數字模擬型 的英文怎麼說

中文拼音 [shǔxíng]
數字模擬型 英文
digital-analogue type
  • : 數副詞(屢次) frequently; repeatedly
  • : Ⅰ名詞1 (文字) character; word 2 (字音) pronunciation 3 (字體) form of a written or printed ...
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • 數字 : 1. (表示數目的文字; 表示數目的符號) figure; digit; numeral; character; numeric character 2. (數量) quantity; amount
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. The thesis centered on the topic. a fluid drive program of the sugarcane mill is made. it is a must to have the digital simulation study on the hydraulic system

    本文圍繞研究課題,展開研究工作,制定了甘蔗壓榨機的液壓傳動系統方案,建立其,並對進行了靜、動態特性研究。
  2. By thorough analysis and synthetize this paper made a frame of the system of intelligent instrument and its hardware structure. as followed, this paper depicted design details of intelligent instrument " s hardware, it included the design of interface circuit, data commutations and digital logic of dsp, mcu, internet ' s chip and isp ' s apparatus etc., and have designed schematic map and circuit. so it accomplished the full design of hardware / software of the new type intelligent instrument

    本文具體給出了新智能儀器硬體結構及實現,描述了智能儀器硬體設計細節,包括信號處理器、單片機、 internet接入晶元、可編程/器件等在新智能儀器中的介面電路設計、據通信設計和邏輯設計等,詳細地給出了設計原理圖和電路圖;給出了新智能儀器的軟體設計細節,從而完成了新智能儀器完整的軟硬體設計。
  3. Based on the simulation system software, navigation and guidance real - time digital simulation system are developed to simulate the whole real - time flight control and guidance process

    本文利用vpm平臺,建立運載火箭迭代制導系統的導航和導引,形成塊化的系統。
  4. In this paper, the mathematics model and simulation model of the passive landing gear shock absorber was built, and was verified by drop test. aimed at acquiring suitable efficiency diagrams, two simple semi - active control algorithms were designed. the mathematics model and simulation model of the semi - active landing gear shock absorber was built

    在本文中,建立了被動控制起落架緩沖系統,並通過落震試驗對該進行參校驗;以合適的功量圖為控制目標設計出兩種半主動簡單控制律,建立了半主動控制起落架緩沖器;通過對這兩種控制方法進行了比較,認為半主動控制較被動控制有很大的優越性。
  5. Finally, the algorithm model of six modules ( space - calibration, time - calibration, spot - track ' unite, track ' s origination and expiration, the form of tracking - door and association algorithm ) are founded. the effect of some modules to tracking result are studied and their intimated results are gained. the intimation result of centralized - system and distributed - system are compared in the end

    建立了空間校準、時間校準、點跡合併、航跡起始與終結、跟蹤門判斷和互聯演算法六個塊的演算法;通過,探討了某些塊對跟蹤結果的影響並給出相應的結果。
  6. Taken yanjia river watershed as an example, this study extracted watershed digital characters from dem, and simulated rainfall - runoff with the rainfall - runoff model based on gis and wms. the main contents and results include : ( 1 ) the building of the spatial database of watershed

    本研究應用地理信息系統和wms系統,以三峽庫區晏家河流域為例,由dem提取流域特徵,再與降雨徑流有機結合進行了降雨徑流研究,主要的研究內容和結果包括以下幾個方面: ( 1 )建立了流域空間據庫。
  7. Hybrid integrated circuits detail specification for type hda030 linear 12 bit digital to analog converter

    混合集成電路. hda030線性12位轉換器詳細規范
  8. According to the characteristics of the circulating water loop of waigaoqiao power plant during unit ' s start - up, the control model was established, and a software was adopted to carry out digital simulation for the model

    摘要針對外高橋電廠啟機階段給水循環迴路的特點建立控制,對建立的進行
  9. According to the requirements of real - time simulation, this thesis build the independent models of missile weapon systems for numerical simulation considering the independence and coupled relations of physical subsystems or parts and try to reduce the coupled degree. the main content of this thesis include : firstly, the missile weapon systems are divided into several subsystems according to function, and the interface protocols between subsystems

    本文針對實時的要求,以具有清晰的物理概念和足夠的物理獨立性的物理系統或部件為基礎,充分考慮導彈各子系統塊的相對獨立性和耦合性,盡可能的降低塊間的耦合程度,建立整個導彈武器系統的,用於導彈武器系統的
  10. The criterion that is based on nonlinear mode of transformers can better reflect the state of transformers that have been proved by academic analysis and empt emulation

