時間增益補償 的英文怎麼說

中文拼音 [shíjiānzēngyìbǔcháng]
時間增益補償 英文
tgc
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 益 : Ⅰ名詞1 （好處） benefit; profit; advantage 2 （姓氏） a surname Ⅱ形容詞（有益的） beneficialⅢ動詞...
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. Time gain compensation

    時間增益補償
  2. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  3. ( 2 ) using the method of parameter identification in literature [ 117 - 118 ], selecting gain function : giving the initial value of the parameter observer from the time serial of output variables of the system, the numerical simulation result shows that the parameter observer proposed in this paper can identify the unknown parameters of the system quickly and exactly no matter if the parameters keep invariable or change in some rule, and the identifying speed is faster than the method in [ 117 - 118 ], when the unknown parameters are being identified, vith parameter compensator, it can synchronizes two hyperchaotic systems completely even if some parameters mismatch

    （ 2 ）採用文獻[ 117 - 118 ]提出的參數辨識方法，通過選取更一般的增益函數： l _ i （ x _ i ） = kx _ ii = 1 ， 2 ， 3並根據系統輸出變量的時間序列給出參數觀測器的初始值來進行參數辨識，數值模擬結果表明：採用本文的參數觀測器，在系統參數固定或變化的情況下，都可對系統未知參數實現快速高精度辨識，辨識的速度快于文獻[ 117 - 118 ]提出的方法；在辨識參數的同時，結合參數補償器，使兩個參數不匹配的超混沌系統同步。
分享友人
分享到 Line

分享到臉書