明煅 的英文怎麼說

中文拼音 [míng]
明煅 英文
calcining openly
  • 明 : Ⅰ形容詞1 （明亮） bright; brilliant; light 2 （明白;清楚） clear; distinct 3 （公開;顯露在外;不隱...
  • 煅 : 動詞1. （中藥製法: 放在火里燒） calcine2. （鍛造） forge
  1. Study on the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process using kaolinite as raw material showed that impurities introduced by kaolinite mainly increased the liquid amount at high temperature, which can assist sintering of specimen. the experiment results indicated that the samples with lower gahnite content had better sinterability than others. however, if the gahnite content was relative high, the promoting effect on sinterability caused by kaolinite was not significant

    採用天然原料高嶺土二步煅燒合成剛玉?莫來石?鋅鋁尖晶石復相材料研究發現：天然原料中帶入的雜質主要是增加液相量，促進高溫下試樣的燒結；當尖晶石含量較低時，試樣在1300保溫2h時，在1600燒后試樣燒結性能相比之下較好；而當鋅鋁尖晶石含量較高時，天然料對試樣的促燒作用不是非常明顯。
  2. Based on orthogonal designed experiment, the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process showed that the light fired temperature and holding time mostly influenced the apparent porosity of the multiphase materials. further study on the light firing time indicated that at the light firing temperature of 1300 and died fire temperature of 1600 for 3h, the optimal light fired time was about 1h

    二次煅燒及正交實驗合成復相材料研究表明：輕燒溫度和輕燒時間對復相材料的顯氣孔率影響顯著；通過輕燒保溫時間的進一步研究表明：含剛玉、莫來石、鋅鋁尖晶石的復相材料，在輕燒溫度為1300 、終燒條件為1600下保溫3h時，最佳的保溫時間為1小時左右。
  3. Ligusticum wallichii, atractylodes macrocephala koidz, akebi, radix astragali and ricepaper pith etc

    石決明煅決明子扼子大黃黃芪等十一味。
  4. The na2fepo4f cathode materials for sodium ion battery were prepared by solid state reaction and the influence of synthesizing temperature and morphology on the electrochemical performance of na2fepo4f powders in sodium ion batteries were systematically studied. the results indicate that na2fepo4f synthesized at 750 exhibited good electrochemical performance, whose first specific discharge capacity is 60mah / g, after 20 times cycling, the average specific discharge capacity is 51. 1mah / g

    首先採用固相法制備了氟磷酸亞鐵鈉粉體，研究了不同煅燒溫度對合成材料顯微結構和電化學性能的影響，結果表明750下合成材料體現出較好的電化學性能，首次放電容量為60mah / g ，循環20次后，容量下降為51 . 1mah / g 。
  5. The addition of calcined kaolin to cement increased the chemical shrinkage of cement stone, but it had no distinct impact on the self - shrinkage of cement stone

    煅燒高嶺土摻入水泥中，增加了水泥石的化學收縮，對水泥石的自收縮的影響並不明顯。
  6. Particle size distributing and the composing of crystal phase were discussed by the orthogonalizing design. the experiments showed that the most suitable process conditions should controlled as follows : process temperature was about 30c ; the ratio of tnb " water and solvent was l : 4 : l 0 : the calcined temperature was about 600 " c. such transition metal ions as fe3 +

    實驗表明，合適的反應條件是：以醋酸為負催化劑，水解溫度應控制在30左右，鈦酸丁酯與水量、溶劑量的配比應為1 ： 4 ： 10 。另外得到比較單一的銳鈦型tio _ 2煅燒溫度應控制在600左右。
  7. It can be seen from this study that avoiding a hardened and impervious lump formed in calcination can accelerate al extraction from coarse metakaolin pellets, and a high leaching rate can be reached within a batch process

    該研究結果表明，避免高嶺土球粒在煅燒時被「燒死」 ，能使粗粒煅燒高嶺土的酸溶反應易於進行。
  8. Through study on the electrical performance of sn - in2o3 nano powder, some conclusions were drawn. when sn - in2o3 precursor was calcinated at 700 - 1000, low square resistance was got. the resistance was lower when sn - in2o3 precursor was calcinated in vacuum than air condition