    該勵磁涌流判據採用了變壓器非線性,能更好的反映變壓器的工作狀態,論文用理論分析和作了詳細證明。
  11. Dynamic analysis and digital simulation of typical motion process for mechanical system

    機械繫統典運動過程動態分析與
  12. First of all, an accurate wecs model with its control system is the base of all the following studies. in the dissertation, an integral wecs model is built using digital simulation software matlab

    高效而準確的研究工具是后繼控制策略研究的基礎,因而也是第一步必須完成的工作,本文選用mathworks公司的工具matlab建立了包括控制器在內的風能轉換
  13. The control algorithms of both traditional and intelligent main - engine speed regulator are emphatically discussed in the thesis. the author established an simplified integrated mathematical model for marine main diesel engine, screw propeller and axis series with the mother type of large low speed diesel man b & w. the digital simulations for pi speed regulator are completed

    本文討論了主機速度控制的兩種實現方法;論文以實船應用的manb & w大低速柴油機為母,建立了柴油主機、螺旋槳、軸系一體化的簡化,並對常規柴油主機pi調速系統進行了
  14. Delay is obvious in large body because of its inertia, moment force, stress and gearing. transfer of electical cell increases the delay. this paper points out that the delay can be compensated by using the smith control algorithm. the result of computer emulation proved that a better quality is gained by using the algorithm on heavy nc machine

    大慣量物體,由於其慣性,加之傳動鏈長,所需的扭矩大,引起的應變大,加上電氣轉換元件的滯后,故滯後效應明顯.該文提出用史密斯控制演算法將滯后進行補償.計算機結果說明,對大慣量有滯后的重控機床,應用該演算法能得到較好的控製品質
  15. The numerical simulation method based on the strip - yield method has begun to be used in the air space structures, but not used in the fatigue questions in the submarine

    基於帶狀屈服方法在航空航天結構上已經開展運用,但尚未用於潛艇結構疲勞斷裂問題。
  16. The numerical simulation technique is used to study on the fatigue properties of submarine with high strength steel. the numerical simulation model is established and its feasibility is validated. at last, the possibility of establishing a kind of calculation and design methods of fatigue life in submarine structure is primarily analyzed

    本文把疲勞裂紋閉合通過切片合成法引入到潛艇結構疲勞強度計算上來,建立了潛艇結構疲勞強度的計算的,分析該方法在潛艇結構疲勞強度計算上應用的可行性,為建立一套計算和設計潛艇結構疲勞強度的方法作了初步的探討。
  17. Deducing the transfer function of the system, one controller is constructed and it has the wide frequencies isolation performance and zero force transfer rate. the active vibration isolation simulation is made and the results show that the two - stage isolation mounting with the controller constructed using the method mentioned in this paper has perfect isolation property and this provide new way for controller design. 4

    通過對雙層隔振振動主動控制系統的力傳遞函的深入研究,構造了一種具有寬帶隔振性能的理論上具有零力傳遞率的控制器,並進行了研究,取得了理想的效果,為振動主動控制控制器的設計提供了新的思路。
  18. Distributed and basic common models of radar system and radar jammer are detailed desig ned and programmed running in general digital computers

    設計和開發了雷達系統、雷達干擾系統、雷達抗干擾技術及其系統動態對抗的雷達電子戰的庫。
  19. The feasibility of the technique is examined by using compute simulation and flutter testing of aeroelastic models in low - speed wind tunnel

    及氣彈低速風洞顫振試驗據驗證,取得了滿意的效果。
  20. According to the tracking principle being exploited, we make the simulation plan and flow chart, and emphasis on discussing the facts that the tracking receiver in antenna systems affects the capturing and tracking systems. the data simulation model of the tracking receiver is built up. using matlab simulation, we verify the fact, investigate the accuracy factors and finally conclude all in practice

    在自動跟蹤系統中,跟蹤接收機作為核心控制單元,根據所採用的跟蹤方式的原理,制訂方案,確定流程,重點討論了天線系統跟蹤接收機性能對捕獲跟蹤系統的影響,研究並建立了跟蹤接收的,通過matlab軟體系統進行了分析和驗證,研究了各種參對系統精度的影響,得到了有實用價值的結果。
分享友人