最高空轉轉速 的英文怎麼說

中文拼音 [zuìgāokōngzhuǎnzhuǎnsù]
最高空轉轉速 英文
maximum no load governed speed
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 轉 : 轉構詞成分。
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 高空 : high altitude; upper air; welkin高空病 airsickness; altitude sickness; aeroembolism; hypobaropath...
  • 轉轉 : pop 1
  1. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  2. Maximum no load governed speed

    最高空轉轉速
  3. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  4. The air - fuel ratio closed loop control adjusts the air - fuel ratio near the theoretical value by controlling the supplementary air of supplementary valve based on the signals of oxygen sensor, running speed and water temperature and which is necessary condition for three - way catalyst converter to work more efficiently

    空燃比閉環控制是根據氧傳感器、轉速和水溫信號，控制化油器后補氣閥補氣將空燃比控制在理論值附近，為三元催化轉換器高效工作準備必要條件，使其最大限度降低尾氣排放。
  5. As a hardware. the gimble servosystem design is very important in the making of the optoelectronic tracking system. the precision of the position. speed and the speed stability are the key indexes. for the optic measurement system in the high space. the minimum stable speed and high precision are needed

    轉臺伺服系統的位置精度，速度精度和速度平穩性是光電跟蹤系統設計的重要指標，而對深空光測系統，則要求其具有穩定的最低速度以及低速時高的工作精度。
  6. The formation process of w - type ferrite underwent from oxide of metal, the m - type transition phase to final w - phase. when the heating rate was 5 / min, at 900 for 3 hrs and 1200 for 4 hrs, pure m - type and w - type ferrites were formed in air respectively. with heat treatment temperature increasing, crystal structure was more intact, the saturation magnetization increased and the coercive force decreased

    熱處理過程表明， m型鐵氧體直接由金屬氧化物反應形成，未經歷尖晶石中間相； w型鐵氧體形成由金屬氧化物到m相過渡相最終向w相的轉變；當升溫速率為5 min ，溫度在900 ，保溫3小時和1200保溫4小時，就分別形成單相m相和w相鐵氧體；隨著熱處理溫度的升高和保溫時間的延長，衍射峰變尖銳，結晶更完整，空心微球的飽和磁化強度增大，矯頑力減小。
  7. Opto - electronic sensor and a / d converter are adopted, and so, the high accuracy time and space information can be obtained in the simplest and most understandable way

    該方案採用光電傳感、模數轉換的方法，通過信號處理把被攝對象的高速時空信息以最簡單最直觀的方式展現出來。
  8. During this paper, definition of the measure enter - cover - probability is given, andthree - dimension detection space are transformed to level detection circles on differentheights. aiming at the most normal situation of symmetric line, cross - to line and cross - awayline taken by the carrier, probablely - enter - cover - target - distribution are analysed in relativemovement method on the premise that targets fly perpendicular to the flying direction of thecarrier. mont - cario method is used to simulate uniformly - distributed - targets situation and getthe measure, and results are used to analyse the influence of line - landscape - orientation - ratio, line - portrait - ratio, and speed - ratio on the measure. for further research, influences of height and blind space are also discussed on base ofradar level detection range, and situations of non - uniformly - distributed targets are alsoresearched

    為了分析主動探測空間動態性能，本文首先提出以「目標進入雷達覆蓋區概率」 （簡稱為「覆蓋率」 ）作為評價指標;然後將三維探測空間轉換為不同高度層對應的水平探測圓，針對載機採用雙平行航線、交叉相向航線和交叉同向航線的最一般情形，採用相對運動的方法，分析目標垂直入侵時可能進入雷達覆蓋區的目標分佈情況;再運用蒙特卡洛法進行模擬計算，分析並比較目標服從均勻分佈時航線橫比、航線縱比及速度比對性能的影響。
  9. The common map is scanned into grid map, and then vectored in mapinfo. after vectoring, vector data are matched and the spatial coordinate data of resident points, water system and other data are gained. the coordinate of reference points in the freeway are gathered by gps, then after data processing, coordinate transition, data inputting, it turn into the freeway graph, which composes the freeway electronic map with the materials subsidiary to the freeway

    將普通紙質地圖經過掃描生成柵格地圖，然後在mapinfo環境下進行矢量化生成矢量化地圖，經過矢量化數據配準，確定居民點、水系等物系的空間坐標數據；利用gps採集的高速公路控制點坐標，經過數據處理、坐標轉換、錄入，最後生成高速公路圖層，和上述高速公路附屬物共同構成了完整的高速公路電子地圖。
  10. The foundation of back is10 steel or spcc, the surface is agglomerated by different trademarks copper and lead powder, resistant against : tiredness, abrasion, heat, has good carrying capability, especially, be the same with the connecting rod clevel, rocker, gear case, cranking motor, trig chasis, and motor gear case, redirector, hydraulic pressure oil pump, engineer

    產品具有疲勞強度高，耐磨不發熱，承載能力大等特點，特別適用於汽車發動機的連桿搖臂，輪箱，起動馬達，制動底盤及摩托車輪箱，轉向器，液壓油泵，工程機械，空調壓速機等場合，目前我廠是國內最大的發動機連桿襯套生產企業之一。
  11. The direct torque control theory is a kind of new control method after vector control theory in ac control field. it calculates and controls the torque and the flux of ac electromotor in stator coordinate using the voltage space vector. adopting the stator magnetism field direction method, it recurs to discrete pang - pang control producing pulse width modulation signal and controls the switch state of the transductor when better quality steady - state performance is produced

    直接轉矩控制技術是繼矢量控制技術之後交流調速領域中新興的控制技術，它採用空間矢量分析的方法，直接在定子坐標系下計算並控制交流電動機的轉矩和磁鏈，採用定子磁場定向，藉助于離散的兩點式控制產生脈寬信號，直接對逆變器的開關狀態進行最佳控制，以獲得轉矩的高動態性能。
分享友人
分享到 Line

分享到臉書