有效孔徑 的英文怎麼說

中文拼音 [yǒuxiàokǒngjìng]
有效孔徑 英文
actual aperture
  • : 有副詞[書面語] (表示整數之外再加零數): 30 有 5 thirty-five; 10 有 5年 fifteen years
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • : Ⅰ名詞1 (狹窄的道路; 小路) footpath; path; track 2 (達到目的的方法) way; means 3 (直徑的簡稱...
  • 有效 : effective; valid; efficacious
  1. Through the special studies on impacts to atomizing and humidifying effect from such factors as the firing pin type, centrifugal structure, higher spraying pressure, less aperture, initial water temperature and original state of the air, some conclusions are obtained, such as : the centrifugal nozzle with firing pin type, high pressure and little aperture has bigger air eddy and atomizing angle. the spaying liquid has high velocity. the droplet is small, and the heat and mass transfer velocity is high

    通過對撞針型結構、離心式結構、較高的噴水壓力、較小的噴嘴、噴水初溫及待加濕空氣初狀態對霧化加濕果的作用原理的重點分析,得到:撞針型高壓小離心式噴嘴具較大的空氣渦與霧化角,噴出的液體流速高、液滴小、水與空氣傳熱傳質速率高,撞針型結構提高了霧化加濕率,高壓小的特點為霧化加濕提供了較大的能量,而噴水初溫的升高會減小水的粘性力和表面張力,從而優化加濕果。
  2. Integrated the work on theory and experiment, the paper provides technical performance material at large about the automating and humidifying character of the centrifugal nozzle with firing pin type, high pressure and little aperture to the manufacture and user. with the valuable reference during the selecting the equipment and ascertaining the parameters, the users could select and control the humid parameter

    課題的理論與試驗兩方面工作相結合,為撞針型高壓小離心式噴嘴的霧化加濕性能提供了較為詳細的技術性能資料,為生產廠家和用戶在設備選型和參數選擇過程中,提供了價值的參考,便於用戶正確而經濟地選擇、控制濕度參數,調節噴嘴、噴水初溫和噴水壓力的大小。
  3. Based on the equal strain consolidation model of sand drain, and neglecting the well resistance and the vertical drainage consolidation, a layered model for the nonlinear consolidation of sand drain, which accounts for the geostatic pressure varying along depth and the relationship between the average viod ratio and the logarithm of average effective stress, is presented

    摘要基於砂井等應變固結模型,考慮初始應力沿深度變化,忽略井阻和豎向排水固結的影響,應用平均隙比與平均應力的對數關系,建立砂井非線性向排水固結的分層計算模型,並求得常荷載作用下的向排水固結解析解。
  4. The feasibility and some advantages of employment of sil have been discussed. the numerical aperture are calculated when laser pulse is defocusing. in contrast with traditional microscopy objective, the employment of solid immersion lens can effectively increase the numerical aperture of the recording system ; thereby it can increase the volumetric density and decrease the demand of the incident laser power

    當脈沖聚焦點相對于固體浸沒透鏡底面離焦時,對系統的數值進行了計算,結果表明採用固體浸沒透鏡離焦的方式進行記錄,系統的數值最低可增大到固體浸沒透鏡插入前的折射率倍,其數值的理論極限值為存儲介質的折射率。
  5. Abstract : double steel - ball extrusion deep hole solves the matching problem of steel - ball nucellus with workpiece axis, using this technology, extruding deep hole with smaudiameter is attained efficiently with high quality. it has been proved that the special problem of finishing curved hole is able to be solved

    文摘:雙珠式擠壓深地解決了鋼珠珠心與工件軸心重合的問題,高質高地實現了較小直的擠壓加工,實踐證明,且能實現彎的高精加工。
  6. Based on the test of drainage salinity effect in different clay interlayer and the analsis of thickness of drainage salinity layer, the design parameter of effective drainage salinity semidiameter, amount of sand - hole and semidiameter of hole were put forword

    通過對不同層位的粘土夾層土壤的洗鹽果試驗研究,分析了脫鹽層厚度、計劃脫鹽層脫鹽率,提出了洗鹽半的概念、砂數量及等設計參數,並制定相應的洗鹽制度。
  7. Designning well tube and drill - hole diameter in order to increase thickness of both annular packing gravel and water - resisting clay, nylon net packing around well tube filters, designing filter layer on the boundary between packing gravel and water - resisting clay and ramming the gravel by working the piston into the well after gravel packing completion and the filling clay for salt - water resisting etc. we succeeded in constructing 3 drinking - water wells in minqin county, proved the affectivity and feasibility of using it and giving a certain technical demonstration of construction of drinking - water well in the same similar to this area

    通過與管的調配設計,增大環狀粒料層和止水粘土層的厚度;濾水管外包尼龍紗網;粒料與止水粘土接觸界面上設計反濾層;填粒后先行拉活塞利用水力夯實粒料層,再投粘土球止掉上部鹹水等措施,在民勤縣三口人飲水井施工中取得顯著果,證明了該套成井工藝的性和可行性,望為同類地區人飲水井施工提供技術示範作用。
  8. The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites

