最高燃燒溫度 的英文怎麼說

中文拼音 [zuìgāoránshāowēndù]
最高燃燒溫度 英文
peak flame temperature
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 溫度 : [物理學] temperature
  1. At last, the conclusions of the whole thesis are drawn, and it is put forward that the future research emphases on the infrared radiation absorption ct technology should focus on : instantly get the absorption projections are the crucial factor to utilize the technology industrially ; on the basis of the hypothesis that the gas is ideal gas, species concentration of particular gas medium can be measured at the same time, which must be helpful to comprehend combustion essence ; if laser source to replaces blackbody stove, for irradiant flame, interferometric projection can be attained, and its temperature distribution will known

    最後，對全文進行了總結，並指出今後研究工作重點。指出：瞬時得到各方向的投影是此技術實用化關鍵；在獲得溫度分佈信息基礎上，進行必要的假設和推導，能同時得到火焰中某特定組分濃度的分佈，這必將進一步我們對燃燒本質的理解；利用方向性好，輻射強度高的激光源代替常規的黑體爐，能得到輻射干涉投影圖像，這樣就能測量所介紹系統不能測量的發光火焰溫度分佈。
  2. According to finite element segmentation principle, by combining test with observation, the author has measured the air streamline and speed distribution of burning equipment in dally situation, which provides some guide for research of air field in hearth on cold and hot conditions. and the law is found of air speed distribution by measuring its speed and distribution of upper and lower deck on cold condition, thus it lays the foundation for analysis on hot condition. under four burning states, we measure the air speed in single, double - deck, and find out its corresponding distribution law

    5 .根據有限元分割原理布置測點，採用降溫方法，用k五江9106等儀器分別測出單雙爐排燃燒方式4種不同工況下，該燃燒設備爐膛內coz 、 02 、 co氣體濃度，並找到了隨爐膛高度方向及深度方向變化規律;從燃燒原理分析評價了2種燃燒方式爐膛內coz 、 02 、 co氣體濃度場分佈特點及相應燃料層內乾燥、干餾、氧化、還原、灰渣層厚度，肯定了雙層爐排燃燒方式爐膛中c02 、 02 、 co氣體濃度場分佈合理性，從燃燒理論找出了最佳濃度場分佈狀態及燃料層內各反應層厚度。
  3. This paper facous on the micro - computer control of the burning furnace system. taking to meet the requirements of the user ' s as basis, it is designed about computer in hardware and software it brings forward a scheme of intelligent & fuzzy - control based on 8098 single - chip micro - computer to get the best proportion of fuel oil and burning air, to realize the auto - contral of the temperature of flue gas in or out the burning furnace. so the accurate efficiency is received, this can ensure the ahf unit having a high production and low costs and energy

    在控制上以滿足新爐型的設計要求為基礎，進行了微機控制的硬體與軟體開發，提出了採用8098單片機進行模糊智能控制的設計方案，實現了燃料油與燃燒空氣最佳比例控制、燃燒爐出口煙氣溫度控制、燃燒爐進口煙氣溫度控制和安全聯鎖報警控制，提高了燃燒爐出口溫度的控制精度和燃料使用效率，為整個裝置提高產量和降低消耗提供可靠的保證。
  4. It ' s the first time to explore the combustion characteristics of lpg / diesel mixing fuel engine, and find that, with the change of load and rotation, the changing trend of the ignition delay period of e10 mixing fuel is almost as identical as that of the diesel, but that of e30 mixing fuel is very different. comparing with diesel, the combustion of e10 is improved slightly, but that of e30 greatly changes ; the maximum eruptive pressure decreases ; the maximum pressure increase rate decreases ; the highest releasing heat rate increases ; the highest combustion temperature falls ; the ignition delay period extends

    結果表明: e10混合燃料與柴油的著火滯燃期隨負荷和轉速的變化趨勢基本一致; e30混合燃料與柴油則有所不同; eio混合燃料發動機的燃燒與純柴油相比，略有改善; e30混合燃料的燃燒特性發生明顯的變化，最高爆發壓力下降，最大壓力升高率減小，最大燃燒放熱率增大，最高燃燒溫度下降，滯燃期延長。
  5. A new calculation method for optimizing diesel engine performance, called nonlinear regression - mess method, is put forward. in this paper, 25 groups of simulated values are calculated from the diesel engine working model, specific fuel consumption, peak pressure, rate of pressure rise, nox and peak temperature are fitted into explicit function about compression ratio and fuel injection advance angle