    Sn - in _ 2o _ 3納米粉體的電性能研究表明： sn - in _ 2o _ 3前驅物在700 - 1000煅燒，方塊電阻較低，真空條件下煅燒試樣的電阻比空氣條件下煅燒試樣的電阻低，南京工業大學碩士學位論文中文摘要sno :摻雜10wt %左右時，試樣方塊電阻最低。
  9. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  10. The sample composition was analyzed by means of tg and x - ray diffraction. the following conclusions can be drawn from the experiments : given conditions, the sample powder that has the same xrd data as the standard fetioa can be gotten when use any method mentioned above ; the key in synthesis is to avoid the oxidation of fe2 +, so the whole process should performed under vacuum or neutral atmosphere, samples used by this study were prepared under nitrogen atmosphere ; the heat - treated time and temperature have some influence on the sample powder, results show that the proper time and temperature is 120 minutes and 1100 respectively

    研究結果表明：在合適的反應條件下，用上述三種合成方法都能得到xrd數據與標準fetio _ 3物相基本吻合的粉體；合成反應需要克服的主要問題是防止體系中fe ~ （ 2 + ）的氧化，因此，整個反應必須在真空或者非氧化性氣體保護下進行，本研究需要的樣品是在高純從保護下合成的；煅燒的時間和溫度對最終的產物也有一定的影響，研究發現：合理的煅燒時間和溫度分別為120分鐘和1100 。
  11. The results show that the shrinkage of cement paste can be compensated by the new mgo - based expansive materials well, only if the burning temperature and burning time of expansive material are controlled and the dosage of expansive material in cement is suitable according to the hydration temperature and with fly ash or not

    結果表明，根據一定條件下（如養護溫度、摻加粉煤灰等）水泥漿體的收縮特性來調整膨脹材料的煅燒溫度和煅燒時間，控制合理的摻加量，新型鎂質膨脹材料可以有效地補償水泥漿體的收縮。
  12. This thesis focuses on the study of the layered lithium nickel - based oxides as catho de materials lithium - ion batteries, the main aspects follow : 1 study on the synthesis and properties of linixco1 - xo2 by the sol - gel method compared with solid - state method, sol - gel method enjoys the advantage of lower calcining temperature and small uniform particle size of products. after the xrd measurement, it was shown that the single - phase layered compound can be prepared in sintering temperature of 750 for 6 ~ 8 hours. the sintering temperature, the properties and the amounts of doping materials can all affect the product ' s phase, and its structure ( lattice parameter, crystal phase distance )

    本論文的研究工作主要集中在作為鋰離子電池正極材料的層狀鋰鎳基氧化物上，包括以下幾個方面： 1溶膠凝膠法（ sol - gel ）合成lini _ xco _ （ 1 - x ） o _ 2的研究與固相合成法相比，溶膠凝膠法合成lini _ xco _ （ 1 - x ） o _ 2煅燒溫度低，產物顆粒均勻一致，經過xrd的測試過后，結果表明750下燒結6 8小時，即可得到單相產物；燒結溫度，摻雜劑的種類及摻雜劑量均對產物物相的形成產生影響，並對產物的結構產生影響。
  13. The result of annealing of silicon nitride showed the crystal nuclear existing in the origin silicon nitride powder led on the grow of hexagonal 3 - si3n4 and formed the 3 - si3n4

    氮化硅的煅燒表明：原始氮化硅納米粉末中的晶核在氮化中誘發相生長，形成- si _ 3n _ 4 。
  14. Xrd and tem patterns showed that superfine powders of namometer oxide, 15 ~ 98nm ca., even and without hard agglomeration, can be synthesized by this method, what ' s more, the size of the powders will be increased as the increasing of the concentration of starting solution, temperature and time for calcining. so products with needed size can be synthesized by choosing the appropriate conditions

    產物超細粉的xrd和tem圖譜表明，該方法可以合成粒徑為15 98nm左右、分佈較為均勻、沒有明顯硬團聚的納米氧化物超細粉，而且其粒徑會隨起始溶液濃度的增加、凝膠煅燒溫度的升高和煅燒時間的增加而增大。
分享友人
分享到 Line

分享到臉書