最低負載 的英文怎麼說

中文拼音 [zuìdīfùzǎi]
最低負載 英文
minimum load
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 負載 : [電學] load
  1. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析，變頻器輸出的電壓波形諧波大，沖擊大，電壓上升率高達6600v / s ，是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低，額定頻率在8 - 20hz ;調速范圍寬，最低運行頻率低到0 . 5hz ，起動次數相當頻繁，每小時高達600 - 800次，沖擊負荷大，過載能力要求較高。
  2. In the leach - new protocol, the mainly improvement of the leach protocol exhibits as follow : for the sake of balancing the network load, the network choose the clusters based on the residual energy ; we take multi - hop communication between sensors instead of single - hop communication, which results in the reduction of energy consumption of clusters ; the new protocol finds the path to the cluster head with the minimum cost, using an algorithm similar to flooding to propagate the cost information and greedy algorithm to find the lowest cost link ; the algorithm for assigning tdma time slot reduces overall delays of network

    在leach - new協議中，對leach協議的改進主要體現在以下幾個方面:根據節點剩餘能量選擇簇頭，以平衡網路負載;節點間採用多跳路由，降低簇頭能量消耗;節點根據能量消耗的代價來選擇至簇頭的路由，通過擴散演算法來廣播代價消息，採用貪婪演算法來選擇能量消耗最小的路徑;採用tdma時隙分配演算法減少網路時延。最後，利用ns2模擬軟體進行驗證。
  3. Simulated results showed that the proposed algorithm is available to construct effectively and quickly, the multicast tree satisfying delay constraint and lowest link cost, with network load balance taken into account to pick out the cheaper idle route

    模擬結果表明，該演算法在考慮網路的負載均衡情況下，選擇鏈路代價較低的空閑路徑，快速、有效地構建滿足時延要求，鏈路代價最小的組播樹。
  4. The key items include the car sinking, constant speed characteristics, inspection function, auto relevelling function and level accuracy, etc. the research contents focus on the following three parts : firstly, research on effects of system parameters on car sinking has been completed. secondly, the constant speed performance with the compensation of internal leakage of pump / motor is improved. lastly, research on improvement of the car level accuracy and contrast to that of traction elevators is presented, and the reasons of low car level accuracy of hydraulic elevators are discussed

    重點研究了三方面內容：一是研究了停層沉降特性及影響電梯轎廂停層沉降特性的各種因素；其次是通過負載壓力補償液壓泵馬達內泄漏來改善電梯轎廂速度穩定性；最後是液壓電梯平層精度的理論和實驗研究，並與曳引電梯的理論模型進行了對比，闡述了液壓電梯平層精度低的原因，理論探討了影響液壓電梯平層精度的主要因素。
  5. The genetic algorithm with load balance can solve routing problem and can be applied in mobile ip and next hop route. chapter 4 collaborates on routing problem via a designated node. due to the excellent performance in nondeterministic polynomial problem, such as tsp, we choose the genetic algorithm to implement triangle routing in mobile ip protocol

    本文第三章提出了基於矩陣編碼的遺傳演算法的最低費用的下一跳路由，解決浙江大學博士學位論文了下一跳路由中不考慮網路負載和時延可能產生擁塞的問題，優化了網路的性能，使得網路中的帶寬得到合理分配。
  6. Bus capacity is the maximum load that can be carried on a system without causing degradation of the generator frequency to less than a prescribed level ( usually 59 hz in a 60 hz system )

    母排容量母排容量是指在發電機頻率不被壓低的情況下，系統所能帶動的最大負載。
  7. Bus capacity bus capacity is the maximum load that can be carried on a system without causing degradation of the generator frequency to less than a prescribed level ( usually 59 hz in a 60 hz system )

    母排容量母排容量是指在發電機頻率不被壓低的情況下，系統所能帶動的最大負載。
  8. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電阻及電源電阻均高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最高，在該頻率之半時則電壓均為最低。
  9. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最低，在該頻率之半時則電壓均為最高。
  10. Improvements in performance include reductions in specific fuel consumption ( 4 % ), take - off distance ( 10 - 20 % ), minimum speed ( 100 kias ), time to climb and increase in specific excess power, sustained load factor and sustained turn rate ( 15 % )

    性能改進方面包括減少4 %的耗油率，縮短10到20 %的起飛距離，減少最低速度大約一百指示空速節，縮短爬升時間和增加單位剩餘功率，提升15 %的持續回轉率與持續負載系數。
  11. Strain - gauge load cell or force transducer, minimum load impedance 320r

