斷路接觸點 的英文怎麼說

中文拼音 [duànlùjiēchùdiǎn]
斷路接觸點 英文
open-circuit contact
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 接觸點 : contact bar
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  1. The main loop of the welder uses a thyratron transistor non - contact switch circuit, quick and reliable close time, accurate timing of welding, high precision of welding, good repeatability, bring a high quality welding

    焊機主迴路採用晶閘管無觸點開關電路，關斷時間快、可靠，焊接定時精確，焊接精度高，重復性好，可實現高品質焊接。
  2. But, with the development, it can ’ t meet the need of modern manufacture more and more. as a result, handhold digital storage oscilloscope is studied. handhold dso is an important genre of digital storage oscilloscope, it ’ s outstanding feature include small form, use battery instead of ac supply for power, and include the whole function of dso while implementing the basic function of multimeter. handhold dso can measure wave range automatic, analyze wave use cursor, measure resistance 、 diode and short circuit if choice digital multimeter

    手持式數字存儲示波器是數字示波器的一個分支，它具有體積小、重量輕、便於攜帶、電池供電、無須外接交流電源等優點，它集數字萬用表（ dmm ） 、數字存儲示波器於一體，可自動對信號進行幅度的測量，也可用光標對波形進行分析，同時還可以通過菜單選擇來實現對電阻、二極體以及電路通斷的測試;可以選擇觸發通道和觸發模式。
  3. For current misoperation cause of microcomputer relay protection, the paper introduces the technology of scattered arrangement protection to improve anti - inteferance ability, the usage of computer digital communication technology to enhance fault diagnostic function of micro computer protection device and outside circuit and decrease bad contact of contactor and terminal which may cause ralay misoperation, establishment of electrical protection remote management network to realize maintenance under condition

    針對目前微機保護不正確動作的原因，提出了採用保護分散布置技術，提高抗干擾能力；應用計算機數字通信技術，增強微機保護裝置及外聯迴路的故障診斷功能及減少接點和端子接觸不良引起的保護不正確動作因素；建立電網保護管理遠程網路，實現「狀態維修」 。
  4. Contact occupation of plug connectors - circuit breakers, rated voltage 52 kv - coordination of auxiliary and control - circuits

    插塞式連接器的觸點佔有率.額定電壓小於52kv的電路斷
  5. When the contacts are connected into direct circuit, we can judge whether the contacts are open or not through analyzing the voltage instantaneous values across the two contacts

    當有觸點電器的觸頭接入直流電路中時，可通過觸頭兩端電壓瞬時值來判斷它是打開還是閉合。
  6. Type 37tf includes an internal resistor wired in parallel with the contacts which serves as an aid to factory circuit testing where the contacts are open at room temperature

    型號37tf包括有一個內部電阻，這個電阻與（一對）觸點並聯連接，這對觸點對出廠前的電路檢測能提供幫助，在室溫下，這對觸點是斷開的。
  7. The air - powered machine of chopper because of having structure in brief, maintenance convenient, the cost was low and otherwise advantages to get an extensive application, but often took place breakdown on control circuit of air providing in actually running, causing the contact point of relay to glue together and burning it to bad, the air pressure getting unusually state and the like other serious obstacle

    高壓斷路器氣動機構由於具有結構簡單，維護方便，成本低等優點得到了廣泛的應用，但在實際運行中常發生氣體打壓控制迴路故障，導致接觸器接點粘連燒壞，氣體壓力異常等嚴重障礙。
  8. In this paper, the over voltage induced by re - ignition, rules of breakdown in vacuum contact clearance, factors which influence dielectric strength of clearance and characteristics of re - ignition when vacuum switchgear switch capacitor banks are analyzed. the conclusion is that the breakdown of clearance in vacuum interrupter is the direct cause which inducing re - ignition of vacuum circuit - breaker in capacitor banks ’ switch. particle breakdown is the essential reason to induce breakdown in clearance of vacuum interrupter, although mechanical characteristic of vacuum circuit - breaker is another factor

    本文通過對真空開關投切電容器組重燃過電壓、真空觸頭間隙擊穿機理及影響真空間隙介質強度的因素、真空開關投切電容器組重燃現象特點進行分析研究發現，真空滅弧室斷口的真空間隙擊穿是導致真空斷路器投切電容器組重燃的直接原因，其次是真空斷路器機械性能的影響，而微粒擊穿是導致國產真空滅弧室真空間隙擊穿的根本原因。
分享友人
分享到 Line

分享到臉書