旋渦分離 的英文怎麼說

中文拼音 [xuánguōfēnlí]
旋渦分離 英文
cyclone separation
  • 旋 : 旋Ⅰ動詞1 （旋轉） whirl 2 （用車床切削或用刀子轉著圈地削） turn sth on a lathe; lathe; pare Ⅱ名詞...
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 旋渦 : vortex （pl vortices; vortexes）; whirlpool; vemous; eddy; vorticit; backset; swirl; [地質學] nuc...
  1. In chapter 2, a simplified analytical model is presented for the analysis of the bvi mechanism, adopting the beddoes " prescribed wake model. by this model, the azimuthal location and miss - distance of the bvi and the radiation directivity of the bvi noise are calculated and discussed, and some conclusions are obtained

    在第二章，使用beddoes預定尾跡模型，建立了一個用於旋翼槳-渦干擾特性機理分析的簡化數學模型，分別對旋翼槳-渦干擾位置、槳-渦干擾距離和聲輻射方向性等進行了計算和分析，得出了有意義的結果。
  2. The series equipment versatillty, its performance had achieved the international advanced level, is at present is most effective, the practical reliable crushed stone machine, is suitable specially for the manufacture grinding compound, fireproof the matreial, the cement, the quartz sand, the emery, the stove are cut broken glass the power, the copper ore, the concrete aggregate and so on many kinds of, the crisp materials on the control granulated substance machine energy conserva tion 50 %, is in the present world system qranulated substance equipment

    物料由機器上部垂直落入高速旋轉的葉輪內，在高速離心力的作用下，與另一部分以傘狀形式分流在葉輪四周的物料產生高速撞擊與粉碎，物料在互相撞擊后，又會在葉輪和機殼之間以物料形成渦流多次的互相撞擊、摩擦而粉碎，從下部直通排出，形成閉路多次循環，由篩分設備控制達到所要求的成品粒度。
  3. In the second chapter, the fluid mechanics principle of vortex flowmeter at first was introduced. the classical theory about vortex flowmeter and the method of computational fluid dynamics about flow around body were expanded on, and the model of the single bluff body and the dual bluff body vortex flowmeter were constructed. and then, fvm - finite volume method - analysis software fluent was applied to analyze the flow phenomenon of flow over single bluff body or dual bluff body

    然後通過大量實驗和理論分析給出雙鈍體渦街流量計的設計準則：當管徑為d ，鈍體形狀為三角形，則鈍體設計參數為：銳邊寬度= 0 . 26d ，高度= 0 . 34d ，鈍體之間的距離= 1 . 2d （即當兩鈍體寬度相等且鈍體距離等於單鈍體兩列旋渦之間的距離） 。
  4. In the second part, firstly, the mathematical model for predicting hydrodynamic characteristics of varivec propeller under steady or unsteady condition are present, based on the general propeller lifting - surface theory, potential flow theory and green theorem. then, theoretical calculation methods for predicting hydrodynamic characteristics of varivec propeller designed above paragraphs are present, based on the finite basic solution method, the unsteady vortex lattice method and hess - smith method

    在理論計算部分，本文首先基於常規螺旋槳升力面理論、勢流理論和格林定理建立了定常和非定常狀態下全方向推進器水動力性能計算的數學模型，然後利用有限基本解法、非定常渦格法和赫斯?史密斯方法對全方向推進器定常和非定常狀態下的數學模型進行了數值離散，接下來針對前面所設計的全方位推進器進行了數值預報。
  5. Based on the green ' s formula and the assumption of the propeller blade ' s thin sections, a lifting - surface method of propellers with the vortex lattice and equal source panel distributions on the mean camber surface has been introduced for the prediction of steady propeller ' s hydrodynamics in this paper. an approximate kurta condition was applied

    基於creen公式和薄翼理論假設導出的升力面方法，採用在螺旋槳拱弧面上分佈離散渦、源布置方法預報均勻流場中的螺旋槳的定常性能，螺旋槳尾渦面上壓力連續性條件採用近似的kutta條件處理。
  6. Although the knowledge of wind effects on tall buildings has significantly improved over the last decades, an understanding of the mechanism that the atmospheric flow field to various wind include effects on structures has not been developed sufficiently for formulation of functional expressions. not only is the wind approaching a building complex, but the flow pattern generated around a building is complicated by the distortion of the mean flow field, the flow separation, the vortex formation, and the wake development

