最大增壓功率 的英文怎麼說
中文拼音 [zuìdàzēngyāgōnglǜ]
最大增壓功率
英文
maximum boost horsepower-
Using jgp560c magnetron sputtering equipment, cu / ag film are deposited on cd1 - xznxte substrate by dc magnetron sputtering in order to get the influences of the main experiments parameters such as sputtering power, gas flow, vacuum air pressure, magnetoelectricity power and substrate temperature on deposition rate of film, discovered that dc sputtering power is the most key factor influencing the deposition rate
在jgp560c型超高真空多功能磁控濺射鍍膜機上，採用直流磁控濺射法在cdznte晶體上制備出cu ag合金薄膜，揭示了氣體流量、直流濺射功率、勵磁電源功率、工作氣壓和襯底溫度等工藝參數對沉積速率的影響規律。結果表明濺射功率對沉積速率的影響最大，隨濺射功率的增大沉積速率快速增大。At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique
最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。Quick and frequent cutting for a few sets of capacitors shall be carried out, of which the factors of electric power shall be maitained in optimum condition so as to minimize the line loss, increase effective output capacity of distrubuting transformer and optimize the quality of power demand
對多組電容器進行快速而頻繁的投切，使受電功率因數始終保持在最佳狀態，從而最大限度地降低線路損耗和增加配電變壓器的有效輸出容量，優化用電質量。The ratio f / c decreases with the increase of power, but increases when pressure increase. the power has more marked effect on f / c than that of pressure. contact angle of fluorocarbon films obtained at different of power, pressure and treating time
最後研究了不同功率、壓力、濺射時間對氟碳膜憎水性能的影響，並測量了氟碳膜的接觸角，發現接觸角隨功率的增加而減小，隨壓力的增加而增大。The results show that wavelength locates in gain zone of semiconductor optical amplifier, and have higher peak power and proper time delay between the two pulses for the second order super gauss control pulse in semiconductor optical amplifier. a high quality amplified signal pulse can be achieved. the chirp can be reduced notability by using cascading soa in cross gain modulation based on soa, and the distance and the peak power of conversion optical pulse can be increased notability, and we can let down the demand for wavelength based on xgm in soa and enhance the flexibility of wavelength conversion
我們應用二階超高斯光脈沖與高斯信號脈沖同時注入soa和應用soa與非線性光學環鏡（ nolm ）相結合的方案來對信號脈沖進行壓縮整形，模擬顯示，在調節系統合適參數的情況下，波長位於soa增益區的二階超高斯控制光脈沖在具有較高的峰值功率和適當時延下輸入soa時，最後可以得到放大的高質量超簡訊號光脈沖；在基於soa的交叉增益調制（ xgm ）全光波長轉換中，採用級聯的soa能有效地使反轉光脈沖的頻率啁啾得到有效降低，波長向下轉換的距離和反轉光的峰值能量都得到明顯提高，降低了利用交叉增益調制（ xgm ）波長轉換中對波長精度的要求，從而提高了波長轉換的靈和性。The results show that the output power decreases with the increase of the diode voltage in the range of 330 ~ 425kv. the input current exist a start value and also an optimum one. they are in the range of 20 ~ 25ka and 28 - 31ka, respectively
結果表明，在33okv ~ 425kv范圍內，微波功率隨二極體電壓增大而減小; rtto存在起振電流和最佳電流，其值分別在20 ~ 25ka和28 ~ 3ika范圍。The simulation results show that to start the oscillation, the length of the resonance cavity must be well matched with the radial span of the cavity ; mismatch of them will greatly affect the microwave development ; the output power of the microwave in rtto is affected by the microwave mode obviously. under the same conditions, the output power for temooi mode is the highest, and its start and saturation time of oscillation are the shortest. the results also show that the output power will decrease with the increase of the size of the extract window ; the operating state of rtto has great close relationship with the operating current, and there exists an optimum current value
結果表明，束電壓一定時，諧振腔腔長和徑向間距必須良好匹配微波才能起振，匹配不佳會極大地影響微波產生；微波模式對微波產生功率影響很大，同等條件下， tem _ （ 001 ）模式的微波功率最高，起振時間和飽和時間最短；微波輸出功率隨提取口的增大而減小； rtto工作狀態與工作電流的大小關系密切，存在一個最佳工作電流值。分享友人