旋風燃燒室 的英文怎麼說

中文拼音 [xuánfēngránshāoshì]
旋風燃燒室 英文
cyclone combustion chamber
  • : 旋Ⅰ動詞1 (旋轉) whirl 2 (用車床切削或用刀子轉著圈地削) turn sth on a lathe; lathe; pare Ⅱ名詞...
  • : Ⅰ名詞1 (空氣流動) wind 2 (風氣; 風俗) practice; atmosphere; custom 3 (景象) scene; view 4 ...
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • 旋風 : tourbillion; whirlwind; whirl; vortex (pl. vortices; vortexes); secondary
  • 燃燒 : (物質劇烈氧化而發光、發熱; 燒) burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Second, we development the influence of flamethrower shape, root air, the obliquity of spin vane and block heat board for the air current in the firebox by simulating them through two phases calculate

    然後通過兩級計算的方法,分別對不同海拔高度、噴火筒形狀、根部大小、流葉片的傾角以及有無回熱板時對空氣氣流組織的影響進行模擬。
  2. Phenomena, such as flow field confusion and slagging etc. have occurred in the practical process of cyclone burner for coal - water slurry ( cws ) firing, on this basis a study on aerodynamic field of cws cyclone burners had been carried out through cold state experiments in the laboratory, then the influence of burner ' s structure properties upon the said flow field had been carried out, and expected to find more reasonable structure of the burner was found. in my study the focus is on the affection of cone and cyclone intensity in the condition of infinite and finite fields

    本文著重研究現有水煤漿器的流葉片角度,一次擴口的長度以及角度對器出口流場的影響,通過流場的比較,以期得到性能較好的器。考慮到水煤漿器中心的水煤漿射流對于其空氣動力場的影響,本文在實驗冷態實驗研究的基礎上,模擬水煤漿射流,研究其對器空氣動力場的影響。
  3. The technology process : the waste, through operation stand, to be rationed into the standing majorcombustion room, being ignited by the ignition - burningmachine, upon the principal of burningthree t, fully burned in the major combustion room ( 800 - 1000 ). the remaining waste gas afterburning via flue goes into secondary combustion room for further high temperature oxidizingcombustion. the gas flow after the secondary combustion goes into the highly effective cyclonedust remover, removing the bigger granule of dust, flowing into rapid - cooling spay and washing equipment to absorb acid gas

    廢棄物經操作臺連續定量投入立式爐本全,由點火文空機自動點火,根據三t原則在爐本體( 800 - 1000 )以充分,焚后產生的殘余廢氣經煙道進入二次再經高溫( 1100 - 1200 )氧化焚,經二次焚后的氣體進入高效除塵器,除去顆粒較大的粉塵后,進入急冷塔噴淋洗滌裝置吸收酸性氣體。
分享友人