    在過去的幾十年裡，雖然人們對高層建築風效應的了解已有顯著提高，但對大氣流場與結構物各種風致響應的關系還不能用解析表達式加以描述。由於平均流場的奇變、流動分離、旋渦形成以及紊流的發展，不僅使得流向建築物的風，而且使得繞建築物的流譜變得十分復雜。
  7. After simulating the model of water hydraulic valves, the velocity distribution, pressure distribution, energy distribution can be obtained and relations between the valve channel and the energy loss, the negative pressure distribution can be analyzed, which offers the theory foundation for designing water hydraulic valves with the high efficiency, low energy loss and low noise

    通過對水壓閥模型的cfd穩態和瞬態解析，可以得到水壓閥內流場的速度分佈、壓力分佈及能量分佈，據此定性分析流道結構（速度、壓力、流動的分離與再附壁，旋渦的產生與消失等）與能量損失、負壓分佈等的關系，從而為設計出高效率、低能耗、低噪聲的水壓閥提供理論依據。
  8. A kind of kelvin type vortex formed by the roll up of the jet shear layer is observed in the experiment

    本文還探討了橫流線流分離旋渦的生成機理及轉向。
  9. The surface panel method has been applied to predict the hydrodynamic performance of highly skewed propeller. the surface of propeller and its trailing vortex are discreted by a number of small hyperboloidal quadrilateral panels with constant source and doublet distribution. for highly skewed propeller, the conventional method generating grid oriented along constant radii will result in a high aspect ratio and a high skewness and a twist panel near the propeller tip on blade surface, which result easily in incorrect calculation results of velovity on blade surface, even in iteration divergence and calculation failure. a “ non - conventional grid ” is developed to acoid these problems. this grid can effectively solve the problem of the calculation and convergence for highly skewed propeller. the non - linear kutta condition of equal pressure on upper and lower at the trailing edge is executed by the iterative procedure. by sample calculating, the obtained results are satisfied the experimental data

    採用面元法預報大側斜螺旋槳水動力性能，螺旋槳表面及尾渦面離散為四邊形雙曲面元，每個面元上布置等強度源匯和偶極子分佈.對于大側斜螺旋槳而言，槳葉表面採用常規的等半徑網格劃分方法在近葉梢處將導致大展弦比、大側斜和扭曲面元，這容易使槳葉表面速度的計算結果不正確，甚至會導致迭代過程發散及計算失敗.文中建立了一種「非常規網格」劃分方法，能有效地解決大側斜螺旋槳的計算和收斂問題.槳葉隨邊處通過迭代實現非線性等壓庫塔條件
  10. Effects of leeside vortex isolation on pressure distribution over a high - alpha body of revolution

    背風渦隔離對大攻角旋成體表面壓力分佈的影響
  11. Abstract : a modified droplets trajectories analysis model is established for the efficiency estimation of liquid - liquid hydrocyclones based on the single vortex field theory

    文摘:在單渦流場理論基礎上建立了一種改進的油粒軌跡模型，用以預測油水旋流器粒級分離效率。
  12. In t his p aper r otating s tall a nd t he inlet v ortex in c entrifugal fans with inlet v ane control has been studied in laboratory. the harmonic wavelet is firstly used for time - frequency analysis and feature extraction of pulsation amplitude and frequency and development of rotating stall and inlet vortex. the development rule of rotating stall and inlet vortex and the effect to fans performance from the two has been found

    文中對採用入口導流器調節的離心通風機的旋轉失速和進口渦流問題進行了實驗研究，並藉助諧波小波對旋轉失速和進口渦流的頻率、幅值特性及動態過程進行了時頻分析和特徵提取，揭示了旋轉失速和進口渦流發展的規律及二者對風機性能的影響。
  13. Mathematical model and numerical simulation of turbulent for hydrocyclonic separation

    旋流分離的湍流渦動數學模型及數值模擬
  14. The result shows that two clear vortexes exist in the cyclone, strong swirling vortex round the exit pipe and weak one near back wall of the half - tilted cone

    結果表明，在分離器內部有兩個較為明顯的旋渦，位於排氣管附近的為強旋渦，位於半斜錐體後壁處有一弱旋渦。
  15. Experimental study shows : it was able to distinguish between rotating stall and the inlet vortex.,

    實驗表明，旋轉失速和進口渦流能夠區分，且區域界限分離明顯。
分享友人
分享到 Line

分享到臉書