最大輸出電感 的英文怎麼說

中文拼音 [zuìdàshūchūdiàngǎn]
最大輸出電感 英文
maximum output inductance
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. Compared to the traditional converter, the new one can transform electric power from a static part to a rotary part without an electrocircuit connection, which makes the contactless power transform come true. one application of this converter is to supply a steady and regulable excitation circuit for synchronous generator by integrated its second winding with the motor while its primary winding is static. the thesis gives two methods of the rotating converter design paticullarly : flyback and fullbridge, and explains how the circuits are designed

    通過理論分析、模擬分析和實驗驗證，得出這兩種旋轉變換器都能進行感應電能傳輸，但它們的傳輸功率是不同的，反激式旋轉換器最大隻能傳輸幾十瓦功率的感應電能，因此只能用在感應電能傳輸較小的場合，或者信號傳輸的場合;而全橋式旋轉變換器能傳輸較大的功率，可用於電機的新型無刷勵磁方案中。
  2. Comparing and analyzing the synchronous control strategy, which brings up the new method to control the double un - symmetry jars proceed synchronously with the combination of proportional valve and servo valve, which forms closed loop control ; basing on the above methods, models are made to get mathematics models of position control system and to analyze system model theoretically by using pid controller, we can realize regulating parameters, minimizing synchronous errors and enhancing the dynamic performances ; the simulink tool box in matlab software is used to imitate the system according to the model, which not only makes the result visual and easy to adjust the parameters in interactive way but also lets us understand the effects of different parameters and optimizes the dynamic properties. the theory of plc control in dshp is discussed after advanced understanding of the system movements. hardware design and general regulation are given on the base of siemens company products s7 - 200 plc

    本文根據大量的國內外文獻，對研配液壓機的工作原理及設計結構進行了簡介；對位置同步的控制方法進行了比較分析，提出比例閥和伺服閥復合控制的閉環結構來對非對稱雙缸進行同步控制電液比例同步控制方案；在此基礎上著重對比例閥控非對稱缸建模，最後得到位置控制系統的總體數學模型，從理論上對同步系統動態特性進行了分析，並用pid控制器進行參數整定，減小雙缸同步誤差、提高系統的動態響應性能；其中控制性能的分析藉助于matlab軟體中的simulink工具箱，由已建立的數學模型形成模擬模型，得到可視化的模擬結果，從而利於交互方式下調整參數，了解不同的參數對系統的影響，優化同步系統的動態性能；在深入了解系統的動作特性后，對plc控制研配液壓機的原理進行了探討，針對siemens公司s7 ? 200型plc給出了硬體設計的總體規劃，編制出研配液壓機動作控製程序，在編程中著重研究位移傳感器與plc的通訊、雙缸同步運行的pid控制在plc上的實現及bcd碼撥盤輸入程序的植入問題。
  3. Then a thorough analysis to the bias - magnetic of ppfc is made. the retraining effects of the main parameters ( include clamping capacitance c, output filter inductor lf, load r, the leakage inductor ls and source winding resistance r ) are studied under the conditions of different von, different ton and different winding parameters. then a conclusion can be drew, that the smaller lf and the bigger r are, the better the bias - magnetic is restrained and c has a best value to retrain the bias - magnetic

    分別對管壓降不同，導通時間不同以及兩原邊繞組參數不一致（包括漏感、電阻、激磁電感三種情況）的情況下，主要參數（包括箝位電容c 、輸出濾波電感lf 、負載r 、原邊繞組漏感ls 、原邊繞組電阻r ）對偏磁的抑制作用進行了模擬分析研究，得出lf越小， r越大時激磁磁勢偏移量ni越小， c在其他參數確定時對抑制偏磁有最優值等結論，為參數的優化設計提供了依據。
  4. Moreover, an optimized lna structure - inter - stage inductor matching - is presented, which can achieve conjugate match of two stages, maximize the forward transmission, sequentially increase the signal noise ratio ( snr ) and reduce the noise figure

    並提出了級間匹配電感的設計方案，此優化結構能實現兩級之間的共軛匹配，使信號的正向傳輸最大化，從而增大信噪比，降低了噪聲。
  5. The anterior pagoda neuron is one of the largest neurons in the leech nervous system. it receives multiple sensory inputs. the physiological function of ap is unknown. with the combination of intra - and extra - cellular electrophysiological recording methods, it is suggested that ap neuron modulates the membrane potential of multiple muscle cells in the contralateral body wall

    水蛭前寶塔神經元ap是神經節前側囊中胞體最大的神經元，它接受多種感覺傳入，但傳出功能未知。通過應用細胞內外電生理學記錄結合方法，揭示了ap神經元的輸出效應可能是調制水蛭體壁肌肉細胞膜的興奮水平。
  6. This contact is normally closed, if an error occurs short - circuit at supply voltage -, sensor or signal cable of force transducer max. output signal exceeded problems with supply voltage the output opens

    但如果有錯誤供電電壓短路傳感器或力傳感裝置的信號線超出最大輸出電壓或者供電電源有故障發生時，觸點的輸出打開。
  7. Maximum output inductance

    最大輸出電感
分享友人
分享到 Line

分享到臉書