整流電動機 的英文怎麼說

中文拼音 [zhěngliúdiàndòngjī]
整流電動機 英文
commutating motor
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 機 : machineengine
  • 電動機 : electric motor; motor （俗稱「馬達; 電滾子」）電動機並聯法 parallel connection of the motors; 電...
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  1. Commutating electromotive force

    電機整流電動勢
  2. Commutating pole motor

    整流極電動機
  3. The thesis is devoted to exploiting a permanent magnet synchronous machine ( pmsm ) for the parallel hybrid electric vehicle ( phev ). three parts are included as follows : at first, in the electromotor state, the current control strategies of pmsm are determined. giving the elementary method for solving the contradiction between enhancing the pmsm ' s flux - weakening capability in the electromotor state and reducing the pmsm ' s connatural adjustment ratio in the dynamotor state

    本課題的研究工作主要圍繞開發一臺並聯式混合動力電動汽車（ phev ）用永磁同步電機（ pmsm ）展開，所作的工作主要包括以下幾個部分：首先，確立了phev用pmsm電動機運行狀態時的電流控制策略，針對pmsm在電動機運行狀態時提高弱磁擴速能力和在發電機運行狀態時減小固有電壓調整率的相互矛盾，提出了初步的解決方法。
  4. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為負載，模擬機車運行，對機車的主發電動機的電流、電壓和柴油機的轉速等參數進行檢測，並對檢測結果進行處理，計算出模擬機車運行時的功率，並以此為依據，對機車的工作狀念進行判斷，通過水阻試驗，調整有關參數，使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  5. This strategy effectively solves the power distribution between the apu and batteries during the drive of the heb. the power control model and multi - torque switching strategy of the driving motors control the charging - recharging current of the batteries within a wide range, which contribute to the improvement of the efficiency

    該策略很好的解決了車輛行駛時輔助動力系統與蓄電池組之間的功率分配，並且驅動電動機採用功率控制模式以及多級動力輸出切換策略，有效的控制了蓄電池的充放電電流，從而提高了整車效率。
  6. Alternating - current commutator motor

    交流整流子電動機
  7. Double commutator motor

    雙整流子電動機
  8. Ac commutator motor

    交流整流子電動機
  9. Basically learn dc, alternating current way, lighting circuit, distribution circuit, transformer of odd, three - phase, dynamo job principle reachs operation method, the principle maintenance of electromotor of single - phase, three - phase reachs application, low - pressure electric equipment, electric power procrastinates move, electromotor maintains skill, brilliant brake canal can accuse rectification, electrical engineering appearance, the electron controls a technology, circuit of new light source, engine, principle of distribution ark job and installation technology

    主要學習直流、交流電路，照明電路，配電電路，單、三相變壓器，發電機工作原理及操作方法，單相、三相電動機的原理維修及應用，低壓電器，電力拖動，電動機維修技巧，晶閘管可控整流，電工儀表，電子控制技術，新光源電路，發動機，配電櫃工作原理及安裝技術等。
  10. Phascon technology introduced in this paper is to improve the outer operation parameters of ac motor, by on line detecting the motor phase angle between current and voltage to adjust the input supply voltage to the motor, to realize the flexible power management mode for ac motor, so as to increase the operation efficiency and reach energy - saving purpose

    本文闡述的相控技術是從改善電機外部運行參數入手，通過實時檢測電動機運行相位角來調整電機的輸入電壓和電流大小，實現柔性化能量管理模式，提高電機效率達到節電的目的。
  11. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念，建立了正弦脈寬調制（ spwm ）逆變器供電異步電動機，考慮主磁路飽和時的變頻調速系統整體數學模型，模擬系統的低頻振蕩；其次從逆變器-異步電動機系統能量轉換角度出發，提出通過檢測逆變器輸入電流中負電流的間隔時間是否大於1 / f _ c （ f _ c為逆變器載波頻率）來判定系統是否出現低頻振蕩；最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
  12. Duplex power feed type a. c. commutator motor

    並聯饋電整流式交流電動機
  13. Apu system, ac induction motors driving system, multi - torque output system, regenerative braking system and battery management system make of the hybrid system. all the subsystems are integrated systematically by the multi - energy resource management system

    輔助動力單元（ apu ）控制系統、矢量控制交流調速驅動電動機的制動能量回收系統以及多級動力輸出管理系統和電池管理系統組成了整個混合動力系統。
  14. Based on comparison of several motor candidates, doubly salient permanent magnet ( dspm ) motor is a good choice for it ’ s outstanding performance. similar to conventional drive system, dspm brushless dc motor ( dspm - bldcm ) is composed of dspm motor and it ’ s controller. the controller is made up of three - phase full - bridge inverter, driver, dsp control unit and etc. for high power system, every switch of three - phase inverter is actually made up of four mosfets in parallel

    在充分考慮國內外不同的液壓泵電動機的基礎上，本文選用了雙凸極永磁電機作為整個系統的電機本體，並配以電動機控制器（控制器包括三相橋式功率變換器、驅動電路、 dsp主控單元、電流采樣及預處理和位置采樣及預處理等主要部分）組成整個液壓泵電動機系統。
  15. Based on designing the models of cutter and dc motor, this paper introduces how to match the characteristic between cutter and dc motor, then analyzes the principle of speed regulator, relay control system and thyristor bridge in the cutter driver system and designs a simplified model. in the end, a small simulation program is provided to demonstrate how to work in cutter driver system model. 4

    在設計絞刀和直流電動機的模擬模型的基礎上，提出了絞刀與直流電動機特性的匹配方法，然後分析了調速系統、可控硅整流系統和繼電器控制系統的工作原理，設計了簡化的模擬模型，最後提供了模擬程序的實例； 4 、液壓系統。
  16. Experiments including resistance load experiment, inverter experiment, dynamic experiment and motor load experiment are carried out with high power supply quality rectifier

    建立了一套完整的實驗系統，對高品質整流電源進行了帶電阻負載實驗、逆變實驗、動態實驗和帶電機負載實驗。
  17. Hydraulic fluid power. positive displacement pumps, motors and integral transmissions. determination of steady - state performance

    液壓流體動力.正排量泵電動機和整體式傳動裝置.穩定狀態性能的測定
  18. It can improve the utilize of power by fed back the power generated by motor machine to power - net, has the benefit of improving power factor, reducing the harmonious feeding back to the power - net and can enhance the performance of converters for the constant voltage of dc - link

    該裝置能夠提高電能的利用率，把由電動機產生的再生能源回饋到交流電網，並且能提高裝置的功率因數，減少對電網的諧波污染。由於pwm整流，變頻器中間直流環節的電壓能保持穩定，提高了逆變器的調速性能。
  19. Based on analysis and contrast of the whole operating process from driving to reverse connect braking and regenerative braking for pmdcm, reverse connect braking has some characteristics of great phase currents and not returning energy

    摘要對永磁無刷直流電動機從電動運行過渡到反接制動或回饋制動運行的整個過程進行了計算和比較。
  20. The key point of this paper is to describe the design of hardware in the analog and digital control systems and the way to improve its performance

    然後介紹了本文的研究重點，永磁無刷直流電動機模擬控制系統和數字控制系統的硬體整體設計，以及改進方法。
分享友人
分享到 Line

分享到臉書