    應變測壓元件或傳感器的最低負載阻抗為320r 。
  12. This thesis illustrates the design of jobs management system - jms. lt can implement load balance in distributed computer system. users can make sufficientlly use of all kinds of resources, enhance efficiency and reduce cost in distributed heterogeneous network environment

    該系統可使分散式計算機系統實現負載共享，使用戶最大限度地利用分散式異構網路環境中的各種資源，以達到提高效率、降低成本的目的。
  13. Load shedding load shedding is the process by which the total load on a paralleling system is reduced, on overload of the system bus, so that the most critical loads continue to be provided with reliable electrical service

    卸載在超載的系統母排上，並聯系統的總負載被降低的過程稱為卸載，以確保最關鍵負載獲得可靠的電力供應。
  14. 2 ) all existing routing algorithms try to adapt to network dynamics reactively, while built - in properties of internet traffic is overlooked ; 3 ) there has not been developed an effective routing mechanism for differentiated service networks, which has been found to face the problem of " inter - class effect "

    2 ）以提高網路服務質量和資源利用率為目標，是否能夠從網路負載的內在特性出發獲取最優路由方法? 3 ）對多等級服務網路，缺乏一個以合理帶寬共享機制為基礎的高效、低阻塞路由方法。
  15. Finally, the design and the test experiment of a high power matching load are introduced. the load has a steady resistance of 5. 82

    最後，介紹了實驗中設計並研製的大功率低電感匹配負載，該負載冷測電阻值5 . 82
  16. Tree construction is a commonly used approach in solving the multicast routing problem. one advantage of multicast tree is that data are distributed to different multicasting destinations along the branches in parallel, which reduces the delay. the other is that message need only be replicated at forking nodes, which minimizes the data replication, spares the network bandwidth, reduces the network load and lessens the congestion

    實現組播的一般方式是建立組播樹，組播樹的優點在於：首先，信息以并行方式沿著樹枝發送到不同的組播終點，從而降低了信息傳遞的時延；其次，信息的復制只在樹的分支處進行，因此網路中需要傳送的復制信息量最少，能夠節約網路帶寬資源，降低網路負載，減少擁塞。
  17. The theoretical analysis of large cryocondensation pump for nbi was mainly concerned. this paper emphasized on analyzing and calculating the heat load of cryocondensation pump, simulating thermal transmission coefficient and molecule transmission coefficient of radiation baffle according to monte carlo method, analyzing the process on cryo - surface and the factor of affecting pumping speed and hydrogen layer thickness of influencing cryo - parameter, etc. finally by verifying the pumping speed on large cryocondensation pump for neutral beam injection system, the pumping speed of 4. 0x105l / s ( for h2 ) was proven to be reasonable

    本文首先介紹了中性束注入系統的國內外發展狀況，闡述了中科院等離子體所ht - 7中性束注入系統的構成，主要對用於中性束注入系統的大型低溫冷凝泵的特性進行了理論分析；對冷凝抽氣面的熱負載進行了分析計算；用蒙特卡羅法對輻射擋板的分子傳輸幾率與熱傳輸幾率進行了模擬計算；研究了低溫表面的處理方法對抽速的影響以及氫層厚度對各低溫參數的影響；最後對用於中性束注入系統的大型低溫冷凝泵的抽速進行了驗證，得出的結論是：選取40萬升秒的抽速是合理的。
  18. Explains how different types of caching can be used to maximize the performance and minimize the workload of each layer of a distributed web application in websphere application server

    ：說明了如何使用緩存的不同類型最大化性能以及在websphere application server中將分散式web應用程序每一層的工作負載降到最低。
  19. In the power - amplifying grade of drive circuit, the system adopts a method of high / low voltage drive that is different to the conventional drivers. so the high frequency performance of the system is improved and the load support capability of step motor is increased. by the software method, the control principle of the optimum increasing / decreasing frequency of step motor is achieved

    在驅動電路的功放級採用了一種不同於傳統驅動器的高低壓驅動方式，改善了系統的高頻性能，增加了步進電機帶負載能力，以軟體方法實現步進電機最佳升降控制規律，實現了步進電機的快速啟、停控制。
  20. According to the electricity ( wiring ) regulations, a low - voltage fixed electrical installation in a residential or commercial building with an approved loading exceeding 100a is required to be inspected, tested and certified at least once every five years

    根據《電力（線路）規例》 ，裝設于住宅或商業房產內的低壓固定電力裝置如其允許負載量超逾100安培，須最少每五年作一次檢查、測試及領取證明書。
分享友人
分享到 Line

分享到臉書