數據控制間隔 的英文怎麼說

中文拼音 [shǔjùkòngzhìjiāngé]
數據控制間隔 英文
data control interval
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 據 : 據Ⅰ動詞1 （占據） occupy; seize 2 （憑借; 依靠） rely on; depend on Ⅱ介詞（按照; 依據） according...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 隔 : partitionseparate
  • 數據 : data; record; information
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 間隔 : interval; space; spacing; blanking; blank; region; distance; gap; intermission
  1. Then following reality constituent of engine and connecting component interface, a nonlinear signal cylinder engine model has been created, though fire interval and fire order, a control - oriented four cylinders engine is build. following dynamometer is seen as load, performance of engine is simulated and researched under the condition of constant torque and speed, validation of the math and simulation model have been confirmed by comparison result between simulation with test result of engine performance simulation software dyno

    按照發動機的實際組成，根據各部件的介面類型連接模型庫中的部件，建立了單缸發動機非線性模型，在此基礎上，依據發動機實際發火間隔和順序，建立了面向控制的四缸汽油機模型，並以測功器為負載，通過恆轉矩和恆轉速方式進行了發動機性能模擬和研究，模擬結果和發動機動力性能模擬軟體dyno測試結果的對比驗證了數學模型和模擬模型的正確性。
  2. The characters, advantages, domestic and foreign status and developing direction of virtual instrument, are inroduced briefly. and the design process of control software of hptimi in the environment of labwindows / cvi is also presented. the primary data exchang mechanism among the contol units of hptimi and the corresponding program flow charts and their programmimg approaches are expatiated

    論文通過簡單分析虛擬儀器的特點及國內外研究現狀和發展方向，詳細闡述在labwindows / cvi環境下，高解析度時間間隔測量儀控制軟體設計過程，說明其主要的數據交互機制，給出相應的程序流程圖和編程方法。
  3. According to the test conditions, the double polarity inputting mode is adopted in the circuit of voltage - frequency converting part ; storage batteries are used in the optical emission part of optical fibre isolating and transmitting device, that can guarantee isolation between the main circuit and the testing system ; the 89c51 singlechip is used in the singlechip testing - controlling unit, the peripheral circuits are extended, data are transmitted through the serial port in this part ; the p opular software delphi5. 0 is used in the pc part, the communication between singlechip and pc by serial port, plotting of current wave, regulation of data ; the optical - electrical isolating and triggering are used in the controlling part, this can guarantee the veracity and reliability of breakers triggered, this triggering mode is also used in the triggering of the main closing breaker, the tested breaker and the assistant breaker, the triggering signals are sent out by a singlechip

    壓頻轉換部分電路中根據實際情況採用了雙極性輸入方式；光纖隔離傳輸裝置的光發射部分電源採用了蓄電池供電，確保了主迴路與測試迴路的完全隔離；單片機測控部分採用了89c51單片機，擴充了外圍電路，通過串口向pc機傳送數據； pc機與單片機之間的串口通訊、波形繪制、數據管理等都採用了軟體delphi5 . 0編寫。該測試系統中預留了輸出口，可以對合成迴路中的主合閘開關、被試開關、輔助開關進行觸發，信號由單片機發出，控制部分採用了光電耦合隔離觸發的方法。軟體設計主要集中在對電流信號的數據採集、數據處理、數據傳送、人機界面、波形繪制和數據管理，軟體部分又可分為單片機和pc機程序設計兩大部分。
  4. In the time - domain, based on the principle of random sampling of dso. two way ( " time amplifing in dual slope integral " and " time - voltage convert " ) are implemented to measure the time between the system triger and writing clock. thus random sampling interpolate can be done to measure repeated signal in high frequency with the a / d convert and controller which frequency are lower

    在時域，根據數字示波器隨機取樣原理，用兩種方法（雙斜率積分時間放大測量方法和時間? ?電壓轉換測量方法）測量數字示波器系統觸發和采樣寫時鐘間時間間隔，用低速a / d轉換器及控制器進行模?數轉換和控制，以此進行隨機取樣內插，從而實現了對高頻率重復信號的測量。
  5. This system is developed based on high performance, low cost and many controllers inside of the embedded processor, and enlarged gpio for the plat of the hardware and software. this system is applied to the high - speed numerical control carving machine. show the operate interface by lcd, input the control code from the keyboard, the data is readed from the usb interface and store that in sdram

    本系統應用於高速數控雕刻機，以lcd為人機可視化操作界面，以編碼鍵盤為操作控制部分，以嵌入式處理器s3c44b0x晶元為核心，文件數據經usb口讀取u盤中的雕刻數據文件暫存於sdram中，經嵌入式處理器進行相關演算法處理，得出相應參數傳送到fpga ，由fpga控制輸出脈沖和脈沖間延時，通過高速光耦隔離（ 2mbit / s ）后輸出，控制步進電機的運轉。
  6. The distribution network automated system ( das ) is a management information system, including computer software and hardware technology, the computer network technology, the automatic control technology, the data communication technology and electrical power system technology, and it is utilized to acquire the data from power distribution network, monitor operation, position breakdown fast, isolate the failure, restore the power supply and administrate need, what ’ s more, it reduces the time of power cut effectively, improve the reliability and quality of power supply

    配電自動化系統（ das ）是集計算機軟硬體技術、計算機網路技術、自動控制技術、數據通信技術及電力系統相關技術於一體的信息管理系統，為配電網路的數據採集、運行監視、快速故障定位、故障隔離、供電恢復以及需求側管理等提供了有力的技術手段，能夠有效地縮短事故停電時間、提高供電可靠性、改善供電質量。
  7. To order to solve above problems, we design a novel rate - based multicast congestion control scheme - rbmcc, which uses the active explicit congestion indication and representative - based feedback control scheme to inform the source of the status of the network, and alternate the send rate by adjusting the packet intervals between packets. the goal of the dynamic congestion control algorithm is to make the entire system responsive to the changes as rapidly as possible in the offered loads or available bandwidth without getting into an oscillating behavior

    針對上述演算法中存在的動態性、靈敏性以及由之引起的公平性等問題，本文第3章設計了一種新的基於速率的組播擁塞控制機制? ? rbmcc ，該演算法利用積極的顯式擁塞指示，基於代表的反饋機制，通過調節包與包的發送間隔來改變數據的發送速率，動態地自適應網路擁塞狀態的改變。
  8. Control sending tcp keep - alive packets and the interval at which they are sent

    控制tcp keep - alive數據包的發送以及發送間隔。
  9. In view of hardware design proposal on a new detection controller in the vertical drilling system based on the single chip microcomputer of c8051f020. two typical structure of software design flow of detection controller is description and the fixed time gap detection control and variable pressure gap of the data storage method is given in this paper

    針對基於c8051f020實現的一種新的垂鉆系統監測控制器硬體設計方案，給出了兩種典型結構的檢測控制器的軟體設計流程，提出了固定時間間隔檢測控制和變壓力間隔的數據存儲方法。
  10. Personal firewall usually is loaded in the computer operate system, takes the place of the operate system to control the access of network, and then controls the link between user computer and internet successfully in the end

    個人防火墻可以根據用戶的要求隔斷或連通用戶的計算機與internet間的連接，用戶可以通過設定規則來決定計算機與internet間的數據傳輸。個人防火墻通常直接切入用戶的個人操作系統，並接管用戶操作系統對網路的控制，從而達到控制用戶計算機和internet之間的連接的目的。
分享友人
分享到 Line

分享到臉書