斜破裂組 的英文怎麼說

中文拼音 [xiépòlièzǔ]
斜破裂組 英文
diagonal sets of fracture
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 破 : Ⅰ動詞1 （完整的東西受到損傷） be broken; be damaged 2 （使損壞） break; break down; damage 3 （使...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 破裂 : break; fracture; burst; split; rupture; crack
  1. Stability of rock slopes is generally controlled by the structure of rock masses, especially the soft structure surfaces. analysis of rock mass structures is a key to establish geological models and numerical simulation and a foundation to assess the stability of rock slopes. the weak structure surfaces are mainly bedding planes, faults, joints, schistosity plane and contact zones of intrusive bodies. since they are different in genesis and scale, the rock masses are different in features and mechanical intensities. based on the combination of rock structure bodies, 15 basic modes of deformation and failure of rock slope are systematically summarized. the deformation and failure of rock masses actually result from the recombination and rearrangement of these rock bodies. there are 11 types of rock mass structures and various deformation and failure of bank slopes are present in the reservoir area of the three gorge project

    巖體結構，特別是軟弱結構面對基巖斜坡變形與破壞具有顯著的控製作用，巖體結構模式分析是建立斜坡地質模型和數學模型的關鍵和評價斜坡穩定性的基礎。巖層層面斷裂構造節理裂隙片理與劈理以及侵入體和圍巖的接觸帶等是控制基巖斜坡穩定的軟弱結構面，這些成因不同大小不一的結構面將巖體分割成性質各異力學強度不均的各種巖體結構體，構成了15種基巖斜坡變形破壞的巖體結構基本模式。不同結構體的重新組合與排列是斜坡失穩的內在原因。
  2. The fault controlled the magmatism and metallization relevant to the contact zone, and deformed successively and produced cataclastic rocks and two sets of joints ; the second stage was from late cretaceous to eocene. the fault zone deformed right - laterally under ne - sw striking transtention, and new joints zone was produced at the end of the two main faults because of local stress concentration. the fault produced inchoative cataclastic rocks, and two sets of typical joints in plutons ; the third stage of deformation was relatively faint and only a little of microcracks was produced and infilled with vei ns in the deformed rocks, which was during the himalayan movement

    其後的繼承性活動在斷裂帶內形成碎裂程度最強達到碎裂巖的碎裂巖系列構造巖，變形帶兩側發育兩組典型的共軛剪節理；第二次在晚白堊世?始新世，斷裂在北東?南西向近水平擠壓作用下右行張扭性活動，斷裂帶兩主斷裂在斜列重疊的端部由於局部應力集中進一步擴展形成節理帶，而斷裂在巖體區也發育兩組典型的共軛剪節理，斷裂內形成初碎裂巖為主的構造巖；第三次是喜山期以西側抬升、東側下降的強烈升降為主的活動，在基巖中，主斷層兩側圍巖出現微破裂。
  3. The author suggests that the three lithosphere - scale faults, lancangjiang fault, jinshanjiang - ailaoshan fault and axis fault in the middle of the basin, are the main geological structures that control the formation of basin, magmatism and metallogenic congregate district. the anticline structure with an axis of triassic strata and the related fault system within the basin, and gonglang arch - shaped folding structure in the south of the basin are the geological structure controlling the formation of ore fields. junctions of two or more faults with different orientation, interlayer cataclastic structural zone and oxidation - reduction ( redox ) boundary were the favorable position for the formation of ore bodies

    認為瀾滄江斷裂、金沙江-哀牢山斷裂及盆地中軸斷裂這三條巖石圈斷裂是主要的控盆-控巖（巖漿巖）構造及礦集區尺度的控礦構造；盆地中以三疊系為軸的背斜構造及相關的斷裂系統、盆地西南緣公郎弧形構造等是礦田尺度的控礦構造；多組斷裂的交叉、層間破碎帶及地層柱中的氧化還原界面是形成礦體的有利部位。
  4. The studied deposit area is located on a monocline geotectonic unit divided by several groups of faults. therefore, the secondary widen transverse and lognitudinal drapes may have great influence on ore forming and location

    礦區基本構造為一個被幾組斷裂破壞的單斜構造，其上發育的次一級的開闊型橫向和縱向褶皺對礦床的形成和空間定位起著十分重要的作用。
分享友人
分享到 Line

分享到臉書