斜向扭曲 的英文怎麼說
中文拼音 [xiéxiàngniǔqū]
斜向扭曲
英文
oroclinal warping-
[ align = center ] [ img = 390, 525 ] http : / / www. blueidea. com / articleimg / 2006 / 04 / 3425 / 07. jpg [ / img ] [ / align ] i have also slightly adjusted her head - it looked a little skewed to me this morning ( a night ' s sleep changes everything ), so i simply selected it, chose distort, and skewed it back the way i think it should be
我還稍微調整了她的頭? ?今早它看起來有點兒朝我這歪斜（睡一晚上改變了所有的事情哦） ，所以我很簡單地選擇頭部，然後選擇「扭曲」 ，然後把它朝我認為應該的方向傾斜回來。When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved
分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。Under the all different structures " combination, the water surface had large bias and turn - around in the torturous path, and in the middle of the path along the longitude, there had the regularity that sink bank surface was higher than the convex bank one
在所有結構組合條件下，彎道水面都有較大偏斜和扭曲，並且在彎道中部主法線方向上，基本為凹岸水面高凸岸水面低的規律。Navier - strokes equation was solved using simple method. lam - bremhorst k - e was used to simulate turbulent flow. it was indicated in this thesis that a longitudinal vortex would be produced after the jet exhausted from a plate into a boundary layer at a pitch angle and a skew angle
研究結果表明，有一定傾斜角度的單個射流與主流作用后，將在下游產生一個流向渦旋，渦旋使得邊界層內的速度和雷諾應力發生嚴重扭曲，從而形成上洗區域和下洗區域。分享友人