斜坡信號 的英文怎麼說

中文拼音 [xiéxìnháo]
斜坡信號 英文
ramp signal
  • : 形容詞(跟平面或直線既不平行也不垂直的) oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • : Ⅰ名詞(地面傾斜的地方) slope Ⅱ形容詞(傾斜) sloping; slanting
  • : 號Ⅰ名1 (名稱) name 2 (別號; 字) assumed name; alternative name3 (商店) business house 4 (...
  • 斜坡 : slope; inclination; incline; hill; clivus; batter; decline; dip; pitch; lean; backfall; pali; [地...
  1. The synchronous rectifying and low power sampling technology is used to reduce the power consumption, flexible external loop compensation, error amplifier output clamp are adopted for better system large signal response. the piecewise slope compensation technology is employed to minimize the consequence of over compensation. the sensor resistor is externally connected, which realize output voltage programmable. the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system

    同時,電路設計採用同步整流技術、低功耗電流采樣技術降低功耗,提高轉換效率;採用靈活的外部環路補償技術、誤差放大器輸出嵌位技術以實現良好大特性;採用分段補償技術,消除不穩定因素,並最大程度地減小過補償帶來的問題;採用外接輸出采樣電阻的方式,實現輸出電壓的可編程。
  2. And so on, the mathematical model and transfer function of the tracking system are built, and the feasibility of the tracking control system design is demonstrated. furthermore, the static error of the system with a unit incline input is deduced. a majority of model of unit is based on analytics, so the general model can apply to other optical intersatellite communications systems

    在此基礎上,將atp跟蹤控制子系統視為線性定常系統,通過解析法和實驗法對子系統的各個控制環節的單元器件進行合理建模,得出整個環路總的開環及閉環傳遞函數,論證了本課題所設計的atp跟蹤控制環路的可行性及其視軸輸入為斜坡信號時的理論穩態誤差。
  3. Because the friction force mainly influences the track precision and the orientation precision of the servo system, it should consider these two targets changes between before and after compensation. low - velocity ramp signal and step signal were chosen as simulation test signal

    由於摩擦力主要影響電液位置伺服系統的低速跟蹤精度和定位精度(即穩態誤差) ,所以要考慮補償前後這兩個指標的變化情況,模擬測試選為低速斜坡信號和單位階躍
  4. It is revealed that the control commands from the filter are composed of a sequence of ramp signals, whose time - ratio of variation never exceeds the permissible value to restrain the excitation to un - modeled harmonic modes

    研究結果表明,該濾波器形成的控制是一系列的斜坡信號,對時間的變化率不超過允許的最大沖擊值,從而降低了未建模動態激勵。
  5. In signal processing circuit, the key of our study, based on methods of mcu + cpld and a / d converter, a time interval measurement unit is done, in which an isp cpld counter is carried out to judge laser pulse for controlling counting and offering signal of time series and control, and a count quantization error measurement circuit which main ramp circuit and 12 bits a / d conversion circuit guarantees the resolution of system

    處理部分是本文研究的關鍵,採用mcu + cpld的設計方法和模數轉換技術構成時間間隔測量單元的理論基礎,其中用可在系統編程的cpld計數器實現了對循環光脈沖的判斷以開關計數,並提供計數量化誤差測量電路相應的時序和控制,用電路和12位a / d轉換電路完成對計數量化誤差的測量,保證了系統的解析度。
  6. The sine is used in the simulation. being aimed at the compensation methods of both the adaptive control basing on the friction model and the repeat control regulator, some experiments are carred out to verify the effectiveness and feasibility of the compensation. the signals which are introduced into the system are ramp and sine for testing the minimum stable speed and error

    針對第三章中提到的基於摩擦模型的自適應低速補償方法,以及第四章提出的不基於模型的重復迭代學習控制的低速補償方法,在系統中分別引入了斜坡信號和正弦進行了實驗測試,並與pid控制結果進行了比較。
  7. The slope maintenance responsibility information centre will permit the public to obtain information from the system such as slope registration number, location and responsible maintenance party in respect of man - made slopes

    維修責任息中心將會讓公眾人士經由上述系統取得如人造的編、位置及負責維修人士機構等資料。
分享友人