. Secondly the major mechanisms of degeneration of pcss are caused by both the filamentary nature of the current in high - gain pcss damage to the chip of the switch and the charge domain reached the anticathode causes the erosion of metal interface

    開關退化的主要原因是:開關體內的絲狀電流對開關晶元的損傷;以及電荷疇到達陽極時來不及放電而產生的電荷擁擠現象對開關電極接觸表面的損壞。
  2. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨，本文提出了一種通過三極電阻調節模塊和由智能功率模塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制，文中設計了igbt門極驅動脈沖pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  3. The technology of high power constant current charging, high voltage heavy current discharging switch, high speed and high voltage pulse generator, precision synchronization delay, auto control and so on are concretely introduced in this paper

    具體研究了大功率恆流充電技術、高壓大電流放電開關、高速高壓脈沖發生器、高精度延時同步技術及系統自動控制技術。
  4. Nowadays, the switches which are being studied or applied, such as gas spark gap, thyratron and ignitron, etc, are of different structures, operating principles, advantages and disadvantages, and are applied in various situations and fields

    目前處于試驗中或者投入實際應用的開關元件很多，如火花放電間隙、閘流管、引燃管等，它們有不同的結構、原理和優缺點，應用在不同的場合和領域。
  5. And the interfaces have analog input, analog output and digital input / output. we have used differently cards, such as pc - 6330d a / d card, pcl - 728 d / a card based isa bus, ipc - 5375 i / o card and so on. in addition, we select micro - stir switches and pressure sensors as sensor elements to inspect the system and choose relays and induction valves to control the bicycle pump and the motor

    總線採用isa內部總線；介面主要有模擬量輸入介面、模擬量輸出介面、開關量輸入輸出介面等，課題分別選用pc - 6330d型a d板卡、基於isa總線的型號為pcl - 728的d a板卡、型號為ipc - 5375的i o板卡；另外，課題選用了微動式行程開關、壓力變送器作為傳感元件檢測系統，選用繼電器、電磁控制換向閥實現對氣缸、電機的控制；採用vc + + 6 . 0編制控制軟體，實現了纖維鋪放技術的計算機控制。
  6. With the stringent requirement of low output voltage and high output current, semiconductor diode is necessarily replaced by synchronous rectifier to minimum voltage drop. because the existed driving schemes can not drive srs properly, two novel driving schemes for synchronous rectifiers in magnetic amplifier post regulating circuit are proposed in this paper

    已有的同步整流管驅動電路主要面對多路輸出的主輸出電路，而應用磁放大器調節的輔助輸出電路同步整流管的驅動，現有的方法存在磁放大器調節與同步整流管驅動的失配，降低了開關電源的效率。
  7. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  8. Include all types and standards of metal ceramic gas discharge tube s, glass subminiature fuse tubes the company building covers an area of more than 6, 000square meters

    有各種型號規格的金屬陶瓷氣體放電管，高性能的開關放電管，玻璃微型熔絲管等。
  9. The translocation of gq has been proposed as one of the molecular mechanisms to control photoreceptor sensitivity. its role is molecular switch and signal amplification in photo - electro transduction

    Gq蛋白亞基的移位被認為是控制感光細胞光敏性的重要分子機制之一，在光電傳導中起分子開關和信號放大作用。
  10. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  11. The three - order modulator has a 2 - 1 cascaded structure and 1 - bit quantizer at the end of each stage, the modulator is implemented with fully differential switched - capacitor circuits. and then, the discussion will begin by exploring the design of various circuit blocks in the modulator in more detail, i. e., ota, switched - capacitor integrator, quantizer, two - phase non - overlapping clock signal, etc., at the same time, these circuits will be simulated in spectre and hspice. at last, the whole cascaded modulator will do behavioral level simulation by matlab soft and simulink toolbox

    本論文中，首先介紹模數轉換器的各種參數的意義，以及一階sigma - delta調制器和高階sigma - delta調制器的原理;給出解決高階單環sigma - delta調制器不穩定性的方案，引入級聯結構調制器，特別針對級聯結構調制器中的失配和開關電容積分器的非理想特性進行詳細的討論;本設計的sigma - delta調制器採用2 - 1級聯結構和一位量化器，調制器採用全差分開關電容電路實現;同時對整個調制器的各個模塊進行了電路設計，包括跨導放大器、開關電容積分器、量化器、兩相非交疊時鐘等，並利用hspice和spectre模擬工具對這些電路進行模擬測試;最後，利用matlab軟體和simulink工具對整個級聯調制器進行行為級模擬。
  12. The deposit boxes are in electromagnetic tumblers

    放東西的盒子是電磁開關的
  13. If you turn down the volume level of the amplifier too low, the auto power on / off function may activate, causing the subwoofer to enter power saving mode

    您如果把放大器的音量電平調得太低，自動電源開關功能即可能會被激活（打開） ，而使副低音揚聲器進入節電模式。
  14. High voltage shunt capacitor installation is comp - rised of capacitor cabinets or steel racks capacitor, special fuses for capacitor overload protection, capaci - tor discharge device, air - cored reactor which is applied to restrain surge current and high frequency harmonic, zno arrester without gaps for overvoltage - limiting and high voltage vacuum switch etc. capacitor cabinet is

    高壓並聯電容器成套裝置主要由電容器櫃或鋼架電容器電容器過負荷保護專用熔斷器放電裝置專用放電線圈或電壓互感器，抑制涌流限制高次諧波的空芯電抗器和限制過電壓的無間隙氧化鋅避雷器及高壓真空開關
  15. The design and analysis of vertical pnp transistor was accomplished through the relationship between carriers lifetime of epitaxy layer and current gain, rate of surface combination and leakage current, carriers lifetime of epitaxy layer and switch speed

    從外延層載流子壽命與晶體管放大倍數，表面復合率與漏電流，以及外延層載流子壽命與晶體管開關速度等方面對于輸出級縱向pnp管進行了較為詳細的設計與分析，達到了電路中對輸出級縱向pnp管主要參數指標的要求。
  16. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  17. At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique

    最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。
  18. The presented thesis studies the gas discharge of lab6 electrodes, the paper analyses the impacts of gas press and electrodes separation on the ignition voltage and voltage drop, and makes low gas pressure, lower than 10pa, discharge switch tubes, with gas of helium and nitrogen, electrodes gaps of 5mm. the paper studies the tubes ’ discharge performances, and the impacts of discharge process on the electrodes

    分析直流工作條件下，以氬氣、氮氣、氦氣為工作氣體時，氣體的壓強、極間距對著火電壓和管壓降的影響，並製作低氣壓（ < 10pa ）下的氣體放電開關管（放電氣體為氮氣和氦氣，極間距為5mm ） ，研究其在直流和脈沖下的放電特性，以及放電過程對電極的影響。
  19. Whose speed is controlled by frequency converter. when optical switch is on, the feeding begins. after going through the feeding rollers, the material will be straightened by straightening rollers which are driven synchronically

    附膜材料裝于油壓擴張變頻高速的料架上，經光電開關控制放料，經入料輥送入矯正輥整平，
  20. The photoelectric switch controls feeding. the frequency converter adjusts speed

    光電開關控制放料附變頻器調速。
分享友人
分享到 Line

分享到臉書