晶粒 的英文怎麼說

中文拼音 [jīnglì]
晶粒 英文
[物理學] crystalline grain; grain crystal; grain; crystal particle晶粒玻璃 ambetti; 晶粒尺寸 crystallite dimension; 晶粒粗化 grain coarsening; 晶粒大小 grain size; 晶粒結構 graininess; 晶粒界限 grain mark; 晶粒碎裂 grain fragmentation; 晶粒形狀 grain shape
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  1. Austenite grain growth behavior of steel 33mn2v designed for oil - well tubes

    的奧氏體晶粒長大規律
  2. Influence of hot rolling technology on austenite grain size of 20mnmob steel

    鋼奧氏體晶粒度的影響
  3. This paper has emulated the complex process of bioceramic " s degradation by using the computer simulation technique and studying the principle of material " s degradation, and combining the grain growing model with material degradation model

    本文利用計算機模擬技術，在深入研究了生物陶瓷體內降解機理的基礎上，將晶粒長大模型和材料降解模型有機結合，用於模擬生物陶瓷的降解過程。
  4. Impurities tend to segregate at grain boundaries.

    雜質常常在晶粒間界偏析。
  5. Two area defects are twins and grain boundaries.

    有兩種面積缺陷，即孿生和晶粒間界。
  6. Though the conventional coarse - grained bn was milled by high - energy ball milling for 5 hours with carbinol, the grain size was scarcely changed

    加入甲醇高能球磨工業生產的bn （約200目） 5小時以上，晶粒大小沒有明顯的變化。
  7. Effect of microalloy element on the grain coarsening behavior of q345 steel

    345鋼奧氏體晶粒粗化行為的影響
  8. Effect of ti content on coarsening temperature and austenite grain size of ah

    36粗化溫度和奧氏體晶粒大小的影響
  9. When ph value < 0. 5, faster deposition rate, faster growth rate of crystallizing nucleus, which causes bigger crystalline granularity and bad surface quality of the deposits such as crassitude or darkling

    Ph 0 . 5時，沉積速度過快，晶核成長速度快，晶粒粒度較大，鍍層表面粗糙、發黑，表面質量差。
  10. Method for crystallite size determination in metal catalysts by x - ray diffractometry

    用x射線衍射儀測定金屬晶體中晶粒大小的方法
  11. General rules for the determination of particle size and crystallite size in metal catalysts

    金屬晶體中粒徑和晶粒大小測定的一般規則
  12. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  13. The influence of the disturbing and anisotropy on dendrite growth has been investigated

    研究了噪聲和各向異性等參數對晶粒形貌的影響。
  14. For electrodeposition by dc methods, the metals deposite uninterrupted and the particles were also embeded uninterrupted into the coatings ; for electrodeposition by pc method, the particles with biggish volume were desorbed from the coatings and returned to the electrolyte again owing to the presence of pulse interval ; for electrodeposition by prc method, the particles carried positive charges are much more easy to desorb from the coatings owing to the effecf of reverse pulse current combined with pulse interval, in addition, the reverse pulse current also could dissovle the metals, further accelerates the desorption of particles, thus the particles size embeded in the coatings by prc method is the least

    直流電沉積時，基質金屬的沉積連續進行，粒子在電極表面不間斷嵌入鍍層;單脈沖電沉積由於脈沖間歇的存在使得具有較大體積的粒子會脫附，重新回到溶液中;採用周期換向脈沖時，反向脈沖電流使表面荷正電的較大的粒子更易從電極表面脫附，同時，反向脈沖電流對基質金屬的溶解作用，也會促進粒子的脫附，因此鍍層中復合粒子尺寸最小。隨著鍍層中粒子復合量的增加，三種鍍層的晶粒都明顯細化，說明al _ 2o _ 3的存在阻止了晶粒的長大，提高了電沉積過程中晶核的形成速率。
  15. The results show that the grain of the strip was refined in the cold rolling process due to the drx and drv

    結果表明：在冷軋過程中，因動態再結晶和動態回復，使薄帶的晶粒進一步得到細化。
  16. Simulation of grain growth in the haz of stainless steel eb

    1不銹鋼焊接熱影響區晶粒生長模擬
  17. The resultant grains tend also to be elongated along the direction of deformation.

    所形成的晶粒沿變形方向被拉長。
  18. In one, equiaxed dendrites form and subsequently ripen into more - or - less spheroidal shape, suitable for forming

    一個是先形成由等軸晶粒構成的晶枝體，再熟化形成類似的球狀體。
  19. 4. after continuously heated and isothermally soaked, the equiaxed grain, as the result of the recrystallization, was the necessary texture condition of the semi - solid grain ' s globalization processing

    4 、連續升溫和等溫保溫過程中再結晶形成等軸晶，為半固態晶粒球狀化提供了必西安理工大學碩士學位論文要的組織條件
  20. The globalization course was that the preformed texture recrystallized and became the granular equiaxed grain, when the temperature rose and the holding time prolonged, the granular grain melted at some area and at the liquid - solid interface the grain globalized at the role of the curvature overheated

    過程機制為：擠壓形變組織在加熱過程中首先發生再結晶長大變為顆粒狀等軸晶；隨溫度升高和保溫時間延長，等軸晶發生局部熔化，液固界面的曲率過熱使晶粒外形向球狀轉變。
分享友人
分享到 Line

分享到臉書