    研究結果表明:採用高純度的fe2o3利於獲得高起始磁導率且頻率特性優良的鐵氧體;為了制備所需性能的鐵氧體,需要嚴格控制配方中各種原材料的含量,優化配方;由於粉體活性受預燒條件的影響,所以對不同要求的鐵氧體選擇的預燒條件就不一樣,適當降低預燒溫度利於獲得較高的起始磁導率,而為了獲得良好的頻率特性可以適當地提高預燒溫度;根據對粉體顆粒粒的不同需求,可以選擇不同的球磨時間;而的添加劑是改善材料性能的必要條件,本文在添加劑的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是高磁導率mnzn鐵氧體制備最關鍵的工藝,適宜的燒結工藝可以獲得理想微結構和組成,從而得到高性能的鐵氧體材料;而從材料的微結構上來看,要提高材料的截止頻率,就要適當地細化晶粒、增加晶粒內部的氣
  9. When the water - air ratio increases, air ' s changing quantity of enthalpy and absolute humid will be enhanced. at last, the paper analyses the data from single factor experiment by mathematics method and gets relationship formulas about the nozzle flux, valid humidifying quantity and air ' s enthalpy changing quantity

    最後,對上述單因素試驗得到的數據進行數學分析,運用線性回歸分析、多項式回歸分析和非線性回歸分析的數學方法,得到影響撞針型高壓小離心式噴嘴的噴嘴流量、加濕量和空氣焙變量的數學關系式。
  10. ( 4 ) through the hydraulic property experiment of micro - hole lateral pipes of simple sdi in air, it was found that the average pressure of 60 mitre length lateral pipes was at the position of per 40o / o ~ ~ ~ 50 % of the effectual pipe length from the fist micro - hole, major pressure - loss was occurred at the ahead part of half pipe. the pressure uniformity reduced with orifice aperture ? increasing, and the relationship between pressure uniformity and initial water pressure was poor. running under the initial water pressure of 1. 5 meter, the discharge uniformity reduced with orifice aperture ? increasing, and when the orifice aperture smaller than or equal 1. 0mm, irrigation uniformity could achieve above 0. 6

    ( 3 )通過對空氣介質中簡易地下滴灌的微毛管試驗研究發現: 60m管長的毛管平均壓力水頭的位置基本上在距第一口的管長40 - 45的地方;大部分水頭損失發生在毛管的前半部分;壓力均勻度隨的增大而減小,但與初始工作水頭關系不密切;在1 . 5m以下的工作壓力下運行,沿程出流均勻度隨的增大而降低,當不大於1 . 0mm時,灌水均勻度可以達到60以上;當大於等於1 . 2mm時,灌水均勻度低於50 。
  11. A simple and effective method is given to successfully simulate circular and different serrate type aperture ' s far - field diffraction and compared with the diffraction of hard - edged circular apertures

    摘要採用一種簡單的方法,模擬了光束經圓形和不同齒形光闌的遠場衍射分佈,並與經圓硬邊光闌的衍射作了比較。
  12. Photographic lenses - methods for the measurement of the effective aperture, f - number and relative aperture

    攝影鏡頭.有效孔徑光圈數和相對的測量方法
  13. Geotextiles and geotextile - related products - determination of the characteristic opening size - wet sieving method

    土工布及其關產品有效孔徑的測定濕篩法
  14. Suggest the method of division to measure the largest compacted dry density of dam ' s material with super large diameter approximately. according to the research of predecessor, suggest applying the effective void ratio or the effective void rate to compute the coefficient of permeability approximately

    採用了表面振動法進行室內最大幹密度的研究,提出了比例法近似測定超粗粒土最大幹密度;在前人研究的基礎上,提出採用隙率或隙比的滲透系數近似估算。
  15. Based on the experiment concerned, it is found that the effective way to solve the problem is to decrease the amplitude of vibration and lower the effect from the vibrator on the surrounding sand layer under the condition that a certain exciting force can be guaranteed ; in which larger amount of water and higher water pressure are needed to saturate the sand layer, and then to make hole under the strengthened vibrating effect from the vibrator as well

    通過試驗,尋求到解決振沖施工造難的是,在保證一定激振力的情況下,適當減少振幅,以降低振沖器對周圍砂層的影響;採用較大水量和水壓,使砂層飽和,並在加重振沖器的振動作用條件下造
  16. Effective aperture of obejctive

    物鏡有效孔徑
  17. Then the kozeny - carmon equation was developed. the new developed fractal model adjusts the measure of the effective pore radius and of the grain radius to the resolution length appropriate for the hydraulic process. the fractal model was applied in the daqing oil field

    在此基礎上,利用分形基本理論把kozeny - carman方程改進發展,把顆粒半隙半調整到適于動力傳導過程的解析度尺度,從而建立滲透率的分形模型。
  18. Effective diameter of voids

    隙粒
  19. Testing of fibre optic elements ; determination of acceptance angle of light guides

    光纖元件的檢驗.第3部分:光導體有效孔徑角的測定
  20. The main performances of band drain include flow capacity, tensile strength, longitudinal and transverse tensile strength of filter fabric, longitudinal and transverse tear strength, water permeability and effective opening size etc

    反映排水板性能的主要指標包括:通水量,抗拉強度,濾膜縱橫向抗拉強度,縱橫向抗撕裂強度,滲透性和有效孔徑等。
分享友人