散失熱 的英文怎麼說

中文拼音 [sǎnshī]
散失熱 英文
dissipated heat
  • : 散動詞1. (由聚集而分離) break up; disperse 2. (散布) distribute; disseminate; give out 3. (排除) dispel; let out
  • 散失 : 1 (分散遺失) scatter and disappear; be lost; be missing 2 (消散失去) (of moisture etc ) be ...
  1. To reduce heat losses the pipes are covered by thermal insulators.

    為了減少,管子外包保溫層。
  2. Smoke has no value in preventing heat-loss.

    煙對于防止沒有作用。
  3. During winter nights and under clear skies, the ground surface is cooled rapidly by radiating heat off to space. the air temperature near the ground will also fall and when the grass temperature drops below zero degrees celsius, hoar frost will form by direct sublimation of water vapour onto the grass surface

    在冬天的晚上,如果天氣晴朗,地面的量會透過輻射快速,貼近地面的空氣也同時降溫,當草面溫度降到攝氏零度以下時,空氣里的水蒸氣便會在草面凝華成為白茫茫的霜。
  4. Hypothermia happens when the body cannot produce as much heat as it loses

    當身體不能產生與散失熱量相同的量時,就會發生低體溫現象。
  5. In winter, losses from a window can be ten or more times the losses through the same area of insulated wall

    冬天,從窗戶量是同面積的保溫墻體上散失熱量的十倍或更多倍。
  6. Insulation used to prevent heat diffusion, as from a steam pipe

    材料用來防止的絕材料,如從蒸汽輸送管上
  7. Via the analysis of heat balance computation model and the computation of online heat balance for industrial coal boiler, this dissertation researched overall input heat, efficient utilized quantity of heat, heat losing of discharge flue gas, heat losing of chemistry and mechanism incomplete combustion, heat losing of dispelling heat of boiler, heat efficiency, air superfluous coefficient, wind speed, wind quantity, computation of primary air circle cutting and whose influence on boiler combustion efficiency

    本文通過對工業煤粉鍋爐平衡計算模型的分析,利用在線平衡計算,研究了總輸入、有效利用量、排煙、化學不完全燃燒、機械不完全燃燒、鍋爐效率、空氣過剩系數、風速、風量及一次風切圓計算以及這些因素對鍋爐燃燒效率的影響。
  8. Thermal exchange is key factor to influence caloric determination, and it will cause temperature dissipation in caloric measuring system during the course of measurement

    測量過程中由於內外桶溫差而導致的交換,是影響準確測的關鍵,必須對此量進行校正。
  9. However carefully boiler casings and steam pipes are sealed, some heat escapes and is lost

    不管鍋爐與蒸汽管封閉的多麼嚴密,還是有一部分損耗掉。
  10. Environmental testing - test methods - tests - tests z bfc - combined dry heat vibration sinusoidal tests for both heat - dissipating and non - heat - dissipating specimens

    環境試驗.試驗方法.試驗z bfc :和無樣品的乾振動
  11. Preventing additional heat loss is crucial

    阻止額外量的至關重要。
  12. Most of what we do in dressing for outdoor activities is attempt to balance heat / moisture retention and heat / moisture loss

    在戶外活動中我們穿衣的目的是試圖平衡量/潮氣量/潮氣保持。
  13. Heat mirror ? ’ s excellent insulating performance can keep temperature difference between two sides of glass unit, thus reduce heat dissipating and accumulating on the inner surface of the glass

    鏡優異的保溫性能使溫差保持在中空層的兩側,從而減少內片玻璃的或積累。
  14. Heat mirror ' s excellent insulating performance can keep temperature difference between two sides of spacing layers, thus reduce heat dissipating and accumulating on the inner surface of the glass

    鏡優異的保溫性能使溫差保持在中空層的兩側,從而減少內片玻璃的或積累。
  15. The biggest fuel savings achieved by a full hybrid vehicle derives from regenerative braking, a technology that captures as electrical power much of the energy normally lost as frictional heat

    高量級混合車最大的省油關鍵來自再生制動(煞車)技術,這種技術可捕集摩擦(通常幾乎掉的能量)並轉變成電力。
  16. In the cloudless night ground temperature decreases on account of the heat lost to the space

    在無雲夜間地面溫度由於其到空間而下降。
  17. The annular space between the outer tube and inner tube is evacuated to virtually eliminate heat loss by conduction and convection

    而介於外管與內管的真空環狀部分是用來減少的。
  18. The different technologies today try to either balance heat retention and heat loss or maximize one side or the other

    現在,不同的工藝有不同的側重點,有的是為了平衡和保持,有的是為了使最大化,有的是為了使量保持最大化。
  19. Environmental testing - test methods - tests z afc : combined cold vibration sinusoidal tests for both heat - dissipating and non - heat dissipating specimens

    環境試驗.試驗方法.試驗z afc :和無樣品冷振動
  20. Assume a furnace will require approximately 24, 000 watts after all heat losses and load factors have been considered. increasing this 24, 000 by 25 % to 50 % gives a wattage requirement of between 30, 000 and 36, 000 watts

    假定在考慮了和負載等因素之後一個熔爐大約需要24000瓦的能量。將這個功率值增加25 %到50 %之後所需的功率在30000瓦到36000瓦之間。
分享友人