整形分頻器 的英文怎麼說
中文拼音 [zhěngxíngfēnbīnqì]
整形分頻器
英文
shaper-divider- 整 : Ⅰ形容詞1 (全部在內; 完整) whole; all; complete 2 (整齊) neat; tidy; orderly Ⅱ動詞1 (整理; 整...
- 分 : 分Ⅰ名詞1. (成分) component 2. (職責和權利的限度) what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] (料想) judge
- 頻 : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
- 器 : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
- 整形 : [電學] reshaping; shaping; [冶金學] coning; [醫學] plastic; reforming; true up; profiling; topiar...
-
This paper studies the variable - voltage energy saving theory and its implementation for asynchronous motor with light load, compares several kinds of scheme of improving efficiency in detail and confirms the variable - voltage energy saving method, that is adjusting the input voltage by detecting the iron loss and copper loss of motor directly. in addition, the directness *, simpleness and availability of the method are verified by the emulational experimental results with simulink of the matlab. the circuit of the general inverter based on the tms320f240 dsp was used in this paper, and the practicable program was compiled
本文分析了異步電動機輕載時降壓節能運行的原理,對幾種提高效率的方案進行了比較,確定了通過直接檢測電動機鐵損和銅損來實時調節輸入電壓以達到高效節能目的的控制方法,應用matlab軟體對系統進行模擬,在基於tms320f240dsp的通用型變頻器上編制了實用化的程序,形成了完整的樣機,對其進行了測試,並給出了試驗結果。The data access pattern is divided into exclusive and sharing, according to the pattern of access and update frequency of the data, three ways are adopted, i. e. the period, update counter and data state to dynamically adjust the frequency and content of data broadcast
將數據的訪問形式分為共用和獨占兩種,根據數據訪問形式以及數據的更新頻率,採用定時、計數以及數據狀態等三種方法,動態地調整服務器廣播更新數據的頻率和內容。After analyzing the noise in the high frequency carrier channel and computing the parameter of channel, we solved the kernel problems of coupling and matched impedance. separate designing the power, power amplification, port, transceiver and other circuits, we fitted together all circuits become the whole lonworks node circuit, and then triumphantly debugged it
經過對高頻載波通道的干擾特性分析和線路參數的計算,解決了耦合和阻抗匹配等核心問題,並對電源、功放、介面、收發器等部分電路分別設計,最後形成了完整的lonworks節點硬體電路,並調試成功。It realizes the functions of storing and transferring the information of fire alarm, displaying time, scanning keyboards, the safe maintenance of system and so on. the part of wireless communication is controlled by at89c2051 mcu, mainly realizing transmitting and receiving data between controller and other detectors. the external signals received by a wireless module are transmitted to mcu through shaping circuit, and the signals of mcu are transmitted by a wireless module through tone modulation circuit
人機交互部分以單片機c8051f020為核心,為用戶提供一個良好的操作環境,實現了火災報警信息的存儲及調用、時間的顯示、鍵盤的掃描、系統的安全維護等功能;無線通信部分由單片機at89c2051來控制,主要實現控制器與其它探測裝置之間信號的無線發射和接收,無線通訊模塊接收到的外部信號經過整形電路送入單片機,單片機發出的信號經過音頻調制再由無線通訊模塊發送出去,這樣實現了數據的無線傳輸;本文還從節能的角度出發,兼顧性能的可靠性,提出了一種合理的無線火災報警的信息傳輸模式。There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor
本文利用s7 - 200plc自身的特點設計了頻率測量單元,根據pid調節各個環節的特點,以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同,利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路,實現了水輪發電機組頻率的測量;在軟體上,對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析,選用改進的pid演算法實現了變參數、變結構的pid調節模式;調速器的機械液壓隨動系統具有步進電機電液轉換元件,採用五相反應式步進電機,根據其驅動特性設計了變頻調壓驅動器,實現plc與步進電機驅動器之間數字介面。Then the paper designed for cable modem frame by using a kind of top grade special cpu and an asic, when analyzing the hardware architecture, and finally formed the entire hardware system by integrating flash, dram, eprom, and e2prom memories, ethernet, rs232 interfaces, and high frequency circuit
