最大頻率誤差 的英文怎麼說

中文拼音 [zuìdàbīnlǜwùchā]
最大頻率誤差 英文
maximum frequency error
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 頻率 : frequency; rate
  • 誤差 : error
  1. And then facing the problem of the channel estimation of the adaptive modulation system, we conclude out the channel estimation algorithms on maximum likelihood ( ml ) estimation and maximum a posteriori ( map ) estimation under the condition of flat fading channel and selective fading channel in detail. to meet flat fading channel, we simulate the relationship of the ratio between the error covariance in map estimation and ml estimation and pilot symbol message length. the conclusion can be drawn from these results

    接著，對自適應調制系統中的通道估計問題難點，詳細推導了平衰落通道條件下和選擇性衰落通道條件下最大似然（ ml ）估計和最大后驗概率（ map ）估計演算法，針對平衰落通道，我們模擬了map估計和ml估計的方差與導頻符號長度的關系，模擬結果表明，錯誤方差受多譜勒頻率的變化影響最大，並且對實際的自適應調制系統，導頻符號長度的取值超過20個符號長度時， map通道估計明顯優于ml通道估計。
  2. The research result indicated : for the strip primary mirror discussed in this article, the hexagon light - weighted cell has the best structural rigidity quality, the square cell is a little worse, the triangle cell is the worst ; there is an optimum on primary mirror thickness ; on condition of 1g gravity load combining with 4 centigrade uniform temperature rising, the thinner and higher of the flexible support reed, the better of the primary mirror surface figure. the decision of the structural parameters of the flexible support reed must take static rigidity, dynamic rigidity, static strength and dynamic strength of primary mirror assembly into account

    研究結果表明：對于本文的長圓形主鏡，採用正六邊形輕量化孔，鏡體結構剛性品質最好，正方形次之，正三角形最差；主鏡鏡體厚度存在最佳值；主鏡組件在1g重力、均勻溫升4共同作用的工況下，主鏡柔性支撐簧片厚度越小、高度越高，主鏡綜合面形誤差（ p - v值）越小，但同時主鏡組件的剛體位移增大、固有頻率下降，因此柔性支承結構參數的確定要綜合考慮主鏡的綜合面形誤差和主鏡組件靜態剛度、動態剛度、靜態強度和動態強度等因素。
  3. On any axis, frequency for 200 hz, max. causes error is 0. 05 % g of range

    在任意軸上，頻率為200hz ，引起的最大誤差為量程的0 . 05 % g
  4. Since 1960 ", the methods for charactering time - frequency stability in time - domain have been in progress. the methods include allan variance, modified allan variance, time variance, hardamard variance, total variance, time interval error ( tie ) and maximum time interval error ( mtie ), of which tie and mt1e are usually used for telecommunication network

    自20世紀60年代以來，時間及頻率穩定度的表徵方法一直在不斷的發展，有阿侖方差、修正阿侖方差、時間方差、哈達瑪方差、總方差以及常用於電信網路的時間間隔誤差（ tie ）和最大時間間隔誤差（ mtie ） 。
  5. The thought that sampling frequency in targets measure system confirm as 3 is studied for the first time. it is proved from three aspects : the frequency spectrum of track, the error requirement of project and the rate of maximum number of allowable lost points in project

    本文首次就目標坐標測定儀中采樣頻率確定為3hz的思想進行了研究，並分別從目標航路功率譜密度、實際工程中誤差要求和允許的最大漏測點概率等三方面加以論證。
  6. Assisted with the sensitivity of the linear analog circuits, the feasibility of parametric faults detection was analyzed through the maximum fault errors acquired at the sensitive frequencies, a stimulation matrix and its stimulation expression were put forward on the test points information

    摘要從線性模擬電路靈敏度的概念入手，分析了通過獲取敏感頻點激勵下的最大故障誤差來檢測電路參數故障的可能性，提出了一種針對測試頻率和測點信息的激勵矩陣。
  7. The maximum permissible error when the working frequency of resistor is equal to or lower than the measurement frequency

    電阻箱的工作頻率等於或低於測試頻率上限時的最大允許誤差。
  8. In this topic, the error characteristic of resistance voltage sensor was analyzed in theory, by using electric circuit analysis, the reasons which affected its error were gotten. based on theory analyses, initial structure was designed. then by using fem ( finite element method ) of simple resonance field, several structures electromagnetic field was calculated, and their amplitude errors, phase errors, maximum of electric field intensity and frequency characteristic of amplitude error were contrasted

    本文從理論上分析了電阻式電壓傳感器的誤差，用電路分析法定性的研究了影響電阻分壓器誤差的因素；在理論分析的基礎上進行了電阻分壓器結構的初步設計；基於該設計，利用簡諧場的有限元方法進行了場的計算，比較了幾種結構方案的幅值誤差、相角誤差、最大場強值及其幅值誤差的頻率特性，從而得到一種最優方案；製作了分壓器樣機，並在本實驗室進行了實驗；最後，對電子電路部分進行了初步設計，並提出了抗干擾的措施。
  9. Secondly, the dissertation proposes a novel blind symbol - timing scheme for ofdm systems based on cyclostationarity feature of received symbols. the proposed schemes also exploits the periodicity of ofdm symbol introduced by cyclic prefix, by applying 2 - dimentional fourier transformation and choosing the appropriate correlation peak value as the symbol start location, the precision of this scheme is higher than previous conventional method. thirdly, the dissertation presents analysis with regard to channel estimation of ofdm systems. several interpolation algorithm in ofdm systems which based on pilot sequence have been analyzed in the first instance, and the influence of the channel noise on interpolation precision has discussed. the theoretic analysis and simulation results show that : the interpolation error induced by the precision of interpolation procedure itself has out weight

    第三，論文在ofdm系統的通道估計方面，先對基於導頻的ofdm通道估計中的多種插值方法進行了分析，討論了噪聲對插值精度的影響，指出插值本身的精度所造成的插值誤差遠大於噪聲所帶來的插值誤差，從而階次更高的插值演算法在實用中並非最優的;並指出插值濾波法比變采樣率演算法對噪聲的影響更為敏感，在信噪比較高時插值濾波演算法比變采樣率演算法更優。
  10. The error of distortion which harmonic distortion meter detects can be least controlled 1. the lowest frequency which harmonic distortion meter can detect is 0. 0001hz. but, generally, this kind of meter is so costly and difficult to operate that the major portion of the distortion meters applies the method of suppressed fundamental harmonic

    採用諧波分析法的失真度儀測得的失真度的最小誤差可控制在千分之一以下，頻率最低可達到萬分之一赫茲，但普遍存在儀器價格較貴，操作繁瑣的缺點，現在用的失真度測試儀大多是用基波抑製法。
  11. Finally, the small computing load and error, and the better estimation effect can be obtained when sampling frequency is more than 4hz and sliding window is between 10 and 20 and polynomial exponent equals 3 or 4 by the computer - based simulation

    最後通過計算機模擬說明在預測海上艦船運動時要求采樣頻率大於4hz ，滑動窗大小取10 20 ，多項式為3或4階時計算量和誤差較小，預測效果較好。
分享友人
分享到 Line

分享到臉書