料層厚度控制 的英文怎麼說

中文拼音 [liàocénghòudùkòngzhì]
料層厚度控制 英文
bed level control
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. Because of the restriction of the performances of the infrared materials, we decide that the hollow waveguide should have the structure of single layer dielectric coated metallic film according to the general analysis of process controllability and transmission capability. the dielectric we choose is silver iodide, made from silver and iodine, and the optimum thickness is about 0. 77um

    因材料性能的限制，通過傳輸性能以及工藝可控性綜合分析，確定製備的空芯光纖為單層電介質塗覆金屬膜結構，電介質膜定為碘化銀，理論厚度為0 . 77 m左右，由銀膜直接碘化得到。
  2. The numerical simulation equations of the border curves in term of and as well as the matching rules and the frequency dependence of microwave electromagnetic parameters of a broad - band homogeneous absorbing coating with a finite value of reflection loss are available. these results pointed out the direction to develop rams ". according to the radar - absorbing model, the optimized design of rams with thin - layer, light - weight, broadband and strong - absorbing is available by the simple genetic algorithms, which can effectively conduct the research work of rams to the detail. small but completely, the electromagnetic parameter ' s databases of rams that based on actual microwave absorbers have been set up, the object function has been constructed which conform to the involved goals, the adaptive coding measure is taken which extends the coding length dynamically adapting to the condition of the number of actual absorbers or the precision of thickness and absorber - volume - percentage, the decoding technique is initiated which satisfies light - weight and strong - absorbing as well as thin - layer and broadband by adopting of tracing variable restricting conditions dynamically to control total thickness. when decoding, the variable restricting conditions of thickness are dynamically traced, so gain the radar absorbing coatings of light - weight multiple - layer single - ingredient. similary, of thickness and absorber - volume - percentage, of light - weight multiple - layer multiple - ingredient. also, the rams ' demand to radar - absorb performance as frequency is met making use of the penalty function

    作為遺傳演算法的具體實施：根據本實驗室近來研製的吸波材料，建立了吸波材料的相關數據庫；構造了能真實體現「薄、輕、寬、強」優化目標的目標函數；根據材料的實際數量以及塗層厚度精度要求、吸收劑體積分數精度要求，建立了能動態擴展相應碼長的自適應編碼方法；首創了通過動態跟蹤變量的約束條件來控制塗層總厚度的解碼技術，以此實現了在不弱化寬頻、高強的吸波性能目標的同時，兼顧到薄層、輕質的使用性能要求；在解碼時通過動態跟蹤厚度變量的約束條件，實現了多層單組分吸波塗層對重量輕的要求；通過動態跟蹤厚度變量的約束條件和吸收劑體積分數的約束條件，實現了多層多組分吸波塗層對重量輕的要求；使用權重系數變化法，實現了吸波塗層的分頻段吸波性能要求。
  3. The membrane layer is formed by the vacuum forming technology. by controlling the weight and the ratio of long path of ceramics fiber, changing the operation factor reasonably of vacuum forming, we can obtain the ceramic fiber composite membrane layer, which has pore diameters of about 5 to about 30um, porosity i s 50 - 80 %, and tensile strength is about 4. 1to 18. 1mpa and thickness of membrane layer is 0. 5 - 2 mm, has the good thermal shock resistance and peal off

    膜層採用真空抽濾成型工藝，通過控制膜組分中陶瓷纖維長徑比、纖維加入量、成型時料漿濃度、成型壓力及成型時間等可以獲得膜孔徑5 ? 30 m 、氣孔率50 ? 80 、抗折強度4 . 3 ? 18mpa 、膜層厚度0 . 5 ? 2mm 、具有良好熱性能和耐剝離性能的陶瓷纖維復合微濾膜材料。
  4. The influence of the bonding layer thickness and material properties, piezoelectric layer thickness, placements and feed - back control parameters on the vibration suppression are investigated

    分析了粘彈層、壓電層厚度和壓電片位置等結構參數變化以及材料參數變化對控制效果及結構頻率的影響。
  5. The system identification method is presented for backcalculating the dielectric property and thickness of pavement structures. the method of singular value decomposition is put forward to diagnose the ill - conditioned governing equation and the problem of finding solution to ill - conditioned governing equation is successfully resolved. the parameter adjustment arithmetic with high accuracy, which is based on precise theory and can be converged rapidly, is established

    提出了路面結構層介電特性及其厚度反演分析的系統識別方法，將奇異值分解技術應用於控制方程的病態診斷和求解，有效地解決了控制方程病態時的求解問題，建立了理論嚴謹、收斂快、精度高的模型參數調整演算法，並開發了路面結構層材料介電特性及其厚度反演分析軟體sidthk 。
  6. To control the settlement of roadbed, the degree of compaction regulated by current criterion is not enough, the mechanics parameter of filler compacted - - deformation parameter should be considered and dual control criterion should be put in practice. to get upper deformation parameter of xigeda stratum filler, the percentage of mudstone should be controlled. the thickness of filling layer regulated by current criterion can be increased if the compaction car has proper function

    通過此次研究，獲得了對路堤變形問題的新的認識，即為了控制路堤的沉降變形，不僅應滿足現行規范中規定的壓實度標準，還應該引入填料壓實后的力學參數? ?變形模量值標準，實行雙重控制標準，而對于昔格達地層這種混合填料，為了獲得較大的模量值，應該控制填料中泥巖的含量；現行公路路基施工規范中對路堤填築時分層填築厚度的規定值，在壓實機具功能滿足的條件下，可以適當提高。
  7. Protein a and styrene - butadiene - styrene ( sbs ) were selected as sensing membrane to cross iink antibodies ; sbs, poiyvinyi chloride ( pvc ) and poiystyrene ( ps ) are polymers and have many advantages such as easiiy obtained, convenientiy forming membranes and easi1y modified by the introduction of other functional groups. pvc. ps and sbs were used as precoating materials for immobiiizing antibody in our experiment

    選擇了兩種固定生物大分子的敏感膜：首先，從具有原料易得，成膜方法簡單，可以進行表面改性等優點的聚氯乙烯、聚苯乙烯、聚苯乙烯-丁二烯-苯乙烯共聚物三種高分子中選擇出成膜迅速、均勻、膜的穩定性好、響應迅速、而且易於控制塗層厚度等優點的聚苯乙烯
  8. In addition, the coverage and number of carbon layers in cca can be easily controlled by changing the sucrose content in the precursors and the impregnation times

    在這種復合材料中，碳層厚度可控制為一個石墨單層的厚度，且碳的覆蓋度及層數可以通過改變浸漬的蔗糖量及浸漬次數來進行調控。
  9. It is shown that vibration suppression efficiency of these kind of treatments depend much more on the viscoelastic layer thickness, material properties and the piezoelectric layer thickness. secondly, a linear quadratic regulator and output feedback are used to actively control vibration. it is shown that placing the active element on the opposite side of pcld or underneath pcld is capable of vibration suppression with lower control effort and more inherent damping

    定義了主被動混合阻尼結構控制性能指標：被動抑振性能指標、主動抑振性能指標、控制能量指標和控制力性能指標；然後，基於狀態反饋最優控制律，根據定義的控制性能指標分析粘彈性阻尼層厚度、粘彈性阻尼材料參數、壓電作動層厚度對主被動混合阻尼結構振動控制性能的影響，得到了一些有價值的結論。
分享友人
分享到 Line

分享到臉書