然後分析了硬體環境,論文中給出了利用一種高檔專用cpu和一塊超大規模asic為基礎設計出cablemodem的框圖。然後加上flash 、 dram 、 eprom 、 e2prom存儲器,以太網、 rs232介面,以及高頻頭電路,最後形成cablemodem的完整硬體系統。At this time, the approximate mechanical model of devices has been put forward, which frequency is 70 mhz, then we analyzed the euler ? bernoulli equation, find that the frequency is determined by the resonator ’ s density thickness and length ; the free - free - beam 、 coupled beam 、 support beam 、 transducer have been designed ; the model was simulated and modal analyzed on the coventorware and were consistent with the designed parameter. the silicon surface microfabrication process was developed and emphatically introduced several key surface microfabrication technologies, and was simulated by coventorware
本文通過分析歐拉-貝努立方程,得出濾波器的共振頻率主要由諧振梁的密度、厚度和長度決定,考慮切變形和轉動慣量的情況下,完成微機械諧振梁、支撐梁、驅動電容的設計;在coventorware軟體上進行模擬,分析結果與理論設計比較好地吻合;對微機械濾波器的加工工藝進行設計,給出器件的完整的工藝流程,重點介紹微機械表面加工工藝,並在coventorware上進行模擬。With the conduction property of the triggered thyristor and the intellective numerical controlled frequency reduction of the triggering pulse by mpu, we can divide alternating current into several complete sinusoidal waves to supply some loads. it can be made as a controller or a pcb ware, which is suitable for the air conditioning, machine tool and various instruments that require electric power or rotate speed adjustment
利用晶閘管的觸發導通特性,用單片機對觸發信號進行智能數字降頻,可在交流電中切分出部分完整的正弦波形供負載使用,可以單獨做成一臺控制儀器或者作為一個控制電路板用於需要電功率和轉速調節的空調、機床以及各類儀器設備中。It also gives the motive of the ka - band vco and mixer, associated with the subject ' s requirement and the realistic conditions, according to which a proposal is confirmed that the gunn diode and the varactor are mounted in the same cavity to fulfill the vco and an antiparallel diode pair is used to fulfill the harmonic mixer. in chapter 2, based on the basic theory of negative resistance oscillating, we analyses the gunn oscillator and it ’ s tuning character. chapter 3 introduces the theory of millimeter - wave harmonic mixer
以此為根據結合課題需要和實驗室的實際條件,確定vco採用耿氏管腔體振蕩器形式,變容管與耿氏管安裝在同一個腔內以進一步減小體積,採用反向並聯二極體實現諧波混頻;第二章介紹負阻振蕩器理論及其調諧原理;第三章介紹毫米波諧波混頻器基本原理;第四章給出了振蕩器及諧波混頻器的設計過程,整個組件聯調的結果;最後是結束語,分析了電路中存在的問題,指出了改進方向。Comparing with conventional nyquist converters, - converters greatly release the requirements for high performance of analog circuit and precisely matched components. additionally, these converters exploit the enhanced speed, circuit density and low cost of modern vlsi technologies. currentlly, - adcs have been widely used for audio a / d conversion
- adc採用過采樣噪聲整形技術實現高精度模數轉換,和傳統的nyquist率模數轉換器相比,避免了對模擬電路性能指標和元器件匹配精度的較高要求,並可充分利用現代vlsi的高速、高集成度、低成本的優點,已成為音頻模數轉換的主要技術。A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built
以ansys有限元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上,對不規則形狀的換能器採用了有限元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況,使換能器的諧振頻率與導管的諧振頻率達到了較好的匹配,使設計變得更加容易和準確;利用有限元方法建立了振子的等效電路模型,求出了其前6階模態的等效動態電容電感值,為阻抗匹配和驅動電路的設計提供了依據。Through analyzing strata ' s absorbtion and attenuation, the specialty of ssf in system - one ( two ) and 24 - bit a z a / d, the scheme to improve the data acquisition system is brought forward including the design of multiple differential spectrum equilibrium filter ( mdsef ) and program control amplifier
通過詳細分析地層的吸收衰減特性, system - one ( two )頻譜整形濾波器及24位a d的特點,對現有採集系統提出了改進方案。其中包括對多級微分頻譜均衡濾波器的理論設計,程式控制型前置放大器的理論分析與設計。This paper focuses on the analysis of sigma delta modulation theories such as mathematics models, noise shaping characteristics, etc. combined with traditional pll fractional - n synthesizers structures, a project of sigma delta modulator is proposed, and the algorithmic analysis is implemented by fpga
本文在闡述-調制理論,分析其數學模型,噪聲整形特性基礎上,結合傳統小數分頻合成器,提出了-調制小數分頻鎖相環頻率合成器實現方案,及其在fpga里的調制器演算法。分享友人