    本文利用柴油機工作過程模型，得出25組模擬計算數據，利用非線性回歸將油耗、最大爆發壓力、壓力升高率、 no _ x濃度及最高燃燒溫度擬合成壓縮比和噴油提前角的顯函數，並用網格法進行優化，用c語言編制了優化計算程序，得出最佳的壓縮比和噴油提前角，使其優化匹配。
  6. In the mean time, i test the separator ’ s performance, including the rate of hole 、 the performance of absorbing electrolyte and the conductance eletrochemical steady range 、 machine intensity test, and then make bettery to test its cycle performance. the test result show that, the spreading separator get better performance, when dbp ’ s percentum reach 50 %, and dry temperature reach 90, after ultraviolet radiation disposal. the test show that, the separator has high conductance reach 6. 1 10 - 3s / cm ( 25 ), and the machine intensity can reach 3. 92 mpa, this separator can meet the need of making bettery, the bettery capability will go down after 30 cycle. and the bettery show worse performance under high temperature, under 70, the bettery will get fire. making the intensified seprator, i find that when dbp % : pvdf % = 40 % : 60 %, dbp % + pvdf % : sio2 % = 70 % : 30 %, the separator get

    但用其制備的電池循環30周期后容量發生衰減，並且電池高溫性能差， 70下電池燃燒;強化聚合物膜的最佳制備配比條件為: dbp : pvdf為40mass % : 60mass % ， dbp含量與pvdf含量之和與納米sio2含量比值為70mass % : 30mass % ;強化電解質隔膜的室溫離子電導率也可達4 10 - 3s / cm左右，完全能滿足聚合物鋰離子電池的使用需要;機械強度遠遠大於流延法制得的隔膜，達到108 . 84mpa 。
  7. Giving some suggestions to develop the fuel according to the experiment result. the final experiment result is very good. after using alcohol - blended diesel oil in diesel engine, the power can be achieved, the let of contamination is reduced, thermal efficiency enhanced, the exhaust degree and the max combustion pressure is steady

    對理論和實驗結論進行總結，對課題的發展提出建議實驗的最終數據證明：在柴油機上燃用乙醇柴油后，能夠達到原機的功率，並且柴油機的排放狀況有很大的改善，熱效率有一定的提高，排氣溫度和最高燃燒壓力基本不變，實驗結果是比較理想的，可以考慮在實際中應用和推廣乙醇柴油。
  8. Peak flame temperature

    最高燃燒溫度
  9. Wall temperature had a remarkable effect on smog exit temperature, whereas its effect on other parameters was not obvious

    壁面溫度對最高燃燒溫度、壁面最大熱流和平均熱流影響不明顯，但煙氣出口溫度隨壁面溫度的升高而增加較大。
  10. Under the condition of constant phosphorus mass flow rate, the smog exit temperature would increase slowly while other parameters would decrease with increasing excess air coefficient

    在燃磷量不變情況下，最高燃燒溫度、壁面最大熱流和平均熱流均隨過剩空氣系數的增大而減小，但煙氣出口溫度緩慢增加。
  11. In addition, radiation absorption coefficient had a remarkable effect on maximum combustion temperature and maximum wall heat flux in the new phosphoric acid tower

    輻射吸收系數對最高燃燒溫度和壁面最大熱流影響很大，隨輻射吸收系數的增大，最高燃燒溫度和煙氣出口溫度會下降，而壁面最大熱流和平均熱流會上升。
  12. The predicted results showed that maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux would increase with increasing phosphorus mass flow rate when excess - air coefficient or air flow rate was constant

    模擬結果表明，無論過剩空氣系數固定還是空氣流量固定，隨燃磷量的增大，最高燃燒溫度、煙氣出口溫度、壁面平均熱流和最大熱流都呈上升趨勢。
  13. The effects of parameters on maximum combustion temperature, smog exit temperature, maximum wall heat flux, averaged wall heat flux of a new phosphoric acid tower with circular water wall were discussed, including phosphorus consumption, excess - air coefficient, wall temperature and radiation absorption coefficient, with the mathematical model developed in part

    摘要利用已建立的數學模型考察了燃磷量、過剩空氣系數、壁面溫度、輻射吸收系數對新型燃磷塔的最高燃燒溫度、煙氣排放溫度、壁面最大熱流和平均熱流的影響。
  14. It also researches the mixed combustion process of hot coal gas and preheats combustion - supporting air by utilizing the left heat of fume from industrial furnace so as to improve the theoretical combustion temperature of hot coal gas

    通過利用工業爐的煙氣余熱預熱助燃空氣，提高熱煤氣理論燃燒溫度的辦法，是諸多方法中最經濟有效的方法。
  15. Firefighters, who had already labored for days in triple - digit temperatures, faced their gravest challenge saturday in the foothills of the san bernardino mountains just east of the 215 freeway

    到星期六，火警們已經在近百度高溫中工作了數日，他們目前面臨著最致命的挑戰，因為大火燃燒的聖貝納迪諾山腳一帶就在215高速公路東面。
分享友人
分享到 Line

分享到臉書