斷裂應力 的英文怎麼說

中文拼音 [duànlièyīnglì]
斷裂應力 英文
breaking stress
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  1. Based on the analysis of thermal contact metamorphic aureoles, granitoid interior structure, quartz axis fabric and strain characters in the different rock unites of yuanshishan granitoid and its wall rocks, the emplacement mechanism of yanshishan granitoid was studied. the magmatic explictite dynamic was advanced in light of regional stress and magma dynamic research. those conclusion was synthesized to ascertain the emplacement mechanism - granitic magma ascended in dikes with the minimum critical width of the magma ascending channels about 2. 213. 88m and located in the core of yindianshan dome with the passive style of dyke explictite ; the later unite is a kind of multiple emplacement mechanism with the character of active emplacement of ballooning

    同時運用巖漿動力學原理從另一個角度探討其侵位驅動力。綜上指出：經分凝后的活動性巖漿在深部側向擠壓和浮力的聯合驅動下，沿深大斷裂以最小臨界寬度為2 . 213 . 88m的裂隙脈動上侵，整體以巖墻擴展的方式被動定位於銀殿山穹窿的核部，但後期屋面前單元具有主動侵位的特點應為一種復合定位機制。
  2. The fault controlled the magmatism and metallization relevant to the contact zone, and deformed successively and produced cataclastic rocks and two sets of joints ; the second stage was from late cretaceous to eocene. the fault zone deformed right - laterally under ne - sw striking transtention, and new joints zone was produced at the end of the two main faults because of local stress concentration. the fault produced inchoative cataclastic rocks, and two sets of typical joints in plutons ; the third stage of deformation was relatively faint and only a little of microcracks was produced and infilled with vei ns in the deformed rocks, which was during the himalayan movement

    其後的繼承性活動在斷裂帶內形成碎裂程度最強達到碎裂巖的碎裂巖系列構造巖，變形帶兩側發育兩組典型的共軛剪節理；第二次在晚白堊世?始新世，斷裂在北東?南西向近水平擠壓作用下右行張扭性活動，斷裂帶兩主斷裂在斜列重疊的端部由於局部應力集中進一步擴展形成節理帶，而斷裂在巖體區也發育兩組典型的共軛剪節理，斷裂內形成初碎裂巖為主的構造巖；第三次是喜山期以西側抬升、東側下降的強烈升降為主的活動，在基巖中，主斷層兩側圍巖出現微破裂。
  3. Maximum circumferential stress criterion of brittle fracture for v - notch

    型切口脆性斷裂的最大周向應力準則
  4. By means of bending tests of three - point and four - point, complex fracture experiments were made for cast iron material with crack. the stress intensity factor and breaking direction angle of cast iron material were measured and compared with theoretical values. based on the research some useful conclusions are given for engineering design and application

    通過3點彎曲和4點彎曲實驗方法，對含有裂紋的鑄鐵材料進行復合型斷裂實驗研究，測試鑄鐵材料的應力強度因子、斷裂方向角，將實驗結果與理論值進行分析、比較，找出兩者之間的異同點，得到一些對工程設計及應用具有實際意義的結論。
  5. It is the regional structure stress field formed in the processes of formation of the major faults of buried hills action on the graben that controlled the development of the fractures of sandstone of mesozoic of baigezhuang region

    正是壘塊上古潛山內幕主要斷層形成過程中的局部構造應力場，控制形成了柏各莊地區潛山中生界砂泥巖中裂縫的發育。
  6. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  7. Having analyzed preliminarily formation mechanism of these common characteristics of anomaly, it concludes that : these are results, controlled by basically united tectonic stress field of large - range, caused by stress - strain accumulation and certain phase strong earthquakes, according to deformation difference brought about in tectonic position along the boundary zone and within second - order faults of active blocks resulted from unstable and inharmonious features for movement of block system at different levels and deformation of boundary

    分析這些異常共性特徵的形成機制，初步認為：是在基本統一的大區域構造應力場控制下，不同層次塊體系統運動及其邊界帶變形的非平穩、非協調性，在活動地塊邊界地帶和地塊內部次級斷裂構造部位產生變形差異而導致應力-應變積累、孕育強震到一定階段的結果。
  8. Stress redistribution around a broken fiber in an intermingled hybrid composite sheet

    層內混雜復合材料斷裂纖附近的應力重分佈
  9. To evaluate fracture instability, the total sum of stresses due to residual welding or rolling stresses, dead load, and live loads must be considered.

    計算斷裂失穩性時，必須考慮焊接或軋制殘余應力，恆載應力和活載應力之總和。
  10. The purpose of the sesa monograph is to assemble, in several chapters, experimental techniques related to fracture mechanics.

    出版這本實驗應力分析學會（SESA）專集的目的，在於用幾個章節把分散的有關斷裂力學實驗技術的資料匯編成冊。
  11. Fracture criterion of - mixed mode crack for orthotropic plate

    正交異性板復合型裂紋相對周向應力斷裂準則
  12. The paper analyzes the occurrence regularity of rock burst of about 263 times in laohutai mine field by database, the osculating relations of rock burst and active faults were summarized

    摘要應用數據庫對老虎臺井田其發生的263次沖擊地壓之統計分析表明，巖體動力現象與活動斷裂有密切關系。
  13. The application of rupture mechanics and remanufacturing technology is very important not only to petrochemistry industry but also to the life - prolong of equipment

    石油化工行業對于斷裂力學和再製造技術的應用極為重要，對設備延壽有重要意義。
  14. Simulation analysis and application of the faults stress field

    斷裂應力場模擬分析與應用
  15. The smaller the curvature and the larger the crack length the smaller will be the fracture stress.

    曲線半徑越小，裂紋長度越大，斷裂應力也就越低。
  16. The thermal fatigue resistance of al2o3 - 20wt. % tic is the best, it is due to high kic and pore of the material. the pore decrease the stress extension of tip of cracks and delay themal shock fatigue cracks extension. 4

    含20wt . tic的復合陶瓷具有高的k _ （ 1c ）和較多的孔隙，這些空隙在熱震疲勞時降低熱震疲勞裂紋尖端的應力集中並阻礙裂紋擴展從而提高了材料的斷裂抗力，故其具有最好的抗熱疲勞性能。
  17. It was also demonstrated that rosin in hybrid polymer functioned as a plasticizer to reduce glass transition temperature, which resulted in the reduction of strength and increase of elongation of polymer films

    力學性能分析顯示歧化松香在雜合物中起到了增塑劑的作用，降低了聚合物的玻璃化轉變溫度，使得斷裂應力下降而斷裂伸長率有所增長。
  18. Thus, the formation of the rock is related to lithospheric extension or collision events, which was derived from upper mantle and intruded along changle - nanao frature zone

    巖體是受俯沖流體交代的上地幔，經部分熔融沿長樂?南澳斷裂?應力轉換帶侵入。
  19. Brittle fracture stress

    脆性斷裂應力
  20. A state - of - art review of several branches of fracture, which are related to the dissertation, are presented, including macroscopic - microcosmic fracture mechanics, fracture dynamic mechanics, 3d crack problem etc. the crack technique, which is the basis and application of controllable regular fracture, are also reviewed concisely but thoroughly

    回顧了目前斷裂力學研究中與本文主題相關幾個方面的國內外研究現狀，包括宏微觀斷裂力學、斷裂動力學以及三維裂紋問題等。對于可控規則斷裂產生的基礎和主要應用對象的裂紋技術，給出了簡要但全面的介紹。
分享友人
分享到 Line

分享到臉書