最大偏置值 的英文怎麼說

中文拼音 [zuìpiānzhìzhí]
最大偏置值 英文
peak bias value
  • : 副詞(表示某種屬性超過所有同類的人或事物) most; best; worst; first; very; least; above all; -est
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  1. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為: ( 1 ) 、這次冷渦在其發生發展過程中,其移動路徑是沿經圈直線南壓,攜帶的冷空氣勢力較強,形成槽后較強的垂直運動; ( 2 ) 、西太平洋副熱帶高壓北位與東北冷渦南壓形成的急流軸,把源源不斷的西南暖濕氣流輸送到遼西地區,也就是急流軸的左前方位,為這次暴雨的產生提供了充足的水汽來源; ( 3 ) 、低空急流不但為暴雨輸送水汽,其造成的較強的垂直環流也是產生強降水的一個主要原因; ( 4 ) 、 mm5模式以四維同化資料作為初始場,限度地避免了觀測誤差可能造成的積分不穩定,提高了模擬結果的參考價
  2. The influence of the eccentricity mass moment, position of mass center and the bearing stiffness to the vibration characteristics of the rotor system is discussed in detail ; 3. to verify the exactness of fem and learn the principle of vibration of dredge pump further, the orbit of the rotor shaft of the pump in the dredger is measured, the measurement results show : the repeat of the orbit of the rotor shaft is very bad when dredge pump is in the dredging mud condition

    模態分析確定了泥泵的振動特性(固有頻率和振型) ;諧響應分析確定了泥泵轉子軸在心力的作用下軸截面處的響應位移;研究了轉子軸的質心位、軸承剛度和質量心矩對轉子軸振動特性的影響; 3 、採用軸心軌跡法,實船測量了泥泵軸工作時振動響應
  3. The influence of msfvw bandwidth on the diffraction efficiency is also considered. for the nonuniform bias magnetic field of u - type parabola profile, when the msw frequency is less than the cut - off frequency at the edge of mo film, the effective mo interaction length reduces. the edge cut - off frequency is determined by the maximum of the nonuniform field

    對于拋物型分佈(開口向上)的磁場,當激發靜磁波的rf頻率小於邊緣截止頻率時,磁光作用的有效長度減小(與靜磁波頻率有關) ;邊緣截止頻率由不均勻磁場的決定,靜磁波的下限截止頻率由不均勻場的確定。
  4. The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field

    具體工作可以概括如下:首先,研究了vcsel的熱場特性,分析了電流擴展,材料參數和工作條件對于溫度分佈的影響;其次,從電極電壓入手,計算出激光器中的等勢線分佈,並對不同深度處的電壓和電流分佈進行比較,研究了高阻區的不同位和不同厚度、限制層和出射窗口半徑的小對電流密度、載流子濃度和溫度分佈的影響;再次,實現了電、光、熱耦合,求出了閾電壓,計算了不同電壓下的電流密度分佈、載流子濃度分佈和熱場分佈,分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響;後,給出了考慮n - dbr和雙氧化限制層時激光器中的等勢線分佈,分析了n - dbr和雙氧化限制層對vcsel電流密度、載流子濃度、溫度和光場分佈的影響。
  5. Due to the existence of the eddy and the abrupt bend of the stream line, the pressure on the four faces has the distribution as follow : the lowest pressure appears at several centimeters after the angle point along the top boundary, the highest pressure appears near the center line of the vertical shaft on the bottom boundary, near the angle point, the pressure on the inner boundary decreases with the decreasing height, the pressure on the external boundary decreases slightly in the right - angle region, and increases obviously near the corner

    迴流漩渦的存在,以及直彎處流線的急劇彎曲,導致壁面壓力分佈在上表面距彎點一定距離后出現壓力,下表面上,在豎井中心線略下游的位出現壓力,豎井內表面接近彎點處出現壓力沿程降低的現象,豎井外表面壓力在進入直彎后先是沿程略有降低,在直彎角落處又明顯升高。
  6. Abstract : calculation formulas are established based on the functions of given movement and dynamical conditions by means of extremum theory, making analytical design of an offset slider - crank mechanism more convenient and good for extend

    文摘:本文根據曲柄滑塊機構的運動特性和傳力特性所建立的函數關系,運用極理論推導出給定條件下傳力特性佳的計算公式,方便了設計應用,得推廣。
  7. It can be found that the two models can measure the credit risk better and their numerical values of the var are relatively close, which means that at a certain confidence level, the portfolio ' s maximum loss calculated under the default model is familiar to the maximum loss in value resulted from the credit metrics model. however, under the default model the standard deviation of the loss of the loan is a bit more than the one which deviates from the average value of the loan under the credit metrics model ; in addition, the conclusion also demonstrates that the two models have some differences in the measuring the capital reserve to some extent

    從結果可以看出,這兩個模型均能較好地度量銀行貸款信用風險,其計算所得的var比較接近,說明在給定信水平下所能達到的損失和所能達到的價上的損失在數上是相近的;不過,違約模型下貸款損失的標準差要比creditmetrics模型下的貸款價離其均的標準差要些;此外,結論還表現出二者在計量資本金要求上有所差異。
分享友人